Q: 1995 GMC Yukon won't start
My car won't start.
Recommended Services
| Car is not starting Inspection | $94.99 - $114.99 | Get a Quote |
The GMC Yukon 1995 came with 2 different motors and the 5.7 was the most common. The most common problems with this vehicle from most to least common are: the fuel pump and filter, starter motor, ignition module, crankshaft position sensor, battery, ignition coil, and ignition switch. These are just a few of the possible causes of your no start. I recommend you have a mechanic like one from YourMechanic check your vehicle to determine what is causing the no-start condition.
The statements expressed above are only for informational purposes and should be independently verified. Please see our
terms of service
for more details
Get an instant quote for your car
Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing
What others are asking
How do I adjust the equalizer?
You can adjust the equalizer in your infotainment system with just a few steps: 1. Press the TONE button. 2. Use the MENU/SEL knob to select EQ. 3. Select the equalizer setting of your choice.
Car makes whining noise when accelerating
It sounds like the power steering has a low fluid level condition. Check the power steering fluid. If it is low, you have a leak. If the pump doesn't have enough fluid it will make a strong whining noise that...
Van shut off while driving, now it won't start
The vehicle may have had a problem with a computer sensor like the crankshaft sensor (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-crankshaft-position-sensor) or camshaft sensor (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-camshaft-position-sensor) but normally they would have put a code into the computer. This is not a common problem and would need...
How do i get the ignition cylinder back in the steering column?
When you went to put in the lock all you had to do was turn the lock cylinder to the key on position, then the pin would push in and slide it into the column. Once that is done, you...
after 20 mins of driving my car acts likes its suffercating until it cools down
A faulty air/fuel oxygen sensor (https://www.yourmechanic.com/services/oxygen-sensor-replacement) may cause the engine to run rough as it send improper information to the vehicles computer. I'm curious if the Check Engine Light is on. If there is a faulty sensor the vehicle can...
hi how long should my brake calipers last?? based on other mercs etc
Brake calipers, associated torque plates and sliding pins should all be thoroughly cleaned and rebuilt every time you have to change the brake pads (https://www.yourmechanic.com/services/brake-pads-replacement). These parts are subject to corrosion, brake grit, dust and dirt, and extremely high heat....
Engine knocking at higher speeds
Hello. A knocking sound during heavy acceleration could potentially be a sign of a serious issue, depending on where it is coming from. A knock from the engine can occur if it runs low on oil, and could quickly lead...
Remote car starter and automatic door locking mechanism won't work after crash.
Hi there. With having the battery cable loose, that caused the computer to reset and lose its memory. I recommend reprogramming the key fob to the vehicle to allow the door locks and ignition to work. First put the key...
While driving, all lights in the car turned off, blinkers included. Then the gas went. Had to pull over. Car would not start again
It sounds like you may have a weak battery, a failing voltage regulator or failing alternator. As you may know, the alternator charges the battery while the engine runs by generating amperage and recharging the battery while the engine turns...
Related articles
How Often Should Spark Plugs Be Replaced?
While your engine runs on gasoline, it also requires electricity. It’s needed to operate most of your accessories, but is also required to...
A Buyer's Guide to the 2012 GMC Yukon Hybrid
The The GMC Yukon is about as big and powerful as any SUV can ever get. However, in the past, that also meant paying a large sum every time you hit the pump. GMC has addressed this problem with their...
How to Replace an Ignition Lock Cylinder
The ignition lock cylinder is usually at fault if there is an issue with the ignition system. A common sign of failure is a car that won't start.
Browse other content
Cities
Services
Maintenance