Porsche Boxster Car starts and then dies Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(112)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(112)

Car starts and then dies Inspection Service

How much does a Car starts and then dies Inspection cost?

On average, the cost for a Porsche Boxster Car starts and then dies Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2008 Porsche BoxsterH6-2.7LService typeCar starts and then dies InspectionEstimate$114.99Shop/Dealer Price$139.99 - $158.75
2009 Porsche BoxsterH6-2.9LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$120.04 - $138.82
2001 Porsche BoxsterH6-3.2LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$120.03 - $138.82
2015 Porsche BoxsterH6-3.4LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$119.98 - $138.72
2016 Porsche BoxsterH6-3.4LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$120.07 - $138.89
2016 Porsche BoxsterH6-3.8LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$120.03 - $138.82
2012 Porsche BoxsterH6-3.4LService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$124.69 - $143.22
2007 Porsche BoxsterH6-2.7LService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$125.63 - $144.85
Show example Porsche Boxster Car starts and then dies Inspection prices

Starting a vehicle only to have it quit immediately after can be confusing and annoying for many drivers especially if their vehicle has not experienced this type of issue before. Typically, a vehicle will start and then quit because of an issue with the fuel or electrical system. It is important to monitor fuel levels as well as warning lights which can signal to the driver that a vehicle may quit unexpectedly.

How this system works:

To start a vehicle, the electrical system, composed of the battery and starter, turns the engine over. Once running, the engine requires a constant flow of gasoline and good spark to keep that fuel igniting. If gasoline is not readily available, or if there is not enough spark, the engine will quit. More modern vehicles with sophisticated computers may affect the way the vehicle runs. These computers help the car run efficiently but can also shut a car down if the fuel/air mixture is not correct. While an older vehicle may be less sophisticated and easier to diagnose, the computers on modern cars can provide more specific information when connected to a code scanner/reader.

Common reasons for this to happen:

  • Mass Airflow Sensor: The mass airflow sensor measures how much air is entering the engine and relays this information to the vehicle’s computer so that the right amount of fuel can be delivered from the fuel injectors. When a sensor begins to fail, the vehicle’s computer may generate an error code to indicate that something has gone wrong. An issue with the mass airflow sensor may manifest itself when a car starts and then stalls soon after starting.

  • Fuel Pump Relay: The fuel pump relay functions much like a fuse for an electric fuel pump. The fuel pump relay engages as the vehicle is started and starts the fuel pump. While the vehicle is running, the fuel pump relay turns off and the fuel pump is powered by the oil pressure sending unit. If the vehicle’s computer is unable to keep the fuel pump relay running throughout the starting process, the vehicle may start and quit immediately after starting.

  • Ignition Coil: Your vehicle’s ignition coil takes the low voltage of the battery and provides the thousands of volts needed to create a spark in the spark plugs. When an ignition coil begins to fail, it may struggle to provide consistent spark to the plugs, causing the engine to stall after starting.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the reason why the vehicle starts and then dies. The mechanic will then provide a detailed inspection report outlining why the vehicle quit and the cost of any repairs that need to be made.

How it's done:

A mechanic will begin diagnosing your vehicle’s issue by plugging a code reader/scanner into the vehicle’s computer. The mechanic should be able to get more information from your vehicle’s computer on what component has failed. Using this information, the mechanic can begin necessary repairs.

If your vehicle has a bad or failing mass airflow sensor, the mechanic will begin by finding the sensor in the engine bay and checking for any signs of failure. The mechanic should check the wire harness connected to the sensor to ensure that all of wires are properly connected. After removing the sensor, the mechanic should be able to discover the nature of the failure and replace the sensor.

If the mechanic suspects an issue with the fuel pump relay, he or she should check the vehicle’s computer for a problem. If the vehicle’s computer is having difficulty providing consistent power to the fuel pump relay, the computer may need to be reprogrammed or replaced. If the vehicle’s computer is functioning normally, the mechanic may need to replace the fuel pump relay.

If the mechanic suspects that the ignition coil may be faulty, he or she should first disconnect the battery before beginning work. The mechanic should then begin the process of disconnecting wires from the ignition coil and removing it from the engine bay. The mechanic will then install the new ignition coil and ensure that it is connected properly. The mechanic should then reconnect the battery and test the new coil.

With all repairs, the mechanic will ensure the newly installed parts work properly. The mechanic can then turn off and warning lights that may have come on while the vehicle was not running properly.

How important is this service?

If your vehicle is starting but dying soon after starting, you should have it checked out by a mechanic. Issues involving the fuel management and electrical systems will become worse if not dealt with. Diligence and paying attention to warning lights may help prevent further damage to critical engine component and may save money in repairs. A vehicle that quits after starting can be inconvenient and having a mobile mechanic inspect and repair you vehicle will ensure that you and your vehicle are back on the road soon.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Porsche mechanics

Real customer reviews from Porsche owners like you.

Excellent Rating

(112)

Rating Summary
101
7
0
1
3
101
7
0
1
3

Willie

24 years of experience
116 reviews
Willie
24 years of experience
Porsche Boxster H6-2.7L - Headlight Bulb Replacement (Driver Side Low Beam) - Garden Grove, California
Very timely, friendly and competent.

Junard

11 years of experience
161 reviews
Junard
11 years of experience
Porsche Boxster H6-2.5L - Oil Change - Merchantville, New Jersey
Great guy, did amazing job on my car..highly recommend, quick and professional

Mario

20 years of experience
110 reviews
Mario
20 years of experience
Porsche Boxster H6-2.5L - Serpentine/Drive Belt - Fort Myers, Florida
Great mechanical knowledge and makes sure the job is done correctly.. will request Mario every time.

John

36 years of experience
438 reviews
John
36 years of experience
Porsche Boxster H6-2.7L - Window Regulator Replacement (Driver Side Front) - Burlingame, California
John was early and very prompt and courteous. Took real good care of the car and explained everything very well. Excellent job done!

Excellent Rating

(112)

Rating Summary
101
7
0
1
3
101
7
0
1
3
Number of Porsche Boxster services completed
1232+
services done by our mechanics
TOTAL NUMBER OF EXPERT Porsche MECHANICS
300+
experts on our platform

Recent articles & questions

Symptoms of a Bad or Failing Exhaust System Hanger
Common signs include the exhaust hanging visibly low, sounding excessively loud, and causing the engine to perform worse than usual.
How to Check Suspension Ball Joints
Ball joints are a suspension component that is found on virtually all vehicles. Ball joints are flexible joints...
Child Seat Safety Laws in Colorado
In In Colorado, as in other states, seat belt laws are in place to protect the occupants of motor vehicles. When those occupants are too young to protect themselves, then the duty falls to adults. Colorado is a bit different...

Car don't seem to downshift

Hi There, What you are describing sounds like possibly low transmission fluid (https://www.yourmechanic.com/services/transmission-fluid-service) or a bad speed sensor or potentially a faulty transmission control module, which also controls the speed sensors. The transmission control module has various sensors such as...

What years ignition module will fit my 1991 Chevrolet Silverado 5.7

Hi - GM V8 ignition control modules from 1987 to 1995 should interchange with your '91 5.7L. For assistance, I recommend a ignition control module replacement (https://www.yourmechanic.com/services/ignition-ignitor-replacement) performed by a mobile, professional mechanic, such as one from YourMechanic, who will...

Second opinion] [Brake](/topics-brake-ford/) pads was hitting the rotors last week. I replaced the rail clips and thought the problem was fixed, but It's touching the rotors again slowing the vehicle down. Any ideas?

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com