Mercedes-Benz ML430 Car idle is rough Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(31)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(31)

Car idle is rough Inspection Service

How much does a Car idle is rough Inspection cost?

On average, the cost for a Mercedes-Benz ML430 Car idle is rough Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2001 Mercedes-Benz ML430V8-4.3LService typeCar idle is rough InspectionEstimate$114.99Shop/Dealer Price$132.49 - $145.62
2000 Mercedes-Benz ML430V8-4.3LService typeCar idle is rough InspectionEstimate$94.99Shop/Dealer Price$112.52 - $125.67
1999 Mercedes-Benz ML430V8-4.3LService typeCar idle is rough InspectionEstimate$94.99Shop/Dealer Price$112.52 - $125.67
Show example Mercedes-Benz ML430 Car idle is rough Inspection prices

A rough idling engine can be caused by a number of issues, some of them are serious while others tend to be minor, but the symptoms remain pretty much the same. The car will feel rough and bouncy when the engine is running. The car will also idle below its regular speed, display inconsistent RPMs and may produce a shaking, skipping or slipping sound when the vehicle is running.

While a rough idling engine may seem to be a simple inconvenience it often indicates a deeper problem within the engine. The vehicle should be inspected and repaired as soon as possible because small problems have a way of turning into expensive repairs.

How this system works:

The idle speed of an engine is basically the rotational speed the engine runs on when it is un-coupled from the drivetrain and the throttle pedal is not being depressed. The idle speed is measured in the revolutions per minute of the crankshaft.

When an engine is running at idle speed it generates enough power to smoothly operate equipment such as the water pump, alternator, and power steering but not enough power to move the vehicle itself. A passenger car will usually idle between 600 RPMs and 1000 RPMs. A properly functioning idle should run smoothly without skipping or slipping.

Common reasons for this to happen:

  • Dirty Fuel Injectors: The fuel injection system injects fuel into the cylinders, which creates a mix of air, and fuel to ignite and burn. Fuel injectors have tiny nozzles to spray the fuel into the cylinder and they can become clogged over time.

A clogged or failing fuel injector creates a lack of fuel in the vehicle's engine. This can cause a rough idle, it can also cause symptoms such as slow acceleration or the car not feeling as if it has enough power. If the problem is addressed early, it is possible to clean the injectors, which will restore them to full function. If this condition is not addressed in a timely manner the injectors will need to be replaced.

  • Incorrect Idle Speed: While the average idle speed falls between 600 to 1,000 RPMs, if your vehicle is experiencing a rough idle it could be due to an incorrect idle speed setting. A trained mechanic can easily adjust the idle speed, and it should stay at the proper speed. If an adjusted idle speed becomes inconsistent or changes at random intervals there may be a bigger problem that needs to be explored.

  • Vacuum Leak: If the vacuum system has a leak, it can seriously affect the ability of the vehicle’s computer to regulate the air to fuel ratio. This can lead to a rough idle and if the problem is not addressed the car may experience slow acceleration and a lack of power. Vacuum leaks should be inspected and repaired immediately.

  • Incorrectly Installed or Damaged Plugs: Spark plugs are responsible for creating the spark that allows the vehicle to burn fuel. If spark plugs are improperly installed or malfunctioning, the idle speed can be affected. The vehicle's engine may vibrate or there may be slipping or straining sounds coming from the engine.

  • Defective or Clogged Fuel Pump: A rough idle can be related to fuel delivery issues. The fuel pump, which is responsible for pulling fuel from the gas tank to the fuel injectors, can become clogged or defective. If this happens the engine will not get enough fuel, which can cause a rough idle, sputtering, stalling and even slow acceleration.

  • Clogged Fuel Filter: A clogged fuel filter can cause similar problems. The job of the fuel filter is to screen out contaminants in the fuel, over time it will become clogged and need to be replaced. A rough idle is one symptom of a clogged fuel filter.

  • Failing Electrical Components: A problem or failure in the ignition system or various electronic components can cause a rough idle. If this is the case, the problem will usually get worse as RPMs increase. Common culprits include the ignition control module, plug wires, coils, and spark plugs.

  • Defective Airflow Sensor: A defective airflow sensor can be responsible for a rough idle. A mass airflow sensor detects the amount of air coming into the fuel injection system and sends that information to the vehicle's computer. The computer uses that data to deliver the proper amount of fuel to the air in the vehicle. Over time these sensors can malfunction or become dirty. One of the first symptoms of a malfunctioning airflow sensor is a rough idle. The car may also accelerate slowly and even stutter or stall as the problem progresses.

  • Dirty Oxygen Sensor: Oxygen sensors measure how rich or lean the gases are as they exit the combustion chamber. Depending on the results, the amount of fuel entering the engine is adjusted by the vehicle computer. The ultimate goal is to maintain an ideal mixture that produces the lowest emissions. A dirty or failing oxygen sensor will usually trigger the check engine light and can lead to a rough idle, lower fuel efficiency and failed emission test.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the source and cause of the rough idle issue, ​and will then provide a detailed inspection report that includes the scope and cost of the necessary repairs.

How it's done:

The mechanic will check your car for leaks and defective parts. This includes airflow sensors, fuel pump, electronics and other important components related to your car's idling state. It may be necessary to crank the car and test drive it in order to verify the problem and provide an accurate diagnosis.

How important is this service?

A rough idling car is more of an inconvenience at first but if the problem is not solved it can quickly lead to bigger problems such as slow acceleration, stalling and eventually a vehicle that will not start at all. Most of these conditions can make the vehicle dangerous to drive. A rough idle should be inspected and repaired as quickly as possible.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Mercedes-Benz mechanics

Real customer reviews from Mercedes-Benz owners like you.

Excellent Rating

(31)

Rating Summary
31
0
0
0
0
31
0
0
0
0

Robert

20 years of experience
1092 reviews
Robert
20 years of experience
Mercedes-Benz ML430 V8-4.3L - Wipers are not working - Denver, Colorado
Very good, He came on time work on the car right away very nice know about the car and fix it.

John

20 years of experience
568 reviews
John
20 years of experience
Mercedes-Benz ML430 V8-4.3L - Car is not starting - Orlando, Florida
He always takes his time to make sure that hge explains everything in order.

Ian

15 years of experience
133 reviews
Ian
15 years of experience
Mercedes-Benz ML430 V8-4.3L - Serpentine/Drive Belt - Seattle, Washington
Ian was great. He arrived on-time...actually, he called and said he could be there early if I was available, which was very nice. He not only fixed the broken belt, but took the effort to diagnose the cause of the problem. He was courteous and knowledgeable and I will request him the next time I need any work done on my car.

Jerome

24 years of experience
415 reviews
Jerome
24 years of experience
Mercedes-Benz ML430 V8-4.3L - Oil Change - Parkville, Maryland
Knowledgeable

Excellent Rating

(31)

Rating Summary
31
0
0
0
0
31
0
0
0
0
Number of Mercedes-Benz ML430 services completed
341+
services done by our mechanics
TOTAL NUMBER OF EXPERT Mercedes-Benz MECHANICS
1100+
experts on our platform

Recent articles & questions

How Air Bags Work
Designed Designed to protect the occupants of a vehicle in the case of an accident, air bags inflate when the vehicle collides with another object, or otherwise suffers a sudden deceleration. Absorbing the energy of the impact, vehicle owners need...
P0218 OBD-II Trouble Code: Transmission Over Temperature
P0218 trouble code definition Transmission over temperature condition What the P0218 code means The P0218 code means that the transmission temperature has...
How to Modify Your Car Payments Without Refinancing
A person’s financial situation can change while they are paying off a car loan (https://www.yourmechanic.com/article/how-to-quickly-pay-off-a-car-loan-by-patrick-haas), and if it changes for the worse, then it will be difficult to make the payments on time each month. This happens to many car...

Why does my car vibrate so much when I am at a complete stop

There are many possible causes for this symptom; there could be a vacuum leak, or the car may simply need a tune-up. It would probably be best to have a certified mechanic take a look at the car and perform...

I am pretty sure my front wheel bearings are going out on my 2010 escape. What is the estimate cost to replace both?

A wheel bearing will not make a crunch sound on bumps but the shocks or struts and sway bar bushings will. I have also seen lower control arms and ball joints make the noise. Try to bounce the front end...

Hello I went outside an started myy car up an it want move I put it in everygear an it still want move it's stuck do u no wht the

Hi Ebony. Thanks for contacting us today. There are several possible issues that could cause this problem, ranging from a damaged shift solenoid to low transmission fluid due to an internal or external fluid leak. The best advice we can...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com