Mercedes-Benz GLC300 Reduced Power light is on Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(13)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(13)

Reduced Power light is on Inspection Service

How much does a Reduced Power light is on Inspection cost?

On average, the cost for a Mercedes-Benz GLC300 Reduced Power light is on Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2018 Mercedes-Benz GLC300L4-2.0L TurboService typeReduced Power light is on InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
2021 Mercedes-Benz GLC300L4-2.0L TurboService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2016 Mercedes-Benz GLC300L4-2.0L TurboService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$112.52 - $125.67
2020 Mercedes-Benz GLC300L4-2.0L TurboService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$104.99 - $112.48
2019 Mercedes-Benz GLC300L4-2.0L TurboService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$105.02 - $112.55
2017 Mercedes-Benz GLC300L4-2.0L TurboService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
Show example Mercedes-Benz GLC300 Reduced Power light is on Inspection prices

A Reduced Power light usually indicates a fairly serious problem with the throttle system. When this light illuminates the vehicle will often go into a “safe mode”, which will severely limit the speed of the car and in some cases will render the vehicle un-drivable.

Since the Reduced Power light can trigger for a number of different reasons, tracking down the exact cause is extremely important, if the vehicle is not properly diagnosed and repaired, the Reduced Power light will trigger again, putting the vehicle in safe mode.

How this system works:

When the vehicle’s computer detects a fault in the engine that affects its drivability, performance, transmission or emission system it will trigger the reduced power light. It will also trigger if there is an issue with the electronic throttle, the accelerator pedal or the throttle module.

When a vehicle goes into reduced power mode it will seriously impact its performance. Some vehicle will be restricted to idle speed while others restrict speed to 20-30 miles per hour. The Reduced Power trigger will save Diagnostic Trouble Codes (DTCs), which will indicate where the fault occurred. In most cases, a Restricted Power light is related to a throttle body or the connector.

Common reasons for this to happen:

  • Faulty Throttle Body: A throttle body is part of the of the air intake system which helps control the amount of air going into the engine. If a throttle body is failing the engine will not get the correct mixture of air and fuel. This can trigger the Reduced Power light as well as lead to a poor running engine. It can also trigger the Check Engine light.

  • Failing Throttle Position Sensor: The throttle position sensor tells the vehicle computer the position of the gas pedal. The computer uses this information to calculate the proper amount of air and fuel to send to the engine. The throttle position sensor also controls shifting the gears of a vehicle, which means that a faulty throttle position sensor will prevent a car from changing gears. If this part is failing, the Reduced Power light will trigger.

  • Faulty Engine Control Unit: The engine control unit is an essential component of a vehicles computer. It regulates and controls many systems, including the drive train and parts of the engine. If a fault is detected in this crucial part, it can trigger the Reduced Power light as well as the Check Engine light. This is a major issue that should be investigated as soon as possible.

  • Faulty Wiring: Exposed or damaged wires can cause issues with the any of these components and will possibly trigger the Reduced Power light. A loose wiring crimp can also be the culprit. Wiring issues can be tricky to track down so using a professional mechanic is a necessity.

  • Malfunctioning Oxygen Sensors: Oxygen sensors are responsible for measuring how rich or lean exhaust gases are leaving a vehicles combustion chamber. The vehicle’s computer uses this information to constantly adjust the amount of fuel going into the engine. A failing or dirty sensor can put too much or too little fuel into the engine. While a failing oxygen sensor will usually trigger a Check Engine light it is possible that the Reduced Power light could also trigger.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the source and cause of the Reduced Power light issue, ​and will then provide a detailed inspection report that includes the scope and cost of the necessary repairs.

How it's done:

The mechanic will inspect your vehicle's air intake system, electrical wiring and sensors, including the throttle body and oxygen sensors, along with other important components. It may be necessary for the mechanic to test drive the car to verify the complaint and provide an accurate diagnosis.

How important is this service?

The Reduced Power light only illuminates if there is a serious issue with the vehicle that must be addressed immediately. In almost all cases, the throttle or the vehicles computer will be malfunctioning which can make driving the vehicle dangerous. While it varies by manufacturer, most vehicles that go into “safe mode” will stay there until the error codes are read by a code scanner.

If the vehicle Reduced Power light illuminates the vehicle should immediately be inspected, diagnosed and repaired.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Mercedes-Benz mechanics

Real customer reviews from Mercedes-Benz owners like you.

Excellent Rating

(13)

Rating Summary
13
0
0
0
0
13
0
0
0
0

Rusty

23 years of experience
528 reviews
Rusty
23 years of experience
Mercedes-Benz GLC300 L4-2.0L Turbo - Oil Change - Mansfield, Texas
On time and very polite.

Keith

18 years of experience
374 reviews
Keith
18 years of experience
Mercedes-Benz GLC300 L4-2.0L Turbo - Auxiliary Battery Replacement - Winter Haven, Florida
Keith was courteous and professional. I will use his services again.

Tomas

17 years of experience
226 reviews
Tomas
17 years of experience
Mercedes-Benz GLC300 L4-2.0L Turbo - Oil Change - Springfield, New Jersey
Very competent mechanic and conveniently done at my drive way.

Nicholas

11 years of experience
597 reviews
Nicholas
11 years of experience
Mercedes-Benz GLC300 L4-2.0L Turbo - Oil Change - Raleigh, North Carolina
I have used Nicholas 3 times and have been very pleased each time.

Excellent Rating

(13)

Rating Summary
13
0
0
0
0
13
0
0
0
0
Number of Mercedes-Benz GLC300 services completed
143+
services done by our mechanics
TOTAL NUMBER OF EXPERT Mercedes-Benz MECHANICS
1100+
experts on our platform

Recent articles & questions

A Buyer’s Guide to the 2012 Audi A5
For For drivers who want a comfortable ride, expert handling and luxurious amenities, the 2012 Audi A5 will certainly fit the bill. Designed for performance and to deliver a gorgeous look, this model offers an array of options and features...
A Buyer’s Guide to the 2012 Chevrolet Equinox
The The 2012 Chevrolet Equinox stands out in the small SUV class for its affordable price, its high-powered engine, and its plethora of features. While the Honda CR-V has led this class for years, the Chevrolet Equinox is positioned to...
P0694 OBD-II Trouble Code: Fan 2 Control Circuit High
P0694 means that the circuit voltage fell more than 10% away from the manufacturer specifications due to a faulty fan motor or relay.

timing chain marks

You should leave the gear where it is unless you plan on removing the distributor and indexing it again. The engine as of now is not on the TDC (Top Dead Center) of the compression stroke of the number one...

oil pressure on 80 what can be the problem?

The best scenario is if the oil pressure sending unit is simply bad. The sending unit can be tested and/or you can simply tee in a known good gauge to rule the sending unit in or out as the cause....

Spark plugs/Coil plugs wont spark and car will no longer start because of this.

The mention of the camshaft position code and the car's mileage make me think of a timing belt problem. If you can see the camshaft you might want to check and see if it is turning while the car...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com