Mercedes-Benz GLB250 Reduced Power light is on Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(5,558)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(5,558)

Reduced Power light is on Inspection Service

How much does a Reduced Power light is on Inspection cost?

On average, the cost for a Mercedes-Benz GLB250 Reduced Power light is on Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2020 Mercedes-Benz GLB250L4-2.0L TurboService typeReduced Power light is on InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
2022 Mercedes-Benz GLB250L4-2.0L TurboService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2021 Mercedes-Benz GLB250L4-2.0L TurboService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
Show example Mercedes-Benz GLB250 Reduced Power light is on Inspection prices

A Reduced Power light usually indicates a fairly serious problem with the throttle system. When this light illuminates the vehicle will often go into a “safe mode”, which will severely limit the speed of the car and in some cases will render the vehicle un-drivable.

Since the Reduced Power light can trigger for a number of different reasons, tracking down the exact cause is extremely important, if the vehicle is not properly diagnosed and repaired, the Reduced Power light will trigger again, putting the vehicle in safe mode.

How this system works:

When the vehicle’s computer detects a fault in the engine that affects its drivability, performance, transmission or emission system it will trigger the reduced power light. It will also trigger if there is an issue with the electronic throttle, the accelerator pedal or the throttle module.

When a vehicle goes into reduced power mode it will seriously impact its performance. Some vehicle will be restricted to idle speed while others restrict speed to 20-30 miles per hour. The Reduced Power trigger will save Diagnostic Trouble Codes (DTCs), which will indicate where the fault occurred. In most cases, a Restricted Power light is related to a throttle body or the connector.

Common reasons for this to happen:

  • Faulty Throttle Body: A throttle body is part of the of the air intake system which helps control the amount of air going into the engine. If a throttle body is failing the engine will not get the correct mixture of air and fuel. This can trigger the Reduced Power light as well as lead to a poor running engine. It can also trigger the Check Engine light.

  • Failing Throttle Position Sensor: The throttle position sensor tells the vehicle computer the position of the gas pedal. The computer uses this information to calculate the proper amount of air and fuel to send to the engine. The throttle position sensor also controls shifting the gears of a vehicle, which means that a faulty throttle position sensor will prevent a car from changing gears. If this part is failing, the Reduced Power light will trigger.

  • Faulty Engine Control Unit: The engine control unit is an essential component of a vehicles computer. It regulates and controls many systems, including the drive train and parts of the engine. If a fault is detected in this crucial part, it can trigger the Reduced Power light as well as the Check Engine light. This is a major issue that should be investigated as soon as possible.

  • Faulty Wiring: Exposed or damaged wires can cause issues with the any of these components and will possibly trigger the Reduced Power light. A loose wiring crimp can also be the culprit. Wiring issues can be tricky to track down so using a professional mechanic is a necessity.

  • Malfunctioning Oxygen Sensors: Oxygen sensors are responsible for measuring how rich or lean exhaust gases are leaving a vehicles combustion chamber. The vehicle’s computer uses this information to constantly adjust the amount of fuel going into the engine. A failing or dirty sensor can put too much or too little fuel into the engine. While a failing oxygen sensor will usually trigger a Check Engine light it is possible that the Reduced Power light could also trigger.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the source and cause of the Reduced Power light issue, ​and will then provide a detailed inspection report that includes the scope and cost of the necessary repairs.

How it's done:

The mechanic will inspect your vehicle's air intake system, electrical wiring and sensors, including the throttle body and oxygen sensors, along with other important components. It may be necessary for the mechanic to test drive the car to verify the complaint and provide an accurate diagnosis.

How important is this service?

The Reduced Power light only illuminates if there is a serious issue with the vehicle that must be addressed immediately. In almost all cases, the throttle or the vehicles computer will be malfunctioning which can make driving the vehicle dangerous. While it varies by manufacturer, most vehicles that go into “safe mode” will stay there until the error codes are read by a code scanner.

If the vehicle Reduced Power light illuminates the vehicle should immediately be inspected, diagnosed and repaired.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Mercedes-Benz mechanics

Real customer reviews from Mercedes-Benz owners like you.

Excellent Rating

(5,558)

Rating Summary
5,170
189
54
28
117
5,170
189
54
28
117

Luis

18 years of experience
321 reviews
Luis
18 years of experience
Mercedes-Benz GLB250 L4-2.0L Turbo - Oil Change - Basking Ridge, New Jersey
Luis was courteous and efficient. Thank you!

William

33 years of experience
69 reviews
William
33 years of experience
Mercedes-Benz E350 V6-3.5L - Reduced Power light is on - Sun City, California
Excellent customer service. Patient as well. Highly recommended.

Ben

41 years of experience
1416 reviews
Ben
41 years of experience
Mercedes-Benz E350 V6-3.5L - Brake Pads Replacement (Rear) - Cypress, Texas
Ben did a great job in a timely manner and look forward to using him again on the next job!!!

Chris

22 years of experience
2229 reviews
Chris
22 years of experience
Mercedes-Benz E350 V6-3.5L - Car is overheating - Lake Forest, California
Chris was really great

Excellent Rating

(5,558)

Rating Summary
5,170
189
54
28
117
5,170
189
54
28
117
Number of Mercedes-Benz services completed
61138+
services done by our mechanics
TOTAL NUMBER OF EXPERT Mercedes-Benz MECHANICS
1100+
experts on our platform

Recent articles & questions

The Best Used Cars to Buy If You Have Limited Mobility
When When you have limited mobility there are a number of challenges you face, one of these can be with your vehicle. Finding a car that meets your specific needs, and addressing your challenges can mean the difference between being...
P0309 OBD-II Trouble Code: Cylinder 9 Misfire Detected
P0309 means one of the engine cylinders is not firing properly due to a faulty coil, or sensor, spark plug, wiring, fuel injector or low fuel level.
P2330 OBD-II Trouble Code: Ignition Coil K Primary Control Circuit Low
P2330 means that there is a problem with a primary or secondary circuit of ignition coil K. This is typically due to damaged or frayed wiring.

After getting oil change rpms jumping up and down wasn't doing this before oil change

You need to have the air cleaner housing and the inlet tube inspected to see if they left a mass air sensor disconnected or if a tube came loose or got damaged. If they cannot locate the issue and you...

Replaced a motor in a 2001 Nissan Maxima and won't crank.

Hello: Anytime you swap out a motor, it's incredibly important to double check that all components correctly align and are compatible. The truth is that without being there to physically inspect your Maxima, it's impossible to diagnose why your engine...

My brake lights not working I changed the switch

It is possible both bulbs are burned out. The filament in each bulb should be tested with an ohmmeter. The bulbs can also be powered off the car to see if both filaments work but be wary of short circuits...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com