Lexus RX400h Fuel Injector Replacement at your home or office.

Our mobile mechanics offer services 7 days a week. Upfront and transparent pricing.

Estimate price near me

Service Location

Customer Ratings

(94)

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

Customer Ratings

(94)

Fuel Injector Replacement Service

How much does a Fuel Injector Replacement cost?

On average, the cost for a Lexus RX400h Fuel Injector Replacement is $1914 with $1620 for parts and $294 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2007 Lexus RX400hV6-3.3L HybridService typeFuel Injector ReplacementEstimate$3564.60Shop/Dealer Price$4387.61 - $6826.85
2008 Lexus RX400hV6-3.3L HybridService typeFuel Injector ReplacementEstimate$3545.68Shop/Dealer Price$4362.19 - $6796.57
2006 Lexus RX400hV6-3.3L HybridService typeFuel Injector ReplacementEstimate$3545.68Shop/Dealer Price$4362.29 - $6796.74
Show example Lexus RX400h Fuel Injector Replacement prices

What is a fuel injector and how does it work?

A fuel injector is a fuel metering device that sprays atomized droplets of fuel in a specific pattern into the engine’s intake manifold or directly into the combustion chamber. The injector has a solenoid and valve within and the operation, or pulsing, of the solenoid is controlled by the powertrain control module (PCM). The PCM controls the solenoid’s “on” time in order to keep the air-fuel ratio optimized while the engine load and operating conditions constantly change. Fuel injectors are usually connected to a fuel rail located on the top of the engine and the fuel rail, in turn, is supplied with fuel under pressure from the fuel pump located in the fuel tank.

When to consider replacing a fuel injector:

  • Rough idle, loss of power, or misfiring. Poor engine operation has many causes but faults in the fuel injection system, including the fuel injectors, are high on the list of possibilities.
  • Odor of raw gas or visible leaks. Fuel injectors should not leak fuel into the intake manifold when the car is off. If you notice any fuel odor around your car, the possibility of a leaking fuel injector should be considered. There should be no external leak from a fuel injector. If an externally-leaking injector is suspected, do not start your car due to the fire hazard.
  • Check engine light. Some fuel injection failures, for example, a faulty solenoid, may cause a trouble code to be set in the PCM and that will cause the check engine light to illuminate. The codes are read and the fuel injector is tested directly, as needed.
  • Major engine repairs, engine replacement, or lengthy storage. All fuel injectors will have deposits given enough mileage. These deposits can cause an imbalance in the performance of the injectors from cylinder to cylinder. When an engine is already disassembled, or if you are installing a new engine, that is a perfect time to service the injectors as a set. All injectors have tiny internal filter baskets. A professional injector service facility will clean each injector ultrasonically and replace these filters for a relatively low cost.

How do mechanics replace a fuel injector?

Injectors can be serviced once removed from the car or replaced outright with new injectors. If the injectors are serviced, specialized cleaning and test equipment are required. The choice to repair versus replace will depend on exactly what is wrong with the injector as well as customer preference. Either option requires removing the injector from the car and the following procedure is typical:

  • Once the engine is cold, the pressure within the fuel rail is relieved by briefly running the engine with the fuel pump fuse out.
  • The upper plenum on the intake manifold is removed along with any cables, hoses, or wiring that restricts access.
  • The supply and return lines are removed from the fuel rail. The electrical connectors to each fuel injector are unlocked and removed. The fuel rail is then unbolted and removed from the intake manifold.
  • The injector(s) requiring replacement are removed from the fuel rail, taking care to not allow any debris to enter the exposed openings. An O-ring seal usually holds the injector very firmly in a finely polished bore in the fuel rail.
  • Using a new O-ring, the serviced or replaced injector is re-inserted into the fuel rail — using engine oil on the O-ring to prevent damaging it. O-rings in this application fit very tight to prevent fuel leaks.
  • The fuel rail is re-installed and the supply and return lines are re-connected. The plenum is re-installed along with all cables, hoses, or wiring.
  • Finally, the engine is run, there is a careful check for leaks, and the vehicle is road tested.

Is it safe to drive with a fuel injector problem?

Yes, so long as there is no external leak of fuel from a broken or malfunctioning injector, it is safe to drive the car. However, if the injector is known to be malfunctioning, it can cause engine misfires, excessive emissions or, in the case of a badly leaking injector, can overload and overheat the catalytic converter. Additionally, fuel efficiency will always be diminished if the fuel injectors are not working properly.

When replacing a fuel injector keep in mind:

  • Using high quality (Tier One) gasoline may reduce deposits on fuel injectors and prolong their life.
  • If an injector problem develops that requires removal of one injector, the best practice is to remove and service all of the injectors at the same time. That service might involve replacement of the electrically failed injector along with off-the-car cleaning of the remaining injectors. Serving all injectors at once ensures the injector set will be balanced, in terms of flow rates, and in turn promote smooth operation of the engine.
  • Do not use fuel system cleaning compounds, or procedures, unless such materials are specified by the manufacturer of your car.
  • On the car cleaning of fuel injectors is not as effective as off-the-car cleaning because injectors have tiny internal filter baskets that should be replaced as part of the process of servicing a fuel injector.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Lexus mechanics

Real customer reviews from Lexus owners like you.

Excellent Rating

(94)

Rating Summary
88
4
0
0
2
88
4
0
0
2

Pardeep

22 years of experience
1277 reviews
Pardeep
22 years of experience
Lexus RX400h V6-3.3L Hybrid - Oil Change - San Jose, California
Best mechanic, always gets the job done, and is super efficient

Patrick

34 years of experience
1579 reviews
Patrick
34 years of experience
Lexus RX400h V6-3.3L Hybrid - Oil Change - Austin, Texas
Once again great service

Lucas

30 years of experience
938 reviews
Lucas
30 years of experience
Lexus RX400h V6-3.3L Hybrid - Noise from engine or exhaust - Los Angeles, California
Lucas is great

Trung

13 years of experience
412 reviews
Trung
13 years of experience
Lexus RX400h V6-3.3L Hybrid - Spark Plugs - Redwood City, California
Trung was excellent. He is highly competent, knowledgeable, professional and personable. He was thorough in his work and clear in communicating his observations and recommendations. I will definitely request him the next time I need something done on my Lexus and would gladly recommend him to others.

Excellent Rating

(94)

Rating Summary
88
4
0
0
2
88
4
0
0
2
Number of Lexus RX400h services completed
1034+
services done by our mechanics
TOTAL NUMBER OF EXPERT Lexus MECHANICS
1100+
experts on our platform

Recent articles & questions

How to Care for Your Car Battery
How How to Care For Your Car Battery Your car’s battery may have been neglected if you have difficulty starting your car, and it is usually when the weather turns...
Is a Keyless Push-Button Ignition More Reliable?
Vehicle Vehicle starting systems have evolved significantly since their inception. When automobiles were initially introduced, you had to manually crank the engine over with a handle on the front of your engine compartment. The next phase involved a lock and...
Symptoms of a Bad or Failing Traction Control Module
Common signs include the Traction Control System (TCS) Light coming on, TCS not turning off/on, and loss of TCS or ABS features.

Turn signals not flashing.

This is a common issue with many Ford vehicles. The faulty part would be your multifunction switch or turn signal switch. There is a mechanism that causes the switch to lock in place during a turn inside the switch that...

Oil leak and hissing noise

You will need to check out all of the plastic oil feed lines on the center area of the motor to see if one is broke. This will pump out the oil. Make sure not to let the oil get...

I put hole in my oil pan in my 2003 VW Passat it has a 2.8L V6 manual transmission I managed to get back on paved road and it shut down, I replaced oil pan and put the recommended oil back in car now it won't start?? I see it may be a sensor the cam shaft or crank sensor should I start with one or both of them and see what happens??

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com