Ford Bronco II Turn Signal Bulb Replacement at your home or office.

Our mobile mechanics offer services 7 days a week. Upfront and transparent pricing.

Estimate price near me

Service Location

Customer Ratings

(25)

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

Customer Ratings

(25)

Turn Signal Bulb Replacement Service

How much does a Turn Signal Bulb Replacement cost?

On average, the cost for a Ford Bronco II Turn Signal Bulb Replacement is $102 with $7 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
1988 Ford Bronco IIV6-2.9LService typeTurn Signal Bulb - Rear ReplacementEstimate$128.95Shop/Dealer Price$142.44 - $160.41
1989 Ford Bronco IIV6-2.9LService typeTurn Signal Bulb - Rear ReplacementEstimate$108.95Shop/Dealer Price$122.46 - $140.44
1984 Ford Bronco IIV6-2.8LService typeTurn Signal Bulb - Front ReplacementEstimate$129.85Shop/Dealer Price$148.58 - $182.24
1985 Ford Bronco IIV6-2.8LService typeTurn Signal Bulb - Rear ReplacementEstimate$108.95Shop/Dealer Price$122.44 - $140.40
1986 Ford Bronco IIV6-2.9LService typeTurn Signal Bulb - Rear ReplacementEstimate$108.95Shop/Dealer Price$122.47 - $140.47
1989 Ford Bronco IIV6-2.9LService typeTurn Signal Bulb - Front ReplacementEstimate$117.37Shop/Dealer Price$132.98 - $157.28
1990 Ford Bronco IIV6-2.9LService typeTurn Signal Bulb - Rear ReplacementEstimate$113.95Shop/Dealer Price$127.32 - $145.20
1985 Ford Bronco IIV6-2.8LService typeTurn Signal Bulb - Front ReplacementEstimate$113.95Shop/Dealer Price$127.69 - $145.86
Show example Ford Bronco II Turn Signal Bulb Replacement prices

What is the Turn Signal Bulb all about?

The turn signal bulbs are located inside the light assemblies on all four corners of the car. The turn signal switch takes the drivers input and sends power to the corresponding bulb to inform other drivers that you intend to change lanes or make a turn.

Keep in mind:

If all four turn signal bulbs stop flashing or lighting up, it is likely that the turn signal flasher has gone bad, not the bulbs.

How it's done:

  • Verify that the turn signal bulb does not flash.
  • Remove the bulb if found faulty.
  • Check the turn signal flasher.
  • Check proper operation of turn signals.

Our recommendation:

The mechanic should check all the lights in your car every time you get a major service.

What common symptoms indicate you may need to replace the Turn Signal Bulb?

  • Turn signal lights are not flashing or lighting up.

How important is this service?

Turn signals exist to alert your surroundings that your vehicle will be making a turn. When you press the lever on your steering column, front and rear turn signal bulbs flash, to let drivers around you know of your intention to make a turn. When a turn signal bulb dies, that turn signal will no longer light up. This means that your vehicle will not alert drivers in front of you (if it’s the front turn signal bulb) or behind you (if it’s the rear turn signal bulb) that you plan to turn, which makes your vehicle a safety hazard. Not having a functioning turn signal is also illegal, and carries a hefty fix-it ticket price.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Ford mechanics

Real customer reviews from Ford owners like you.

Excellent Rating

(25)

Rating Summary
22
2
0
0
1
22
2
0
0
1

Christopher

12 years of experience
142 reviews
Christopher
12 years of experience
Ford Bronco II V6-2.9L - Battery is dead - Charlotte, North Carolina
Arrived early, very friendly & helpful. Was unable to determine cause of battery drain due to battery being completely dead (my fault), however; he was able to tell me what steps to take moving forwards in order to determine the problem.

Kerry

31 years of experience
27 reviews
Kerry
31 years of experience
Ford Bronco II V6-2.9L - Car starts and then dies - Covington, Georgia
Kerry was on time, and he described each diagnostic test that he performed. When he left , he told me the cause of the problem. The fuel pump was not keeping the correct pressure while the vehicle was running. This was caused by the vehicle sitting for a long period of time and the gas tank had developed rust and water in the gas. He showed me samples of the bad gas coming from the fuel pump. He is professional, knowledgeable, and friendly.

Scott

34 years of experience
548 reviews
Scott
34 years of experience
Ford Bronco II V6-2.9L - Starter - Denver, Colorado
Scott did a great job I’d recommend him to anyone.

Nolan

30 years of experience
206 reviews
Nolan
30 years of experience
Ford Bronco II V6-2.9L - Coolant Temperature Switch (Sensor) - Tucson, Arizona
Great job

Excellent Rating

(25)

Rating Summary
22
2
0
0
1
22
2
0
0
1
Number of Ford Bronco II services completed
275+
services done by our mechanics
TOTAL NUMBER OF EXPERT Ford MECHANICS
1700+
experts on our platform

Recent articles & questions

How to Buy a Personalized License Plate in West Virginia
Personalized Personalized license plates (https://www.yourmechanic.com/article/how-to-find-out-which-license-plates-are-available-in-your-state-by-brady-klopfer) add a special touch to your vehicle. It is an inexpensive way to make your vehicle a little more personal without performing any lasting modifications to your car. Personalized license plates are used by many...
B1200 OBD-II Trouble Code: Climate Control Pushbutton Circuit Failure
B1200 means there is an electrical failure in one or more of the climate control system's pushbuttons, likely caused to a damaged pushbutton.
B1904 OBD-II Trouble Code: Air Bag Crash Sensor #2 Feed/Return Circuit Failure
B1904 means there is a circuit malfunction in the #2 airbag crash sensor, likely due to damaged electrical components or a bad sensor.

2009 Buick Lacrosse is setting DTC codes P2125 and P2138.

Hi there. Try performing a snap throttle and see if the wave form changes on the Oscilloscope. If the waves do not change when performing a snap throttle, then the throttle position sensor on the pedal needs replaced. If the...

I have a strong burnt metal smell.

Most of the time, bad smells indicate leaks. Oil, coolant, or brake fluid can leak onto hot surfaces and cause some really potent eye burning type smells. But in your case, I'm suspicious of the brakes. If you have a...

Hello, I need to replace front axle seals and pinion seal on a 2012

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com