Dodge Dakota Power Steering Pump Replacement at your home or office.

Our mobile mechanics offer services 7 days a week. Upfront and transparent pricing.

Estimate price near me

Service Location

Customer Ratings

(9)

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

Customer Ratings

(9)

Power Steering Pump Replacement Service

How much does a Power Steering Pump Replacement cost?

On average, the cost for a Dodge Dakota Power Steering Pump Replacement is $266 with $84 for parts and $182 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2005 Dodge DakotaV6-3.7LService typePower Steering Pump ReplacementEstimate$526.98Shop/Dealer Price$613.03 - $860.65
2003 Dodge DakotaV6-3.9LService typePower Steering Pump ReplacementEstimate$415.53Shop/Dealer Price$474.35 - $645.44
1992 Dodge DakotaV6-3.9LService typePower Steering Pump ReplacementEstimate$415.57Shop/Dealer Price$474.43 - $645.58
2008 Dodge DakotaV8-4.7LService typePower Steering Pump ReplacementEstimate$599.51Shop/Dealer Price$704.35 - $1013.45
1997 Dodge DakotaV8-5.2LService typePower Steering Pump ReplacementEstimate$459.36Shop/Dealer Price$521.14 - $694.47
1992 Dodge DakotaL4-2.5LService typePower Steering Pump ReplacementEstimate$359.11Shop/Dealer Price$404.03 - $532.97
1994 Dodge DakotaV6-3.9LService typePower Steering Pump ReplacementEstimate$415.57Shop/Dealer Price$474.45 - $645.61
1998 Dodge DakotaL4-2.5LService typePower Steering Pump ReplacementEstimate$597.50Shop/Dealer Price$691.46 - $966.63
Show example Dodge Dakota Power Steering Pump Replacement prices

What is the power steering pump and how does it work?

The power steering pump is a belt-driven or electric-driven hydraulic pump that generates the hydraulic pressure needed to provide power steering assist. It develops output pressures of 1,000 PSI or more. The pump output is directed to the steering gear, often a rack and pinion type unit, where the hydraulic pressure pushes on the steering rack, greatly reducing the effort it would otherwise take to turn the steering wheel.

Power Steering

When to consider replacing the power steering pump:

  • Groaning or whining noise when turning. Noise can occur if there is wear on the pump bearings or impeller vanes. A low fluid level or trapped air can also cause noises. If the pump has already been operating while dry, adding fluid may not resolve the noise and replacement of the pump might be necessary.
  • Power steering fluid leaks. Leaks can develop at pump seals, threaded connections, hoses, or on the steering rack and pinion unit. Pump seal leaks will generally require a replacement.
  • Difficult steering. Should you notice it is harder to turn the steering wheel, it might mean the power steering pump output pressure is too low, or there could be blockages in the pump or lines.
  • Damage to the pump pulley. Should the pump pulley become damaged or is loose on the pump shaft, you might detect vibration, drive belt damage, or hard steering. Either the pulley will have to be serviced or the pump assembly replaced.

How do mechanics replace the power steering pump?

  • If driven by a drive belt, the power steering pump is bolted to the engine via a bracket that allows for adjustment of the pump drive belt. Once the engine is cold, and safe to work on, the drive belt is removed.
  • If driven by an electric pump, the pump may be mounted in conjunction with the steering shaft or in conjunction with the steering rack. With either a drive belt or electric pump, removal of any dash, panel, or steering components is performed to access the pump.
  • The threaded connectors to the pump inlet and outlet are loosened and removed.
  • Any mounting bolts and brackets are removed so the pump can be removed.
  • If the old pump has failed catastrophically, or there is reason to suspect contaminants in the power steering hoses, the system is flushed.
  • The new pump is bolted on, the pressure and return hoses attached and the system is bled of all air. If pump is belt-driven, it is tightened to the manufacturer’s specification.
  • Finally, the engine is run and the car is road tested to confirm normal steering effort. If a new drive belt was installed, belt tension is measured again, and adjusted as needed, after the belt has run for a few minutes.

Is it safe to drive with a power steering pump problem?

No. If the power steering pump is operated without an adequate amount of fluid, and the pump reservoir will not hold fluid due to a large leak. The pump could seize, which would snap the serpentine belt and likely leave you stranded. If the pump turns and there is adequate fluid, but there is no power assist, it will require much greater effort to turn the steering wheel, and that presents inherent safety risks. Generally, the wisest course is to seek immediate repairs if you suspect a problem with any component in your car’s power steering system.

When replacing the power steering pump keep in mind:

  • Any belts driving the pump should be inspected and replaced as needed. The pump will only produce the required hydraulic pressure if it is driven by the belt at an adequate speed.
  • Power steering leaks from aged rubber hoses, particularly where the rubber is crimped to the steel tube, are not unusual and should be carefully inspected. The system operates under high pressure. The fluid is flammable, and if leaking fluid happens to contact a hot engine part, a fire might result. You always want to be sure the hoses and connections are sound.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Dodge mechanics

Real customer reviews from Dodge owners like you.

Excellent Rating

(9)

Rating Summary
8
1
0
0
0
8
1
0
0
0

Marco

24 years of experience
157 reviews
Marco
24 years of experience
Dakota 1999 - Power Steering Pump - San Bernardino, CA
He was a GREAT mechanic and a GREAT guy to talk to he broke down exactly what my problem was with my truck and had it fixed in a matter of no time I definently want Marco working on my car next time

Chris

10 years of experience
31 reviews
Chris
10 years of experience
Dakota 2001 - Shock Absorber - Clearfield, UT
Chris was very friendly and professional

Pedro

7 years of experience
26 reviews
Pedro
7 years of experience
Dakota 1998 - Wheel Stud - Bakersfield, CA
Great worker

CURTIS

5 years of experience
8 reviews
CURTIS
5 years of experience
Dakota 2003 - AC Belt - Warrington, PA
great all around

Excellent Rating

(9)

Rating Summary
8
1
0
0
0
8
1
0
0
0
Number of Dodge Dakota Power Steering Pump Replacement services completed
99+
services done by our mechanics
TOTAL NUMBER OF EXPERT Dodge MECHANICS
1400+
experts on our platform

Recent articles & questions

How to Replace a Door Lock Switch
The door lock switch goes bad if pressing the button does not lock or unlock the door or the usual functionality fails to work.
The Guide to Right-of-Way Laws in New Jersey
Most Most traffic accidents in the state of New Jersey occur when one motorist fails to yield the right of way to another, or to a pedestrian. Common sense dictates that you should do everything you can to avoid an...
How Long Does a Fuel Injector O Ring Last?
There There are a number of gaskets and O-rings that reside in an engine. Without these gaskets and O-rings, it would be very hard for the various liquids that are in the engine to stay where they need to be...

Jeep making a whirring noise

Hello, I will address the issues as you present them. For the whirring/humming, I recommend having this noise heard by a mechanic (https://www.yourmechanic.com/services/car-is-making-a-noise-inspection) to have it diagnosed correctly. Noises are a hands on job, so they must be experienced firsthand...

Question

Scion models, as a Toyota "brand", were discontinued in August, 2016. All 2017 Scion models that carried forward were marketed under the Toyota brand. To discuss the historical reliability data of discontinued Scion models versus "Toyota" in general, or versus...

Hi I have a 2010 Ford Fiesta and it is overheating all I can see is the the ac pump is not turning could this be the problem?.

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com