Chevrolet V2500 Suburban Reduced Power light is on Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(18)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(18)

Reduced Power light is on Inspection Service

How much does a Reduced Power light is on Inspection cost?

On average, the cost for a Chevrolet V2500 Suburban Reduced Power light is on Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
1989 Chevrolet V2500 SuburbanV8-6.2L DieselService typeReduced Power light is on InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
1990 Chevrolet V2500 SuburbanV8-7.4LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1990 Chevrolet V2500 SuburbanV8-5.7LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1990 Chevrolet V2500 SuburbanV8-6.2L DieselService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$104.99 - $112.48
1991 Chevrolet V2500 SuburbanV8-6.2L DieselService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$105.02 - $112.55
1989 Chevrolet V2500 SuburbanV8-5.7LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1991 Chevrolet V2500 SuburbanV8-5.7LService typeReduced Power light is on InspectionEstimate$99.99Shop/Dealer Price$109.87 - $117.28
Show example Chevrolet V2500 Suburban Reduced Power light is on Inspection prices

A Reduced Power light usually indicates a fairly serious problem with the throttle system. When this light illuminates the vehicle will often go into a “safe mode”, which will severely limit the speed of the car and in some cases will render the vehicle un-drivable.

Since the Reduced Power light can trigger for a number of different reasons, tracking down the exact cause is extremely important, if the vehicle is not properly diagnosed and repaired, the Reduced Power light will trigger again, putting the vehicle in safe mode.

How this system works:

When the vehicle’s computer detects a fault in the engine that affects its drivability, performance, transmission or emission system it will trigger the reduced power light. It will also trigger if there is an issue with the electronic throttle, the accelerator pedal or the throttle module.

When a vehicle goes into reduced power mode it will seriously impact its performance. Some vehicle will be restricted to idle speed while others restrict speed to 20-30 miles per hour. The Reduced Power trigger will save Diagnostic Trouble Codes (DTCs), which will indicate where the fault occurred. In most cases, a Restricted Power light is related to a throttle body or the connector.

Common reasons for this to happen:

  • Faulty Throttle Body: A throttle body is part of the of the air intake system which helps control the amount of air going into the engine. If a throttle body is failing the engine will not get the correct mixture of air and fuel. This can trigger the Reduced Power light as well as lead to a poor running engine. It can also trigger the Check Engine light.

  • Failing Throttle Position Sensor: The throttle position sensor tells the vehicle computer the position of the gas pedal. The computer uses this information to calculate the proper amount of air and fuel to send to the engine. The throttle position sensor also controls shifting the gears of a vehicle, which means that a faulty throttle position sensor will prevent a car from changing gears. If this part is failing, the Reduced Power light will trigger.

  • Faulty Engine Control Unit: The engine control unit is an essential component of a vehicles computer. It regulates and controls many systems, including the drive train and parts of the engine. If a fault is detected in this crucial part, it can trigger the Reduced Power light as well as the Check Engine light. This is a major issue that should be investigated as soon as possible.

  • Faulty Wiring: Exposed or damaged wires can cause issues with the any of these components and will possibly trigger the Reduced Power light. A loose wiring crimp can also be the culprit. Wiring issues can be tricky to track down so using a professional mechanic is a necessity.

  • Malfunctioning Oxygen Sensors: Oxygen sensors are responsible for measuring how rich or lean exhaust gases are leaving a vehicles combustion chamber. The vehicle’s computer uses this information to constantly adjust the amount of fuel going into the engine. A failing or dirty sensor can put too much or too little fuel into the engine. While a failing oxygen sensor will usually trigger a Check Engine light it is possible that the Reduced Power light could also trigger.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the source and cause of the Reduced Power light issue, ​and will then provide a detailed inspection report that includes the scope and cost of the necessary repairs.

How it's done:

The mechanic will inspect your vehicle's air intake system, electrical wiring and sensors, including the throttle body and oxygen sensors, along with other important components. It may be necessary for the mechanic to test drive the car to verify the complaint and provide an accurate diagnosis.

How important is this service?

The Reduced Power light only illuminates if there is a serious issue with the vehicle that must be addressed immediately. In almost all cases, the throttle or the vehicles computer will be malfunctioning which can make driving the vehicle dangerous. While it varies by manufacturer, most vehicles that go into “safe mode” will stay there until the error codes are read by a code scanner.

If the vehicle Reduced Power light illuminates the vehicle should immediately be inspected, diagnosed and repaired.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Chevrolet mechanics

Real customer reviews from Chevrolet owners like you.

Excellent Rating

(18)

Rating Summary
16
2
0
0
0
16
2
0
0
0

Charles

34 years of experience
342 reviews
Charles
34 years of experience
Chevrolet V2500 Suburban V8-5.7L - Starter - Sandy, Texas
Arrived a little bit early and finished in under an hour. Charles thoroughly test the vehicle to make sure it worked as expected. I could not have asked for more.

Chris

22 years of experience
2247 reviews
Chris
22 years of experience
Chevrolet Silverado 1500 V8-5.3L - Reduced Power light is on Inspection - Sun City, California
Will call Chris again

Michael

9 years of experience
9 reviews
Michael
9 years of experience
Chevrolet Cobalt L4-2.2L - Reduced Power light is on Inspection - Warren, Michigan
Friendly n helpful good job listening to my problem n diagnosing it

Michael

27 years of experience
499 reviews
Michael
27 years of experience
Chevrolet Impala V6-3.5L - Reduced Power light is on - Gilbert, Arizona
Showed up on time and fixed my problem with ease.

Excellent Rating

(18)

Rating Summary
16
2
0
0
0
16
2
0
0
0
Number of Chevrolet Reduced Power light is on Inspection services completed
198+
services done by our mechanics
TOTAL NUMBER OF EXPERT Chevrolet MECHANICS
1600+
experts on our platform

Recent articles & questions

Symptoms of a Bad or Failing Shift Selector Cable
Common signs include the indicator not matching the gear and the vehicle not turning off, starting in another gear, or not going into gear at all.
10 Best Stores to Buy Auto Parts in Houston, Texas
Automotive technicians rely on auto parts stores to add and replace car parts. The best auto parts shop in Advance Auto Parts.
P0791 OBD-II Trouble Code: Intermediate Shaft Speed Sensor “A” Circuit
P0791 means that there is an issue with the intermediate shaft speed sensor circuit due to a faulty sensor, solenoid, or wiring issues.

Car does not go into gear.

Most of the time when this issue occurs it is due to the shift interlock solenoid going bad. Systems that use this part usually have a manual override button near the shifter in order to manually shift into a gear....

2007 Honda Odyssey, 102K miles. Started hearing some engine noise when turning steering wheel at low speed couple of weeks ago. En

The noise associated with steering at low speed is not related to the fault causing code P1717 to display. The steering related noise could involve the power steering pump and/or drive belt although there are other possibilities. To pinpoint the...

Grinding

Hello, thank you for writing in. A grinding noise when turning can come from the mechanical linkage that allows your steering wheel to turn the tires, or it can come from the hydraulic system that assists you in turning. Start...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com