Cadillac Brougham Brake Drum Replacement Costs

Estimate price near me

Service Location

Customer Ratings

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

See availability

Customer Ratings

Brake Drum Replacement Service

How much does a Brake Drum Replacement cost?

On average, the cost for a Cadillac Brougham Brake Drum Replacement is $337 with $166 for parts and $171 for labor. Prices may vary depending on your location.

Car	Service	Estimate	Shop/Dealer Price
1989 Cadillac BroughamV8-5.0L	Service typeBrake Drum Replacement	Estimate$551.18	Shop/Dealer Price$667.61 - $942.08
1990 Cadillac BroughamV8-5.7L	Service typeBrake Drum Replacement	Estimate$505.02	Shop/Dealer Price$620.09 - $894.29
1992 Cadillac BroughamV8-5.0L	Service typeBrake Drum Replacement	Estimate$654.69	Shop/Dealer Price$799.71 - $1116.45
1988 Cadillac BroughamV8-5.0L	Service typeBrake Drum Replacement	Estimate$513.18	Shop/Dealer Price$629.59 - $904.04
1990 Cadillac BroughamV8-5.0L	Service typeBrake Drum Replacement	Estimate$505.02	Shop/Dealer Price$620.14 - $894.37
1991 Cadillac BroughamV8-5.0L	Service typeBrake Drum Replacement	Estimate$550.20	Shop/Dealer Price$675.94 - $978.21
1991 Cadillac BroughamV8-5.7L	Service typeBrake Drum Replacement	Estimate$559.70	Shop/Dealer Price$684.99 - $986.92
1992 Cadillac BroughamV8-5.7L	Service typeBrake Drum Replacement	Estimate$669.69	Shop/Dealer Price$815.96 - $1133.62

Show example Cadillac Brougham Brake Drum Replacement prices

What are brake drums and how do they work?

A brake drum is a heavy, cast iron brake system part that looks like a shallow, several inches-high cylinder about 9 to 12 inches in diameter. The brake drum has a precisely machined surface all around the interior circumference, that the brake shoes make contact with when you apply the brakes, transmitting hydraulic pressure through the wheel cylinder. This forces the brake shoes outward against the interior of the brake drum, resulting in the friction that causes the car to slow. The brake drum is mounted over, and fully encloses, all of the rear brake components such as the wheel cylinder, springs and clips, brake shoes, and parking brake mechanism. The drum is commonly held to the wheel hub by the wheel and the lug nuts, but some configurations combine the drum with the wheel hub as one unit. Nowadays, a drum brake type system is only installed on the rear axle, if used at all, as 4 wheel disc type systems have become more common.

When to consider replacing brake drums:

Reduced braking effectiveness. If the brake drum is unevenly worn, scored or cracked, it will increase stopping distances. A cracked drum must be replaced outright but a worn drum can be restored on a brake lathe so long as enough metal material remains.
Pulsating brakes, pulling to one side, vibration or noise. If a brake drum is warped, is unevenly worn, or perhaps the brake shoes have worn down completely — creating metal-to-metal contact — you might detect pedal pulsation, the vehicle may pull to one side, or you might feel a vibration or hear a noise when you apply the brakes. The brake system will have to be inspected to pinpoint the exact problem.
Brake shoe replacement. Anytime the brake shoes are replaced, the drum must either be resurfaced or replaced outright. Installing new brake shoes on a used, unresurfaced drum will lead to poor results.
Loss of parking brake function. The parking brake locks the brake shoes against the brake drum. If the brake drum is cracked, the parking brake lever will pull up excessively and the car may still be able to roll. However, a more common circumstance is parking brake maladjustment or seizure of parking brake components. Repair of those problems will often require removal of the brake drum.

How do mechanics replace brake drums?

There are two options when it comes to brake drum service: outright replacement or resurfacing. In some cases, it is cheaper to replace the drum rather than refurbish it. In both cases though, the removal and installation procedure for the drum is the same.

Raise the vehicle and safely support it using steel jack stands.
Remove tire and wheel assembly.
Remove brake drum. Sometimes the brake drum has rusted to the wheel hub and removal of the drum will require a brake drum puller. In some cases, the wheel hub is integral to the brake drum, in which case the hub-bearing retaining bolt and the wheel bearing must be removed to replace the drum.
Measure the interior diameter of the machined surface in the drum with a brake drum micrometer or similar measuring tool. If sufficient metal exists to resurface the drum on a brake lathe, the mechanic will compare the cost of such restoration to the alternative: buying a new drum.
Prior to installing the resurfaced or new drum, the brake shoes, springs, wheel cylinder, parking brake mechanism, and backing plate are all inspected. All worn parts should be replaced. Generally, if drums have been replaced or resurfaced, new brake shoes should be installed. The worn shoes will cause irregular wear in the brake drum and reduce braking effectiveness.
The shoes are adjusted and the drum is installed. The wheel and tire assembly are installed and torqued in the proper sequence and the car is road tested to check the operation of the brakes.

Is it safe to drive with a brake drum problem?

No. Should there be a deficiency with the brake drums, stopping distances will not be as short as possible. In a panic stop, stopping just five or ten feet shorter could be the difference between no collision and a collision. Any deficiency in a vehicle’s braking system is a cause for concern and a potential safety issue. Have the brake drums inspected at your earliest convenience to determine if a problem exists and find out what must be done to fix it.

When replacing brake drums keep in mind:

With few exceptions, brake work on one end of an axle should be performed on both ends of the axle. Should a brake drum on one end of a front or rear axle be serviced, or brake shoes on one end are serviced, both sides of the axle should receive the same service. This helps to avoid problems, such as pulling, vibration, and so forth, once the vehicle is returned for use.
Brake drum systems use very powerful springs to keep the brake shoes in position. These springs are exposed to extreme heat. It is best practice to replace all springs whenever new shoes are installed. Should a spring unexpectedly break in the brake drum assembly, a mispositioned brake shoe could cause the brakes to grab and lock, which would pose a safety issue.
If the wheel hub and bearing are integral to the brake drum on your car, the mechanic may recommend replacement of the grease in the wheel bearings and inspection of the wheel bearings.
Since the arc of the brake shoes will not perfectly match with the arc of the drum when new, expect a bed-in period before maximum braking efficiency is achieved.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee

Meet some of our expert Cadillac mechanics

Real customer reviews from Cadillac owners like you.

Excellent Rating

(14)

Rating Summary

14

0

0

0

0

14

0

0

0

0

SEE REVIEWS NEAR ME

Refugio

17 years of experience

51 reviews

Request Refugio

Refugio

17 years of experience

Request Refugio

by Timothy

Cadillac Brougham V8-5.7L - Windshield Wiper Motor Replacement (Front) - San Antonio, Texas

Very professional and polite, did a great job on my car. Thank you Refugio and YourMechanic

Bryan

2 years of experience

92 reviews

Bryan

2 years of experience

by John

Cadillac Brougham V8-5.0L - Power Steering Pressure Hose - Fort Lauderdale, Florida

Bryan was GREAT!!! on time and listened to what I wanted to replace and without hesitation got right to work. Clean, Neat, Efficient and Fast! Best car experience I ever had and right in my own driveway! Will definitely use YOUR MECHANIC again

Joseph

33 years of experience

540 reviews

Joseph

33 years of experience

by Alonzo

Cadillac Brougham V8-5.7L - Windshield Wiper Motor Replacement (Front) - Dallas, Texas

It was a very great first-time experience using your mechanic. Joseph was very knowledgeable and skillful I would definitely recommend to anybody. thank you for the great work you've done I really appreciate it

Manuel

32 years of experience

579 reviews

Manuel

32 years of experience

by Steve

Cadillac Brougham V8-5.0L - Spark Plugs - Newport Beach, California

manuel was perfect. hope i can have him again in the future

Excellent Rating

(14)

Rating Summary

14

0

0

0

0

14

0

0

0

0

SEE REVIEWS NEAR ME

Recent articles & questions

What Kind of Glass Are Windshields Made From?

When When you drive, your windshield encounters a harsh environment. It has an important job to protect you from: Flying stones Bugs and dirt Driving rain and snow Even the occasional bird impact Your windshield is a safety device as...

What are the Car Pool Rules in New Mexico?

Car Car pool lanes have been around for a few decades, and have rapidly gained popularity in recent years. These now cover more than 3,000 miles in many of the country’s states, and help a huge number of drivers every...

How to Keep Your Car’s Acrylic Paint Looking Brand New

Acrylic Acrylic paint was extremely popular in older cars, and can still be found on many cars today. While there are many different reasons for manufacturers, auto body specialists, and car owners alike to use acrylic paint, there is one...

How much pag 46 oil goes in a new condenser for 2005 Honda Accord?

Hi there. You will need to add 1 ounce of Pag 46 oil to the condenser. Also if you are just replacing the condenser, I recommend replacing the receiver dryer as well for excessive moisture in the system. The system...

knocking noise coming from transmission

Hi there. It is more than likely that you have either a damaged CV joint or axle, especially if you hit a curb. If you are going to remove everything, I would recommend inspecting the inner CV axle shaft input...

Why Yourmechanic will not last long?

Feel free to inform this customer that FREE advice on products we DON'T SERVICE (like his moped question) is not what we offer at yourmechanic.com.

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com