Buick Encore GX Car starts and then dies Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(13)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(13)

Car starts and then dies Inspection Service

How much does a Car starts and then dies Inspection cost?

On average, the cost for a Buick Encore GX Car starts and then dies Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2020 Buick Encore GXL3-1.2L TurboService typeCar starts and then dies InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
2021 Buick Encore GXL3-1.3L TurboService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2021 Buick Encore GXL3-1.2L TurboService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2020 Buick Encore GXL3-1.3L TurboService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$104.99 - $112.48
2022 Buick Encore GXL3-1.3L TurboService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.02 - $112.55
2022 Buick Encore GXL3-1.2L TurboService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
Show example Buick Encore GX Car starts and then dies Inspection prices

Starting a vehicle only to have it quit immediately after can be confusing and annoying for many drivers especially if their vehicle has not experienced this type of issue before. Typically, a vehicle will start and then quit because of an issue with the fuel or electrical system. It is important to monitor fuel levels as well as warning lights which can signal to the driver that a vehicle may quit unexpectedly.

How this system works:

To start a vehicle, the electrical system, composed of the battery and starter, turns the engine over. Once running, the engine requires a constant flow of gasoline and good spark to keep that fuel igniting. If gasoline is not readily available, or if there is not enough spark, the engine will quit. More modern vehicles with sophisticated computers may affect the way the vehicle runs. These computers help the car run efficiently but can also shut a car down if the fuel/air mixture is not correct. While an older vehicle may be less sophisticated and easier to diagnose, the computers on modern cars can provide more specific information when connected to a code scanner/reader.

Common reasons for this to happen:

  • Mass Airflow Sensor: The mass airflow sensor measures how much air is entering the engine and relays this information to the vehicle’s computer so that the right amount of fuel can be delivered from the fuel injectors. When a sensor begins to fail, the vehicle’s computer may generate an error code to indicate that something has gone wrong. An issue with the mass airflow sensor may manifest itself when a car starts and then stalls soon after starting.

  • Fuel Pump Relay: The fuel pump relay functions much like a fuse for an electric fuel pump. The fuel pump relay engages as the vehicle is started and starts the fuel pump. While the vehicle is running, the fuel pump relay turns off and the fuel pump is powered by the oil pressure sending unit. If the vehicle’s computer is unable to keep the fuel pump relay running throughout the starting process, the vehicle may start and quit immediately after starting.

  • Ignition Coil: Your vehicle’s ignition coil takes the low voltage of the battery and provides the thousands of volts needed to create a spark in the spark plugs. When an ignition coil begins to fail, it may struggle to provide consistent spark to the plugs, causing the engine to stall after starting.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the reason why the vehicle starts and then dies. The mechanic will then provide a detailed inspection report outlining why the vehicle quit and the cost of any repairs that need to be made.

How it's done:

A mechanic will begin diagnosing your vehicle’s issue by plugging a code reader/scanner into the vehicle’s computer. The mechanic should be able to get more information from your vehicle’s computer on what component has failed. Using this information, the mechanic can begin necessary repairs.

If your vehicle has a bad or failing mass airflow sensor, the mechanic will begin by finding the sensor in the engine bay and checking for any signs of failure. The mechanic should check the wire harness connected to the sensor to ensure that all of wires are properly connected. After removing the sensor, the mechanic should be able to discover the nature of the failure and replace the sensor.

If the mechanic suspects an issue with the fuel pump relay, he or she should check the vehicle’s computer for a problem. If the vehicle’s computer is having difficulty providing consistent power to the fuel pump relay, the computer may need to be reprogrammed or replaced. If the vehicle’s computer is functioning normally, the mechanic may need to replace the fuel pump relay.

If the mechanic suspects that the ignition coil may be faulty, he or she should first disconnect the battery before beginning work. The mechanic should then begin the process of disconnecting wires from the ignition coil and removing it from the engine bay. The mechanic will then install the new ignition coil and ensure that it is connected properly. The mechanic should then reconnect the battery and test the new coil.

With all repairs, the mechanic will ensure the newly installed parts work properly. The mechanic can then turn off and warning lights that may have come on while the vehicle was not running properly.

How important is this service?

If your vehicle is starting but dying soon after starting, you should have it checked out by a mechanic. Issues involving the fuel management and electrical systems will become worse if not dealt with. Diligence and paying attention to warning lights may help prevent further damage to critical engine component and may save money in repairs. A vehicle that quits after starting can be inconvenient and having a mobile mechanic inspect and repair you vehicle will ensure that you and your vehicle are back on the road soon.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Buick mechanics

Real customer reviews from Buick owners like you.

Excellent Rating

(13)

Rating Summary
13
0
0
0
0
13
0
0
0
0

Jason

23 years of experience
190 reviews
Jason
23 years of experience
Buick Lucerne V6-3.8L - Car starts and then dies - Nashville, Tennessee
Very experienced &knowledgeable off my problem an explained all details of my cars problems an how to go about getting the issues fixed.

Brandon

18 years of experience
275 reviews
Brandon
18 years of experience
Buick Park Avenue V6-3.8L - Car starts and then dies - Stone Mountain, Georgia
Arrived on time, which was awesome. Professional attire and attitude. My car wasn't staying on and he figured it out. He explained thoroughly my situation and repair option. I will be booking him to fix.

Brian

18 years of experience
74 reviews
Brian
18 years of experience
Buick Park Avenue V6-3.8L - Car starts and then dies - Elk Grove, California
Brian arrived on time and was professional. I watched as he went through all the diagnostics on my car and came up with the problem. Thank you Brian

Alejandro

9 years of experience
82 reviews
Alejandro
9 years of experience
Buick Regal V6-3.8L - Car starts and then dies - Los Angeles, California
Service was more then i could ask for

Excellent Rating

(13)

Rating Summary
13
0
0
0
0
13
0
0
0
0
Number of Buick Car starts and then dies Inspection services completed
143+
services done by our mechanics
TOTAL NUMBER OF EXPERT Buick MECHANICS
800+
experts on our platform

Recent articles & questions

How to Keep Your Car Running Well in Cold Weather
Cold weather affects how a car performs. Get snow tires, check your car battery, wash and wax your car, and check car fluids to help winter driving.
P2219 OBD-II Trouble Code: NOx Sensor Heater Control Circuit Low Bank 2
P2219 code means there is an abnormal reading within the NOx sensor circuit voltage often due too faulty fuel usage or defective sensors.
10 Best Entry-Level Auto Mechanic Jobs
Automotive technician jobs involve gaining technical experience. Starting in an entry-level job opens doors for advancement into specialized areas.

Battery died. Now can't get into my car to pop the hood and charge it.

Hi there. The car could have made the door latches locked out. This prevents the doors from opening during an event of power loss during an accident. This happens, but the mechanical key should still open the doors. If the...

Steering Angle Sensor

Your vehicle has an electronic vehicle stability control (VSC) system. The VSC system relies on data from the steering angle sensor to keep the vehicle on the intended path during an emergency maneuver. Inasmuch as this is a valuable vehicle...

The car shudders between the speeds of 25 mph to 45 mph when accelerating. What is the problem?

Hi there. Check the engine and transmission mounts on your vehicle. When accelerating quickly, the engine and transmission move around causing the loose or broken mounts to make the engine and transmission move around violently making the front tires to...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com