Buick Century Car Battery Replacement Costs

Estimate price near me

Service Location

Customer Ratings

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

See availability

Customer Ratings

Car Battery Replacement Service

How much does a Car Battery Replacement cost?

On average, the cost for a Buick Century Car Battery Replacement is $276 with $136 for parts and $140 for labor. Prices may vary depending on your location.

Car	Service	Estimate	Shop/Dealer Price
1995 Buick CenturyV6-3.1L	Service typeCar Battery Replacement	Estimate$431.72	Shop/Dealer Price$504.50 - $714.74
2001 Buick CenturyV6-3.1L	Service typeCar Battery Replacement	Estimate$495.67	Shop/Dealer Price$584.92 - $848.56
1992 Buick CenturyV6-3.3L	Service typeCar Battery Replacement	Estimate$422.71	Shop/Dealer Price$493.75 - $702.68
1995 Buick CenturyL4-2.2L	Service typeCar Battery Replacement	Estimate$422.71	Shop/Dealer Price$493.75 - $702.68
1991 Buick CenturyL4-2.5L	Service typeCar Battery Replacement	Estimate$422.71	Shop/Dealer Price$495.22 - $705.26
1993 Buick CenturyV6-3.3L	Service typeCar Battery Replacement	Estimate$422.71	Shop/Dealer Price$493.89 - $702.93
1991 Buick CenturyV6-3.3L	Service typeCar Battery Replacement	Estimate$422.71	Shop/Dealer Price$493.76 - $702.71
2005 Buick CenturyV6-3.1L	Service typeCar Battery Replacement	Estimate$495.67	Shop/Dealer Price$584.95 - $848.60

Show example Buick Century Car Battery Replacement prices

What are car batteries and how do they work?

A car battery is an energy storage device that relies on a chemical reaction within the battery to produce electricity. The stored electrical energy is used to initially operate the starter motor, ignition system, and fuel system on your vehicle. Once your car engine is running, the alternator supplies the electricity needed for all vehicle systems and charges the battery to replace the electric energy used when starting a car.

Most electric vehicles have a traction battery which is in addition to the standard 12 volt battery that is used to start the car engine. Traction batteries also convert chemical energy to supply electrical energy but operate at higher voltages and often are monitored by the PCM (Powertrain Control Module).

Battery

When to replace a car battery?

Your car doesn’t start. A new battery has a specified capacity to provide power. This capacity is referred to as the cranking amps rating of the battery. As a battery ages, the actual amps that a battery can supply becomes lower than its original rating Once the cranking amps fall below a critical threshold, it will be difficult or impossible to start your car.
Battery or charging system warning light is illuminated. Should a battery or charging system warning light illuminate, a mechanic should perform a few basic tests to determine if a battery replacement is needed.
Electrical components don’t work. Once a battery has started to fail, and the voltage produced by the battery drops, then vehicle electrical components can malfunction, such as the security system. If you are experiencing electrical malfunctions, it’s a smart idea to have the battery tested.

How do mechanics replace the battery?

A temporary power source might be installed to avoid the possibility of losing radio presets or stored data in the PCM while the battery is out. When the battery is already completely dead, this step is unnecessary.
The vehicle’s negative cable is removed from the battery, followed by the positive cable. The battery tie down system is loosened and the old battery removed.
Cable ends and wiring are carefully inspected to ensure cleanliness and no corrosion. In some cases, corrosion can be extreme and the cable may need to be replaced or wiring repaired.
The new battery is installed and the tie down system is reinstalled. Anti-corrosion compound is applied to the battery terminals. The positive terminal is reconnected followed by the negative terminal.
Some vehicles, for example some models of BMW, VW, and Audi, may require PCM programming to input battery parameters. This step, performed using a specialized scan tool, is necessary to maximize battery life and prevent electrical system malfunctions.
The car is started and charging system output is measured and compared against the factory OEM specification to ensure that the new battery will properly recharge. Generally, charging output will be in the range of 13.8 to 14.8 volts but the exact specifications vary by make and model.

Is it safe to drive with a battery problem?

Yes, but if you have a weak battery you might be left stranded somewhere if the battery dies completely and you cannot start your car. A faulty battery may also needlessly overload the alternator and could adversely affect the operation of the vehicle’s electrical system, including the vehicle security system and the shift interlock.

When replacing the battery keep in mind:

The quality of the electrical connections to the battery posts is important. Connections must be clean, free of corrosion and properly tightened.
Batteries store a large amount of energy and if short-circuited a battery could explode and can create intense discharges that can damage your eyesight. Insulated tools should be used to attach cabling to battery terminals. Otherwise, the battery’s positive cable can be shorted to ground or the positive and negative posts can be directly shorted. Batteries can only be safely installed from a positive terminal to positive wiring and from a negative terminal to body ground. If the polarity is reversed damage will likely occur to the vehicle’s electrical system.
Generally, a car battery will have a service life of 4 to 7 years. If a load test on a battery reveals a significant reduction in the capacity of the battery to provide power, you should buy a new battery rather than wait for the old battery to fail completely.
Batteries should only be disconnected if the engine is off and the alternator is not running. Disconnecting a car battery while the alternator is running can cause a voltage spike that will damage sensitive electronic components in the vehicle, such as the PCM.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee

Meet some of our expert Buick mechanics

Real customer reviews from Buick owners like you.

Excellent Rating

(10)

Rating Summary

10

0

0

0

0

10

0

0

0

0

SEE REVIEWS NEAR ME

Deuwn

0 years of experience

33 reviews

Deuwn

0 years of experience

by Justin steve

Century 2001 - Battery - Capitol Heights, MD

Very good service

Brett

5 years of experience

264 reviews

Brett

5 years of experience

by Samuel Bell

Century 2001 - Battery - Austin, TX

Great!

Reginald

30 years of experience

70 reviews

Request Reginald

Reginald

30 years of experience

Request Reginald

by Michael F Kindell

Century 1999 - Transmission Position Sensor (Switch) - Los Angeles, CA

The mechanic was very knowledgeable about the car and the problem. He also was very friendly, and had " excellent " customer service skills.

Walter

43 years of experience

238 reviews

Walter

43 years of experience

by Rhonda Taber

Century 2003 - Wheel Hub Assembly - Tulsa, OK

Walter is awesome! He's very knowledgeable about his craft! We would recommend him to anyone!😊

Excellent Rating

(10)

Rating Summary

10

0

0

0

0

10

0

0

0

0

SEE REVIEWS NEAR ME

Recent articles & questions

How to Buy a Personalized License Plate in New York

A A personalized license plate is one of the most popular ways to add fun flair to a New York vehicle. With a personalized license plate, you can show support for your favorite team or your alma mater, show off...

P2110 OBD-II Trouble Code: Throttle Actuator Control System Forced Limited RPM

P2110 P2110 trouble code definition Throttle Actuator Control System Forced Limited RPM What the P2110 code means P2110 is an OBD-II generic code for the engine control module (ECM) detecting a major failure in the throttle actuator control (TAC) system...

Cadillac Certified Pre-Owned (CPO) Car Program

Drivers Drivers who are shopping around for the perfect used Cadillac may want to check out cars under their certified pre-owned program. Many manufacturers have a certified pre-owned (CPO) program, and each one is set up differently. Read on to...

Transmission staying in 3rd gear only and not shifting.

Hi there. The transmission could have an issue with the shift solenoids. Check the wiring harness to the transmission case and make sure that it is plugged in. 3rd gear is the only forward gear in a 4L60E transmission that...

When power steering pump cap is removed should there be a slight presure release

You should have the power steering reservoir cap checked to make sure the vent on cap is not blocked. Also make sure the system is bled of excessive air in the system. Once these two things are checked then you...

My car shows the check engine light, the computer showed code P0455, and it shakes and vibrates at stops and during acceleration.

First, remove and reinstall the gas cap, clear the code P0455 (https://www.yourmechanic.com/article/p0455-obd-ii-trouble-code-system-gross-leak-evaporative-emission-by-john-nelson), and drive the vehicle for a few days and see if the code comes back. If the code comes back on, then either the gas cap (https://www.yourmechanic.com/services/gas-cap-replacement) needs...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com