Acura Legend Car starts and then dies Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(43)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(43)

Car starts and then dies Inspection Service

How much does a Car starts and then dies Inspection cost?

On average, the cost for a Acura Legend Car starts and then dies Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
1988 Acura LegendV6-2.7LService typeCar starts and then dies InspectionEstimate$114.99Shop/Dealer Price$132.49 - $145.62
1992 Acura LegendV6-3.2LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$112.52 - $125.67
1995 Acura LegendV6-3.2LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$112.52 - $125.67
1987 Acura LegendV6-2.7LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$112.48 - $125.60
1991 Acura LegendV6-3.2LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$112.55 - $125.72
1986 Acura LegendV6-2.5LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$112.52 - $125.67
1990 Acura LegendV6-2.7LService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$117.28 - $130.25
1987 Acura LegendV6-2.5LService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$117.94 - $131.39
Show example Acura Legend Car starts and then dies Inspection prices

Starting a vehicle only to have it quit immediately after can be confusing and annoying for many drivers especially if their vehicle has not experienced this type of issue before. Typically, a vehicle will start and then quit because of an issue with the fuel or electrical system. It is important to monitor fuel levels as well as warning lights which can signal to the driver that a vehicle may quit unexpectedly.

How this system works:

To start a vehicle, the electrical system, composed of the battery and starter, turns the engine over. Once running, the engine requires a constant flow of gasoline and good spark to keep that fuel igniting. If gasoline is not readily available, or if there is not enough spark, the engine will quit. More modern vehicles with sophisticated computers may affect the way the vehicle runs. These computers help the car run efficiently but can also shut a car down if the fuel/air mixture is not correct. While an older vehicle may be less sophisticated and easier to diagnose, the computers on modern cars can provide more specific information when connected to a code scanner/reader.

Common reasons for this to happen:

  • Mass Airflow Sensor: The mass airflow sensor measures how much air is entering the engine and relays this information to the vehicle’s computer so that the right amount of fuel can be delivered from the fuel injectors. When a sensor begins to fail, the vehicle’s computer may generate an error code to indicate that something has gone wrong. An issue with the mass airflow sensor may manifest itself when a car starts and then stalls soon after starting.

  • Fuel Pump Relay: The fuel pump relay functions much like a fuse for an electric fuel pump. The fuel pump relay engages as the vehicle is started and starts the fuel pump. While the vehicle is running, the fuel pump relay turns off and the fuel pump is powered by the oil pressure sending unit. If the vehicle’s computer is unable to keep the fuel pump relay running throughout the starting process, the vehicle may start and quit immediately after starting.

  • Ignition Coil: Your vehicle’s ignition coil takes the low voltage of the battery and provides the thousands of volts needed to create a spark in the spark plugs. When an ignition coil begins to fail, it may struggle to provide consistent spark to the plugs, causing the engine to stall after starting.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the reason why the vehicle starts and then dies. The mechanic will then provide a detailed inspection report outlining why the vehicle quit and the cost of any repairs that need to be made.

How it's done:

A mechanic will begin diagnosing your vehicle’s issue by plugging a code reader/scanner into the vehicle’s computer. The mechanic should be able to get more information from your vehicle’s computer on what component has failed. Using this information, the mechanic can begin necessary repairs.

If your vehicle has a bad or failing mass airflow sensor, the mechanic will begin by finding the sensor in the engine bay and checking for any signs of failure. The mechanic should check the wire harness connected to the sensor to ensure that all of wires are properly connected. After removing the sensor, the mechanic should be able to discover the nature of the failure and replace the sensor.

If the mechanic suspects an issue with the fuel pump relay, he or she should check the vehicle’s computer for a problem. If the vehicle’s computer is having difficulty providing consistent power to the fuel pump relay, the computer may need to be reprogrammed or replaced. If the vehicle’s computer is functioning normally, the mechanic may need to replace the fuel pump relay.

If the mechanic suspects that the ignition coil may be faulty, he or she should first disconnect the battery before beginning work. The mechanic should then begin the process of disconnecting wires from the ignition coil and removing it from the engine bay. The mechanic will then install the new ignition coil and ensure that it is connected properly. The mechanic should then reconnect the battery and test the new coil.

With all repairs, the mechanic will ensure the newly installed parts work properly. The mechanic can then turn off and warning lights that may have come on while the vehicle was not running properly.

How important is this service?

If your vehicle is starting but dying soon after starting, you should have it checked out by a mechanic. Issues involving the fuel management and electrical systems will become worse if not dealt with. Diligence and paying attention to warning lights may help prevent further damage to critical engine component and may save money in repairs. A vehicle that quits after starting can be inconvenient and having a mobile mechanic inspect and repair you vehicle will ensure that you and your vehicle are back on the road soon.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Acura mechanics

Real customer reviews from Acura owners like you.

Excellent Rating

(43)

Rating Summary
39
2
1
0
1
39
2
1
0
1

Carlos

25 years of experience
122 reviews
Carlos
25 years of experience
Acura Legend V6-3.2L - Clunking noise when I drive over bumps - San Pablo, California
Good mechanic.

Eric

15 years of experience
133 reviews
Eric
15 years of experience
Acura Legend V6-3.2L - Serpentine/Drive Belt - Washington, District of Columbia
Arrived on time- got job done quickly. Thanks

Bacle

17 years of experience
60 reviews
Bacle
17 years of experience
Acura Legend V6-2.7L - Radiator - Los Gatos, California
Professional demeanor and excellent performance.

Joshua

27 years of experience
709 reviews
Joshua
27 years of experience
Acura Legend V6-3.2L - Brake Warning Light is on Inspection - San Pablo, California
A great guy on time and gets the job done.

Excellent Rating

(43)

Rating Summary
39
2
1
0
1
39
2
1
0
1
Number of Acura Legend services completed
473+
services done by our mechanics
TOTAL NUMBER OF EXPERT Acura MECHANICS
1000+
experts on our platform

Recent articles & questions

How Long Does an Ignition Trigger Last?
In In order to crank a car, there are elements of the electrical and the fuel system that have to work together. As the car key is turned over, the ignition coil will have to let out a spark that...
Texas Speed Limits, Laws, and Fines
Following Following is an overview of the laws, limits, and fines as they relate to speeding traffic violations in the state of Texas. Speed limits in Texas Texas is the only state without prescribed speed limits for each type of...
Windshield Laws in Indiana
If If you drive on Indiana roads, you already know that you are required to follow a variety of traffic rules. In addition to the traffic laws, motorists are also required to make sure that their windshields are in compliance...

replacing a crankshaft sesor in a suzuki XL7

Hi there, thanks for writing in about your 2008 Suzuki. It may be caused by a timing belt (https://www.yourmechanic.com/services/timing-belt-replacement) that has jumped a tooth. A bad crank sensor (https://www.yourmechanic.com/services/crankshaft-position-sensor-replacement) will typically cause the ignition to not fire at all. For...

I still need help. I have a 1997 Chevy k1500 truck. I still won't stop. Can you please help?I I had it put on a code reader and no

Hello - to respond to your email question, we need a little more information regarding the problem with stopping your vehicle, and what work might have already been done. Since this is obviously a huge safety issue, perhaps an inspection...

Where is the fuel pump cut off switch?

The fuel pump cut off switch is located behind the lower passenger scuff panel under the dash by the A-pillar. If you need further assistance with fuel cut off switch (https://www.yourmechanic.com/services/fuel-pump-shut-off-switch-replacement), then seek out a professional, such as one from...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com