To answer your question: maybe. The throttle body has some redundant circuits in it that might make it possible to operate in a "limp home" mode, but unless the owner can have the car repaired and verify the repair before...
Hi there. For the check engine light being on, to start, get a code reader and scan the codes to the computer to have a starting place with diagnosing your engine. The computer can store a lot of codes from...
Replacing the timing belt is not a job to take lightly. If you have never done one before, I suggest you get a shop manual. If your belt broke while you were driving, you probable bent valves in the head....
Assuming you are referring to the AT temp light, this is related to your transmission and indicates that the transmission may be overheating. The ideal transmission fluid (https://www.yourmechanic.com/services/transmission-fluid-service) temperature is under 175 degrees, but as fluid ages it starts to...
What you are describing sounds like a dirty or failing idle air control valve. The idle air control valve (https://www.yourmechanic.com/services/idle-control-valve-replacement) monitors the air intake as it is mixed with fuel prior to being injected into the engine at low speeds...
Hello - your "noisy lifters" (https://www.yourmechanic.com/question/noisy-lifters) could have a couple of causes: worn out lifters (they're hydraulic by the way, not adjustable), or poor oil supply to them. Poor oil supply could be a blocked oil passage, worn out oil...
Hi there. To properly repair your vehicle you need to use the correct ignition coil. If you do not use the right coil then it either will not work or it can damage the circuit and the computer. The resistance...
Hello, thank you for writing in. The alternator should be reading around 14 volts at all times. If it is dropping lower, there is an issue with the alternator or its wiring. You can verify the voltage output with a...
Hello. Thanks for writing in. The warning light is telling you that the automatic transmission is having an issue. It may be a simple sensor issue which occurred during the latest work done. It may be something completely different. The...
Hello, well it sounds like a common issue in the braking system. One thing I would make sure of first is replacing both calipers (one axle) at the same time. The braking system is a hydraulic system and if there...
Hi there. The engine, transmission, and power steering system all use an oil type fluid and the systems are prone to leaks, especially in the case of poor maintenance. If you need further assistance, I recommend you have a certified...
Hi there. When a vehicle sits for a long period of time any number of things can cause this to occur. From the symptoms you are explaining, I would suspect a fuel issue. When a vehicle sits for this long...
What you are describing sounds like a faulty starter solenoid or quite likely a misaligned starter. A faulty starter solenoid (https://www.yourmechanic.com/services/starter-replacement) will generally produce a clicking sound when turning the key. The starter solenoid is located on the starter and...
Hello. In order to properly adjust idle speed on this vehicle you will need a scan tool. The vehicle will need to be put in relearn mode to do so. Over time the computer will adapt on its own if...
Hello. The crankshaft position sensor on your engine is located right above the front of the crankshaft behind the timing cover. The cover will have the be removed in order to replace it. If you need some help with this,...
The pipe that connects to the hose on the back of the engine is the supply pipe to the heater core. If you need further assistance with a coolant leak (https://www.yourmechanic.com/services/oil-fluid-leak-inspection), then seek out a professional, such as one from...
The consequences in regard to the pulley depend on which pulley was vandalized (there are quite a few on a engine). If it was the crank pulley, such could fall off (eventually) and if it does cause a fair amount...
Hello, thank you for writing in. The vehicle may be having spark issues. If the spark is not strong enough to ignite all of the fuel, or does not ignite the fuel at all, the spark plugs may not be...
Hi there. It is suggested to have a bidirectional scan tool but it is not required. Verify the idle speed is within 650-750 rpm. You want to be at 700 rpm ideally. Connect data link connector terminals TEN & GND...
Hello there, when vehicles such as your 2004 Mitsubishi Montero become flooded it can create many issues. The most common problems with flooded cars is water being sucked into the intake, and into the engine. The other problem is corrosion...
