Q: Where's then cam sensor on a Dodge Caliber 2009

The starter on your vehicle is causing your problem. The starter is spinning but the starter lever is not allowing the starter solenoid bendix to engage the flywheel and turn the engine. Technical Service Bulletin (TSB) 13-EE-001 dated January 2013...

If the latch is broken then that will definitely make the door not open correctly. The most common failure on this vehicle though is the door handle breaking inside of the door. If the door will not open then the...

The speedometer and odometer in the cluster are electronic and, if they do not illuminate, then your cluster may have failed. The cluster would have to be scanned to confirm that it is bad and in need of service. The...

Hello there, thank you for asking about your 2005 Kia Sorento. Most of the time if there is a grinding noise that is related to the speed of the vehicle it is caused by a bad wheel bearing. When a...

Your brake system (which includes ABS) has check valves and accumulator chambers between the master cylinder and the calipers. It will be necessary to use a pressure bleeder to overcome these "restrictions." Gravity flow or a vacuum bleeder at the...

You have two hood support gas charged shock supports that when they are weak and low on charged gas will not support the trunk lid as it should. You need to replaced both sides.

Hello, thank you for writing in. 1987 truck's by Dodge were enjoyed for decades. The truck you are looking at is going to need components specific to the condition the truck is in. If you have not already, obtain a...

The fan should blow air toward the engine (i.e., same direction as the air flow when the vehicle is in motion). If the fan is not OEM, the air volume may be off and the electrical characteristics could be different....

It can be tricky, especially as the cable is usually buried amidst other components. The best approach is use the steps in the car manual because that way you do not have to improvise. However, if the manual is not...