Q: Where is the fuel pump shutoff? 2005 Chrysler PT Cruiser

Check the battery (https://www.yourmechanic.com/article/how-to-check-a-car-battery) ground cable (black cable going to the chassis of the car) to be sure you have a proper ground connection as this sounds like a common ground problem. Also, check the battery health (https://www.yourmechanic.com/services/battery-replacement) to be...

Hi and thanks for contacting YourMechanic. The struts or shocks could be causing a rough ride, but the looseness under the vehicle is a suspension part that is loose. Check all of the suspension for any broken bolts or damaged...

Hi there. Getting into an accident, may have created a poor electrical connection (https://www.yourmechanic.com/services/electric-problems-inspection) in the engine management system. Starting the engine, having a rough idle (https://www.yourmechanic.com/services/car-idle-is-rough-inspection) and stalls (https://www.yourmechanic.com/services/car-is-stalling-inspection) could be any number of component failures. Identifying whether there...

Hello - yes, you are correct. Both the 3.7l and 6.1l Jeeps utilize the W5A580 transmission. Should be a straightforward swap. Torque converter may be different however (RPM range engagement), check your transmission supplier for details.

Hello, It sounds like you may have a problem with the voltage regulator. As you know, when turning on an accessory like the A/C, this puts an additional load on the motor which results in the motor needing to create...

You should check each pulley and tensioner or component driven by the belt to see if one of the components are seized that caused the belt to come off. Have a mechanic like one from YourMechanic to come to you...

Hi there. In general, high pressure on both high and low pressure AC sides is typically caused by an obstruction in the evaporator. In some cases, this can be a simple debris that can be cleaned if removed, while in...

Prior to replacing the throttle body, you should go through the Ford diagnostic procedure in the Factory Service Manual for this part to ensure that you do not replace a perfectly good part. The removal procedure is to first remove...

Most vehicles have an ignition switch actuator, or comparable device, and if that component fails, the symptom you describe is exactly what occurs. The diagnosis of this, and the likely part replacement, can be performed at your location. If you...