I have a push door where you just push on the door and it...


I have a push door where you just push on the door and it pops open, but it’s not popping open Mechanic's Assistant: What is the make/model/year of your car? It’s a 2014 Volkswagen Jetta Mechanic's Assistant: Are ...

I have a push door where you just push on the door and it pops open, but it’s not popping open Mechanic's Assistant: What is the make/model/year of your car? It’s a 2014 Volkswagen Jetta Mechanic's Assistant: Are you fixing your Jetta yourself? What have you tried so far? Just pushing on the door as many times as possible. I’m by myself

Automotive Expert
Hello, my name is \*\*\*\*\* \*\*\*\*\* thank you for using just answer. The site will prompt a phone call, but i only accept this service if absolutely necessary, as it is an additional charge. If it is necessary later in the conversation, I will propose it. Is this the fuel door you are referring to? thanks. Kyle S. A.S.E. certified master auto technician licensed smog technician, test and repair, L-1 advanced engine performance certified Certified Volkswagen technician, 2003,2004,2013,2014,2015 Volkswagen and Audi independent 12 years

the fuel door
Automotive Expert
It is very common to have issues with the release that works with the cars locking system. When you lock the car, the fuel door has a little lever that locks the door, and sometimes they catch and do not work properly. Try unlocking and locking the car a couple times. If that does not work, try using a credit card and apply some pressure to the door. Hope this helps, thank you.

Thank you, \*\*\*\*\* \*\*\*\*\* my keys to pry it open. We are good now
Automotive Expert
Ok great. I would look into having that little actuator replaced. Have a good evening.

Yah I definitely will! Thank you you too!

What others are asking

How do I fix a locked seat belt?
Sometimes your seat belt gets locked while you are wearing it, or when you are trying to put it on. When this happens, unbuckle the belt (if it is latched), and let it retract all the way into the retractor....
Car stalls, P0685 code
Hello. Most of the time this is caused by one of two things on your vehicle. It is either because the powertrain control module, or engine computer, is failing internally, or the main relay that supplies power to it is...
My rear tire on the driver side feel hot?
Hello there, thank you for asking about your 2005 Honda CR-V. It is normal for tires to get a little warm after driving on the highway. If one tire is warmer than the others, then first check to make sure...
dealer tells me that the ECM damaged the throttle body. For $1,100 they are replacing both. Does that make sense?
Hi there. From the description you have provided, the ECM (electronic control module) may have been the problem from the start. When the TPS (throttle position sensor) codes were stored in the computer. This would of been the time to...
One of the relays is clicking and draining the battery
There could be a parasitic draw involving the relay that is keeping it engaged. Lexus specifications for parasitic draw with the key off is approximately 50 milliamps. Anything over this amount indicates a parasitic draw. You could remove the fuses...
Is there another name for the front disc brake dust shield on a 1982 Camaro? Everytime I search for them it only brings up rear dr
The part is variously referred to as "backing plates", "dust shields", "front rotor shields", and so forth. If you are looking for an inexpensive used set (left and right), I see a set presently listed on Ebay for $18. Search...
I have a P0193 Fuel Rail Pressure Sensor High Input Code and want to know how to fix this
The code P0193 pinpoint test should be done to verify the pressures and sensor indicate the same. You most likely have a defective sensor for the fuel pressure on the fuel rail. Replace the sensor and clear the codes. If...
Cleaned air mass flow light was red . now unplugged or plugged in . started noticing car was dying at red lights and stumbled high
It should be safe to drive a short distance to purchase a Mass Air sensor. As long as the engine is not stalling or overheating and take it easy driving you should be fine.
Check engine light came on, stayed on for a month, then went off.
Hi there. In most cases, the P0420 code (https://www.yourmechanic.com/article/p0420-obd-ii-trouble-code-catalyst-system-efficiency-below-threshold-bank-1-by-jamahl-walker) means that either the upstream or downstream oxygen sensor in the catalytic converter is not working. The other code listed tends to be caused by issues with the catalytic converter being...