Q: torque hub assembly for 2011 buick lacrosse cxl

If your wheel is not straight you could have a broken control arm or something else may be broken in the suspension. I would have the car checked out by a technician who can better determine the cause (https://www.yourmechanic.com/services/brakes-steering-and-suspension-inspection).

Thank you for your inquiry. Your assumptions are very close, especially if your vehicle has a dual-zone system where the driver and passenger can enjoy different temperatures. Have a certified mechanic, like the ones at YourMechanic, inspect the system (https://www.yourmechanic.com/services/ac-is-not-working-inspection)...

The symptoms you describe lead me to believe you have a fuel leak in your steel fuel line. A fuel leak is a serious concern that needs to be addressed immediately for your safety. The lack of power you are...

When you put pressure in the radiator you are only going up to about 15 psi, but when a cylinder fires, it puts out a lot more than the compression test showed at 125 psi. This is why you are...

Hello, the pitman arm is attached to the steering gear but is not part of the steering gear assembly. This part would not be covered unless it was replaced when the steering gear was replaced. You could look at the...

Hi there. Water will sink down in the fuel. Check the air filter (https://www.yourmechanic.com/services/air-filter-replacement) to see if it is dirty. On a diesel engine, if the air filter is dirty then the engine will not start. Check to see if...

Without the vehicle specifics, I can give you reasons an engine will not start. Besides air, the engine needs spark and fuel to start and run properly. If either are not present, the engine will not start. Lack of fuel...

Hi there. Unfortunately, we are not able to answer your question due to the fact that this is a vehicle we don't service here in the United States. I would recommend contacting your local dealership or Renault specialist to receive...

It sounds like you may have either installed a faulty idle control valve (https://www.yourmechanic.com/services/idle-control-valve-replacement) or you may potentially have a bad connector or wiring running to the idle control valve. You can test the functionality of the valve by checking...