I believe it is a blown head gasket. The engine isn't run...
Responses
Tom
225 days ago
Hello, my name is \*\*\*\*\* \*\*\*\*\* to just answer! I will be assisting you with all of your vehicle questions today. Give me one moment while I review your question and I will be right back with your answer, or I may need some additional information from you about your vehicle. The site will ask for a phone call not me so please disregard that thanks!
Customer
225 days ago
Ok
Tom
225 days ago
Ok this is definitely classic head gasket signs as well as timing being off. So while the head gaskets are being done make sure timing is dead on as well as check engine compression to make sure there is no valve or internal engine damage. If you need more help please use the reply tab to continue our conversation. I am here to help you in anyway I possibly can. Please Stay Safe ! It was my pleasure helping you today .
Customer
225 days ago
Ok thanks
Tom
225 days ago
My Pleasure!
Still not sure what you need?
Have a certified mobile mechanic diagnose what's wrong with your car, at your home or office.
Top Questions
Trending Topics
What others are asking
2004 Saturn Vue...Right Front brake hanging up, replaced caliper and master cylinder and still hanging up.
High brake effort can be caused by a restriction in the system. What can happen with the brake system is the brake hoses attached to caliper degrade internally causing a restriction. The hose will collapse under pressure.
Check engine light is off and when I turn on the key the car won't start. Just happened after changing the clutch kit.
Hi there. If the vehicle ran before you performed the job for the clutch exchange, then back track the work you had performed and look for anything that is not plugged in. Most likely, the crankshaft sensor was unplugged and...
I changed my mas and the check engine light came back on what next
You will need to have the computer scanned to see why the light came back on. If you continue to get codes to the mass air sensor then you should have the pinpoint test completed that will test the system...
Car runs rough in drive but run smooth in neutral
Hi There, It sounds like you may have a faulty MAP sensor as the car responds to putting it in gear or otherwise putting the motor under load. The Manifold Absolute Pressure (MAP) sensor senses engine load and generates a...
i have a code that says it could be an oxygen sensor (THERE IS 4) HOW CAN U TELL WHICH ONE IS BAD?
Oxygen sensor function can be tested and verified using an oscilloscope, automotive scope, or a vehicle specific, manufacturer scan tool. A faulty O2 sensor, if it exists can be found. However, the Diagnostic Trouble Code you are referring to, namely...
im getting a loud squeal from the brakes. However the brake pads and rotors are absolutely fine and relatively new.
This circumstance is not unusual and can be caused by the use of non-OEM rotors and brake pads and also the failure to re-apply factory specified shims and/or appropriate anti-squeal compounds and lubricants. Unfortunately, if and once non-OEM parts and...
Hi, my engine light has started to flash and my car is shuddering and getting worse - especially when stationary. The engine light
Hello, thank you for writing in. The symptoms you are having can come from a range of different issues with the vehicle. There may be a sensor that is failing, low fuel pressure, a spark and ignition issue, or an...
Squealing noise 2010 Range Rover
Hello. This is caused by an oil leak in the engine. I usually use dye in the engine to find the source of the leak. In a lot of cases on this engine the entire motor will need to be...
I have a 2011 Ford F-150. I tried turning the truck on this morning and there was a knocking sound as soon as I try to turn it on.
If the warnings you saw were for oil pressure, you might have some engine damage. If the truck is running, you need to stop using it until you get it checked out. Driving with low oil pressure can do a...
Browse other content
Maintenance
Estimates
I believe it is a blown head gasket. The engine isn't running the same. It 8s giving a jerking or vibration also dark exhaust is visible from the muffler Mechanic's Assistant: Is this your first time dealing with this issu...
I believe it is a blown head gasket. The engine isn't running the same. It 8s giving a jerking or vibration also dark exhaust is visible from the muffler Mechanic's Assistant: Is this your first time dealing with this issue? What size is your engine? Yes, v6 2.5 l Mechanic's Assistant: What is the make/model/year of your car? Nissan skyline 2001 Mechanic's Assistant: Are you fixing your vehicle yourself? What have you tried so far? Right hand drive Mechanic's Assistant: Anything else you want the Mechanic to know before I connect you? I had a busted radiator, which I got replaced and car still overheated. I tried adding blue devil head gasket sealant into the radiator, but car still not functioning properly