Q: my engine light still comes on after i replaced the 02 sensors and the idle air control valve .now the code is low voltage on bank

asked by on January 07, 2018

my engine light still comes on,for low voltage on bank one sensor one its new Bosch. i changed the idle air control valve and cleaned the map sensor witch is very clean. what is wrong with my car.i think its time to junk her. all the wires are good and intact.

My car has 213000 miles.
My car has an automatic transmission.

Check Engine Light is on Inspection $94.99 - $114.99 Get a Quote

The codes describe the conditions in the circuit. A low sensor voltage code may not mean the sensor is bad, it might mean there is a problem in the wiring harness or in the relay for the sensor heater. I’m sure it can be fixed by someone with knowledge of the system, but you might be right about giving up on the car. When they get that many miles it seems you are always chasing one problem or another and every time it costs a few hundred dollars. It adds up fast. Meanwhile, contact YourMechanc to have a technician come out to your home or office to check out your Buick and let you know what it is going to take.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

TPMS light staying on
Hi. There are many problems with the Honda TPMS system. Honda has a proprietary TPMS system and can only be reset by the Honda dealer or somebody that has a Honda TPMS scan tool. I recommend taking the car to...
There is noise when I go over bumpy road or uneven road.the noise only happen when the car left around 5-6 hours before driving
Your front struts may be worn out or have bad strut insulators that need to be replaced. The struts have a gas charge in them that, if too low, will not work correct until the strut is warmed up from...
What does 'Top Up Coolant' light mean?
This indicates the engine cooling system is low on coolant and will need to be topped off. The system should be inspected for leaks to ensure there are no other issues causing the engine coolant level to drop. Please note:...
Temperature gauge not working?
You would need to check the temperature sender unit to see if it got coolant in the connector or wire got shorted somehow. Disconnect the sensor and see if the gauge acts differently. If it does then replace the sensor...
Loose Steering? 2012 GMC Sierra 1500
Hey there. I would suggest having the inner and outer tie rods (https://www.yourmechanic.com/services/tie-rod-end-replacement) checked for looseness and replaced if any play is found. When checking the rack and pinion mounts and bushings there should also be no looseness. The steering's...
Battery dies unexpectedly, turned off the car, went to turn it on 5 min later and battery had died.
Hey there. The battery may not have been recharged (https://www.yourmechanic.com/article/how-to-recharge-a-car-battery) between each stop if you were driving at night with heavy accessory load like the A/C and lights with the radio on. Each time you stop and shut off the...
How do I remove the cylinder head?
The cylinder head bolts on this engine are tightened to 65 ftlb or 88 nm. Over time the bolts that go into the cooling system passages may have corroded in the holes. You should use a large breaker bar and...
Why would someone charge me $600.00 to replace battery cable-positive side?
Hello - on some vehicles, the positive battery cable is quite long, going from the starter to the rear passenger seat or trunk area - literally 15' long. Besides costing quite a bit for the part, the labor to install...
Engine shaking rough idle losing power and burning rich
Hello, thank you for writing in. The first step when having these issues is to scan the vehicle for diagnostic codes, regardless of having a warning light on or not. With no codes, it will be a process of elimination....

Related articles

P2609 OBD-II Trouble Code: Intake Air Heater System Performance
P2609 P2609 code definition A P2609 trouble code indicates that the PCM has detected abnormal voltage readings from one or more of the intake air heater circuits. This particular trouble code is most often associated with trouble codes P2604, P2605,...
P3459 OBD-II Trouble Code: TP, MAP, or MAF Sensors
P3459 means the system has detected a problem with the vehicles TP, MAP, or MAF sensors due to defective cylinders, low oil pressure, or an oil block.
P0384 OBD-II Trouble Code: Glow Plug Control Module Control Circuit High
Trouble code P0384 means the PCM detects a malfunction in the voltage reading of the glow plug heater circuit, often due to a faulty glow plug relay.