I want to know which solenoid is use for changing 1st gea...


I want to know which solenoid is use for changing 1st gear to second gear there are total 7 solenoids in mazda 6 2014 ...

I want to know which solenoid is use for changing 1st gear to second gear there are total 7 solenoids in mazda 6 2014

Automotive Expert
Hello - my name is \*\*\*\*\* \*\*\*\*\* the SSL2 #4 controls the clutch band lock up for 2nd and 6th gear (overdrive) - it controls the fluid flow through the valve body to engage the 2nd gear clutch pack

What others are asking

High-pitched noise
High pitch brake noises are usually caused by the wear indicator on the brake pads. This is a thin piece of metal that makes contact with the rotor with the brake pad lining gets to about 20%. The noise is...
Whining when off clutch and tapping from engine when cold
Hello. The whining noise you are hearing is typically from the pilot bearing located at the rear of the crankshaft. It can be an internal transmission issue but that is not as common. I typically check and even change the...
Oil drain plug and pan missing after oil change
Hello there, this is a rare accident that can occur when oil changes are performed. In this type of situation, an oil sample is taken and sent off to a facility that can perform an oil analysis. This is done...
Car won't start
Hi there, thanks for writing in. It's highly unlikely that the computer is damaged, especially with only 48,000 miles on the vehicle. You may have an issue with your key or the ignition system that is causing some electrical gremlins...
2012 Chevy Equinox with 72k miles vs 2006-07 Honda Pilot, Toyota 4runner, or Toyota Highlander with 100k to 150k miles
Hello. If the vehicles you are look at have been properly maintained then there should be only a few repairs to anticipate. Along with regular oil changes, vehicles of that mileage will likely need brakes, transmission fluid services, and depending...
I am looking for torque specs on front upper and lower strut bolts as well as sway bar linkage nut, not tie rod.
Usually these bolts can be tightened very snugly by hand and be just fine. Almost as tight as you can but not quite. If you do not have the feel for this particular tightening method, the torque specs are likely...
Changed radiator and cooler hoses(2 at 3/8" wide), the ones that run to the bottom of radiator. The car now when starts wont move
You will need to add about 1 quart of fluid that was lost when the radiator and hoses were changed. Check transmission level and if problem continues then you may need to have transmission checked. Just low on fluid will...
What's the usual labor hours on a mastercylinder and slave cylinder replacement
To replace both cylinders takes roughly 8 hours. You can get an exact quote, both as to labor and parts, by using YourMechanic's on-line estimator for clutch repairs (https://www.yourmechanic.com/services/clutch-master-cylinder-replacement). Note that sometimes the problem is just a hydraulic leak, for...