Q: I need brake caliper mounting bolt torque and guide pin torque for 2011 lacrosse. Front and rear brakes

Most of us think that getting stuck is the province of trucks and SUVs driving off road, but that’s not always the case. Your car may get stuck in snow, mud or sand that’s washed over the road, or you...

In addition to providing you with a live video feed of the area directly behind your car to assist with backing out of parking spots and other situations where you need to use reverse, the rear view monitoring system also...

A loose battery terminal can cause a whole host of issues from electrical malfunctions, voltage spikes, and in the worst case scenario, an engine compartment fire. The negative battery terminal needs to be disconnected, and the suspect loose terminal needs...

There's only one thing that will cause a converter to glow red. That is too much air and fuel. The most common reason is the engine is misfiring. If your engine is shaking, and does not have power, it is...

Hey there, thanks for writing in about your 1989 Chrysler New Yorker. The lowered vehicle may be from the previous owner cutting the springs out of the rear struts. This vehicle also has a rear shock system that uses air...

It sounds like your idle air control valve could be failing. The idle air control valve is responsible for maintaining the proper amount of air into the intake while the vehicle is slowing down to a stop and resuming idle...

Hello. While DIN and Double-DIN standards specify height, width, depth, etc. of audio equipment packaging standards, it does not take into account any trim dimensions - which may not be the same for all manufacturers. I would check back with...

Hello. Code P0599 is the code for an issue with the thermostat heater control circuit, while P0171 is for a lean condition on bank 1. P0599 is set when the computer detects that there is an issue with the electronically...

Hi - I suspect your rough idling (https://www.yourmechanic.com/question/what-is-causing-really-rough-idle-by-devon) is an air leak (loose hose or crack in the air intake), or dirty idle air control valve. A leaking exhaust gas recirculation (EGR) valve would also cause rough idling. I recommend...