Q: How to disable alarm on a 97 acura rl

I would need a little bit more information to answer this question fully. When you say the car bolts, I'm assuming that means that the car accelerates without input from you. If this is occurring, it sounds like there may...

Hello. If the engine will not crank at all and the starter and battery are fine then I start by checking to see if the starter relay is getting power (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-starter-relay). If it is but is not sending power to...

Checking all the fuses was a good move. I would also want to put a scan tool on it and check for diagnostic trouble codes (https://www.yourmechanic.com/article/how-to-read-and-understand-check-engine-light-codes-by-jason-unrau) (DTCs) as well as seeing the data that the computer is seeing. A fuel...

Hi, thanks for writing in. When you went to replace the bulb, did you find any amount of corrosion or signs of burns on the connectors or bulb sockets? Try replacing all of the bulbs at the same time before...

Hi there. The most common cause of this is a tire balance issue. I would typically start by checking the balance of the tires to see how they are. I would inspect the tires at the same time as a...

Hello. Code P0672 is the code for a low circuit on glow plug #2. If you are also having an issue with the cylinder 8 glow plug, then both of these issues, together, could be a potential cause for hard...

Hi Corey. The type of problem you are describing above is one of the more difficult ones to diagnose. It typically requires a mechanic to test drive the vehicle and replicate the symptoms (which apparently the dealership has done). The...

You did not mention the model of your vehicle. The noise may be coming from the tires. You should have your tires rotated and balanced first to see if this helps the problem. Since your vehicle is pretty new and...

For optimal ring seating, the cylinder should be honed. I understand you can see the old cross hatch but the honing also ensures that any glaze on the cylinder wall is broken. That glaze prevents the new rings from sealing....