Q: How do you get the purge solenoid hoses off

asked by on June 22, 2016

Bought a purge solenoid valve and got the electronic hose off do not know how to get the other 2 hoses off, a2012 jeep liberty
My car has an automatic transmission.

You will need a fuel line disconnect tool on most models. Some models you have to squeeze the connector and pull it off. Depending on your connection you may need the special fuel line tool to have it removed.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

How do I shift between 2H, 4H, and 4L?
The different gears are designed to help you navigate uneven terrain. There are a variety of gears for you to choose from so you find the one that best suits your needs. To shift between 2H, 4H, and 4L. Start...
ABS light is on
Hi, have you taken the car to get the computer scanned? Typically when the ABS light is on the Check Engine Light should also be on, this lets you know that the computer has detected a fault in the ABS...
How to correct locked ignition, steering, gear shift
If you turn the steering wheel left or right with a little force, while turning the ignition, it will sometimes release it. This usually happens when power steering puts pressure on the steering wheel when it's turned and the car...
Engine modification
Sounds like a nice build. Assuming you used the 305 crank, the engine will still be called a 5.0 or 305, since that is the cubic inch displacement of the engine.
Why does my brake light fuse keep blowing?
The brake light switch is powered by the fuse and then powers the rear brake lights and third brake light also. The power also goes into the body control module to signal to unlock the shifter interlock. I would first...
Tappet noise oud, rough idle 2009 Ford Focus
Hi there - the valve mechanism on your Zetec engine uses solid lifters (or cam followers to be more precise), and need to be adjusted periodically. As you mention, the delayed maintenance may not be helping here as well. I...
MASTER RELAY switch
Hello. There is a large (by comparison to other vehicle relays) relay under the dashboard next to where the dash curves under and meets where you pedals tie in. You will have to remove its mounting screws and unplug the...
Will my car pass smog if the coolant is leaking?
It depends. If for any reason, the leak has caused the check engine light (CEL) to come on OR has caused any of the OBD-II emission monitors to fail to register properly, the answer is no it will not pass...
My 2004 Audi TT brake pedal is very hard to press down. It is taking effort to press down and it is stopping slow too.
You probably have a problem with your brake booster or the vacuum line to the brake booster. The brake booster is a vacuum driven device that helps pull the brake pedal down according to the amount of pressure you put...

Related articles

A Buyer’s Guide to the 2012 Ford Focus
The The 2012 Ford Focus brings a lot to the world of compact cars. Available as either a four-door sedan or a five-door hatchback, the Focus has great fuel efficiency and European styling that sets it apart from other cars...
A Buyer’s Guide to the 2012 BMW 3-Series
The The 2012 BMW 3-Series has been wildly popular in the US since it was first introduced in 1975. This series of luxury sedans sets itself apart from other luxury models with its superior performance and driving dynamics. No matter...
How to Replace a Fuel Hose
The fuel hose goes bad when there are visible leaks under the car or cracks in the hose and when gas vapors are smelled around the car.