Q: How do the sun visors work?

asked by on December 15, 2015

How do the sun visors work?

Your Accord is equipped with two sun visors to help reduce glare from sunlight. Using them is as easy as it gets. Just follow these steps:

  1. Fold down the sun visor.

  2. Pull the support rod out of the roof clip.

  3. Adjust the sun visor to block the glare by swinging it out and sliding it on the slide rod.

  4. Replace the sun visor when you park the car.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

Starter keeps cranking
You have two starter relays. Check and change the starter relay on the inner fender near the battery. Follow the red battery cable to the inner fender relay and this should be your problem. If you are still having trouble,...
Fuel pump will not kick on and all the fuaes and relays are fine and its hooked up right, what is the problem?
You have a circuit opening relay behind the glove box and the EFI relay in the main fuse box in the engine compartment. You will need to have the complete circuit checked to see if they are supplying power. These...
When changing the engine mount, do you have to change out the brackets one at a time?
Hello. If the engine mounts are bad then they need to be replaced. Many times the vehicle will only need one mount if the issue was found early enough. If it was put off for a long time then that...
Truck with P0707 code - 2011 Isuzu NQR
Hello - if you are still getting the P0707 (https://www.yourmechanic.com/article/p0707-obd-ii-trouble-code-transmission-range-sensor-circuit-low-input-by-spencer-clayton) code after replacing the range sensor switch, either the new sensor switch is out of adjustment still, or the wiring/connection to that sensor is malfunctioning. I would recommend a transmission...
p-0101, p-1320, p-1108, p-0107
Hi There, It sounds like you may have a number of possible issues. The codes are as follows: Code P1320 - Faulty or worn out spark plugs (https://www.yourmechanic.com/services/spark-plugs-replacement), Faulty fuel injectors (https://www.yourmechanic.com/services/fuel-injector-replacement), Faulty Camshaft Position Sensor (https://www.yourmechanic.com/services/camshaft-position-sensor-replacement), Faulty Crankshaft Position...
Car starts and idles but idle fluctuates but the car stays on. After bringing the rpms up to 4-5K the car dies on deceleration.
Since you are getting different codes and engine is stalling you may have a sensor issue along with ignition issues like a defective coil or compression problem in cylinder number 5. I would suggest getting a mechanic like one from...
2008 Ford F-150 no reverse
You may have broke the reverse band inside the transmission and would require the transmission to be taken apart to replace the broke part.

Related articles

A Buyer's Guide to the 2012 Mazda CX-9
If If you’re having a hard time picking between a luxury sedan and an SUV, the 2012 Mazda CX-9 is definitely worth a look. It has the exterior of a mid-size SUV, but inside, you’ll find a world of luxury...
A Buyer’s Guide to the 2012 Nissan Maxima
The The Maxima is one of the most popular vehicles from Nissan, and they’ve been hitting it out of the park in recent years. The 2012 Nissan Maxima is a fantastic, practical vehicle that offers some excellent performance for a...
2012 Chrysler 200 vs. 2012 Chevrolet Malibu: Which One Should I Buy?
When you are looking for a small-range sedan, you need to get somewhere quickly and inexpensively, and may even need to take a few kids with you. Slightly larger than a commuter car, these mid-size options offer decent gas mileage,...