Q: How do I use the manual windows?

Hi there. The most common cause of a battery not holding a charge can be a faulty alternator (https://www.yourmechanic.com/services/alternator-replacement). Other causes like a voltage regulator (https://www.yourmechanic.com/services/instrument-voltage-regulator-replacement), PCM (power control module), or an electrical short. In plain terms, the battery is...

This should not have anything to do with the oil changed that was performed, however occasionally, parts get left unbolted or become loose and can drag on ther ground causing a scraping or rattling noise. This can also happen sometimes...

Hi -Filling the windshield fluid reservoir (https://www.yourmechanic.com/services/windshield-wiper-refill-replacement): Inside the engine compartment, towards the front of the engine compartment, in the corner there will be a flip cap with a picture of a windshield wiper. This is the wiper fluid reservoir...

Hi and thanks for contacting YourMechanic. The inner and outer tie rods on your vehicle can take up to some time. The dealership will change out the tie rod ends and then perform a vehicle alignment, so the time there...

The whining noise near the belt area along with the crank no start and sputtering is a pretty good sign the timing belt (https://www.yourmechanic.com/services/timing-belt-replacement) has suffered a failure. It is very common for the failure to occur at start up....

Hi there. I would need to know what kind of truck this is before I could give you and actual information about the issue. From my experience with problems like this it is usually caused by a faulty radio amplifier....

Hello, and thank you for writing in. Replacing the struts was a good starting point. Now you are going to want to inspect the rest of the steering and suspension components (which are very closely related). Turn the steering wheels...

Hello - assuming an adequate oil level, which you have checked, there may be a real oil pressure problem (https://www.yourmechanic.com/article/how-do-you-know-if-the-oil-pressure-gauge-is-bad). It's worth checking with a know working oil pressure gauge, so that you can get the real readings (i.e. 40...

The codes suggest an electrical (wiring) and or sensor fault. A real time scanner can graph sensor function on cranking and you can obtain that diagnostic if you request a check engine light diagnostic (https://www.yourmechanic.com/services/check-engine-light-is-on-inspection). P0335 (https://www.yourmechanic.com/article/p0335-obd-ii-trouble-code-crankshaft-position-sensor-a-circuit-malfunction-by-spencer-clayton) can set if...