Q: How do I turn the engine off after using remote start?

Hello. You are correct that the brakes might be rusted, not allowing the wheels to turn. It is also possible that if you used the parking brake, one of the parking brake cables might be too rusty, causing the cable...

Hello. Water coming out of the exhaust pipe is usually an indication of a blown head gasket. The head gasket is located between the engine block and the cylinder head. Antifreeze runs over the head gasket and when working properly....

Your car seems to be showing symptoms similar to a vehicle with a dirty or failing idle air control valve (https://www.yourmechanic.com/services/idle-control-valve-replacement). This valve regulates airflow when the throttle plate is closed, and if clogged, you will have to usually keep...

The computer should be scanned to see why the Check Engine Light (https://www.yourmechanic.com/services/check-engine-light-is-on-inspection) is on by a mechanic. The Check Engine Light (https://www.yourmechanic.com/services/check-engine-light-is-on-inspection) is an indication that the computer has a fault in the systems that it monitors and has...

Hello. The stalling issues (https://www.yourmechanic.com/services/car-is-stalling-inspection) you are having may by caused by a variety of issues. Typically these symptoms can be blamed on fuel, spark, or air. Fuel and spark being the most common systems to fail. Starting with the...

Hi there. Your scooter has a fuel flow restriction which could either be in the tank, lines, or carburetor itself. Let off the throttle and open the throttle again. If the scooter fixes its self, then the float bowl in...

The cooling system does not need any special procedures to get the air out of the system except to have the heater to on and warm setting. This will allow the coolant to flow through the heater core and out...

Hi there. Check the suspension to the front axle and see if the axle is loose or moving around. If the alignment is good on the front axle and the axle is solid and not moving around, then the band...

Hi there. The code P0303 (https://www.yourmechanic.com/article/p0303-obd-ii-trouble-code-cylinder-3-misfire-detected-by-spencer-clayton_2) means that cylinder number 3 has a misfire. There are three ways that the cylinder number 3 can be misfiring. Spark plug is fouled out and not creating a strong enough spark to ignite...