Q: How do I disable the Rear Park Aid feature?
How do I disable the Rear Park Aid feature?
Your truck has a feature called Rear Park Aid to assist you in backing up. This feature makes a noise whenever there is something within close proximity to the rear bumper. This feature is only active when the vehicle is in reverse. To disable the Rear Park Aid feature.
Press the Setup button until Rear Park Aid appears.
Press the Reset button to turn this feature off.
The statements expressed above are only for informational purposes and should be independently verified. Please see our
terms of service
for more details
Get an instant quote for your car
Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing
What others are asking
Air sucking noise at low RPM during acceleration
Inspect the inlet air tube between the throttle body and the mass airflow sensor. You most likely will find that the tube may be loose, has disconnected, or has cracks in the hose itself. If it is damaged then replace...
Alternator dead short when power applied.
Firstly, with the battery disconnected you will have continuity between the positive cable to the ground of the body or engine if you have any components hooked up or have fuses in. You are getting a complete circuit through some...
Brake pedal has very little resistance
From what you've described, I'd advise you to not drive the vehicle and get the brakes bled out. It's possible that you still have a brake fluid leak in this case. I'd suggest having this looked at by a certified...
Break (stop) Fuse blows when brakes are pressed.
This is often times a result of a short in the system or an incorrect size bulb. Sometimes a bulb that draws too much power can cause this. Check also to be sure the right size bulb is in the...
The cigarette lighter is not working. What should I do?
You will need to get the fuse replaced if it was blown. If you use a phone charger, it may have blown the fuse if it was shorted. Check to see if that may be the case. If not, check...
Camshaft position sensor error code P0343
Hello. The P0343 code (https://www.yourmechanic.com/article/p0343-obd-ii-trouble-code-camshaft-position-sensor-circuit-high-input-by-logan-utsman) indicates there is no signal from the passenger side cam position sensor (https://www.yourmechanic.com/services/camshaft-position-sensor-replacement) (Bank 1 actually). Given you have changed the sensor, this would suggest a wiring or connector issue. Your mileage would also make...
no room to install snap ring that came with lower ball joint.
According to the official Factory Service Manual for your vehicle, the ball joint that was designed for the vehicle, and thence installed on the vehicle, has a provision for a snap ring and the ring is installed at the factory....
Why is my 2010 kia forte sound like it is grinding when I'm driving but when I push the gas harder it stops?
Hi there. If your vehicle is emitting a noise when driving but when you apply more acceleration the noise goes away, then there could be an issue with the engine's lubrication system. Check the engine oil level and make sure...
Too long of a crank to start car
It sounds like you may have a fuel supply problem in getting the proper amount of fuel to the fuel injectors. As you know, when you turn the key to on, the fuel pump (https://www.yourmechanic.com/services/fuel-pump-replacement) is activated and the fuel...
Related articles
A Buyer’s Guide to the 2012 Audi R8
The The 2012 Audi R8 is a two-door sports car with plenty of power and performance to offer. It manages to combine an aggressive stance and plenty of get-up-and-go with the comfort and interior refinement you’d expect from a German...
A Buyer's Guide to the 2012 Acura RDX
Compact Compact luxury SUVs have come a long way since the Acura RDX first showed up on the scene. However, to this day, Acura still produces one of the best vehicles in this category. The 2012 Acura RDX is a...
The Best Used Cars to Buy If You're a General Contractor
If If you're a general contractor, you probably aren’t in the market for a used car. More likely, you’re looking for a pickup truck, because you need to haul equipment and supplies to various job sites. Most contractors will likely...
Browse other content
Cities
Estimates
Maintenance