Have a p133 code says it is glow plug controller. Check [...
Responses
Customer
260 days ago
Thanks
Bart
260 days ago
Hi I'm Bart. I'll be helping you today.
p133 is not a valid code. Could you please resend the code?
Customer
260 days ago
I don't have it with at this time, but it may be a PO 133. Thank you Bart, my name is Ted.It lists it as glow plug controller.
Bart
260 days ago
Hi Ted. Let me see if I can figure out what code you've got. Just a moment please.
p1137?
p133a or p133f
Customer
260 days ago
No, I had autozone check it. Could be p133a, I know it is not with an A.I meant not F.
Bart
260 days ago
If this is a P133a, and you have not replaced the glow plugs, then the glow plug module is faulty.
Customer
260 days ago
Ok, that confirms what I've found out so far. Thank you Bart.
Bart
260 days ago
You're welcome. Thanks for using JustAnswer.
Still not sure what you need?
Have a certified mobile mechanic diagnose what's wrong with your car, at your home or office.
Top Questions
Trending Topics
What others are asking
Car making a clicking sound when trying to start up, but car won't start.
I would have the battery load tested (https://www.yourmechanic.com/services/battery-is-dead-inspection) to see if it is in fact dead. That may cause all the problems you're having.
It is hard to turn the wheels when stopped/ moving slowly.
You may have a power steering pump that is low on pressure and cannot produce enough pressure at low speeds to turn easily. Have the power steering pressures checked by a mechanic to be at or above about 700psi. If...
Mudguard destroyed under my left front bumper
Hello, thanks for writing in about your 2016 Hyundai Accent. You will be ok driving it around. Your mudguard does not serve a critical function that would otherwise prevent you from driving your car safely. If you'd like some peace...
Misfire code 302 cylinder 2
Hey there. Your logic is absolutely correct. This is in fact one of the most commonly used ways to diagnose a bad ignition coil. If the trouble code turns to a P0301 (https://www.yourmechanic.com/article/p0301-obd-ii-trouble-code-cylinder-1-misfire-detected-by-jamahl-walker), the ignition coil is faulty (https://www.yourmechanic.com/services/ignition-coil-replacement). If...
My car shuts off while I'm driving sometimes and makes a bubbling noise once the car is warmed up or if I'm driving
Your coolant overflow reservoir usually bubbles when the engine has a restriction that causes the flow of coolant to be reduced. This can lead to or be a cause of the engine to overheat (https://www.yourmechanic.com/services/car-is-overheating-inspection). I would recommend getting a...
Leakage of the automatic transmission fluid.
As you describe it, it sounds like you may have a leak coming from your transmission; however, it's difficult to diagnose without more information or actually seeing the vehicle. I would recommend having an expert from YourMechanic come to your...
Car takes multiple tries to start when cold. Fine when warm. New battery. DLR says check valve on fuel pump assembly. Needs entire assembly?
The fuel pump has a small check valve the is suppose to keep fuel pressure up to the fuel injectors after you shut off the engine. The check valve is an integral part of the fuel pump assembly. The way...
Type of oil and when to change
Oil change intervals on your vehicle are determined by the vehicle's engine oil change monitoring system. A message on your instrument panel will alert you when it is necessary to change the oil. The change interval is based on a...
Hi I have a chevy j1 2010 model. My remote is jamed and I can't start my car. It shuts off my fuel how can I reset my alarm to start the vehicle.
Hi there. The remote will need to be repaired or replaced and then the new remote would need to be programmed to match the computer system in your vehicle. Then your vehicle will start up properly. If you need further...
Browse other content
Cities
Services
Have a p133 code says it is glow plug controller. Check [engine](/topics-engine-gmc/) light on, remote start won't work. Mechanic's Assistant: Does the light stay on, or does it blink? Continuous Mechanic's Assistant:...
Have a p133 code says it is glow plug controller. Check [engine](/topics-engine-gmc/) light on, remote start won't work. Mechanic's Assistant: Does the light stay on, or does it blink? Continuous Mechanic's Assistant: What is the make/model/year of your car? 2017 gmc duramax l5p Mechanic's Assistant: Are you fixing your vehicle yourself? What have you tried so far? Still trying to figure it out, doing it myself if possible Mechanic's Assistant: Anything else you want the Mechanic to know before I connect you? Disconnected ground on [battery](/topics-battery-gmc/), light went out until I tried to remote start it.