Q: Does my 2013 ford f-150 xlt 3.5L Turbe have a fuel pressure regulator or a fuel rail pressure senser on it

The fact that it is speed related leads me to think it is somehow related to the tire area. Calipers are what actually apply the brakes on the car when you step on the pedal. If one of the caliper...

Hello. Most vehicles require an oil change (https://www.yourmechanic.com/article/when-should-i-change-my-oil) at least every 5,000 miles. This is a good rule of thumb. If your engine has a knock (https://www.yourmechanic.com/article/what-does-it-mean-when-an-engine-knocks) now, then it either had an issue with the oil getting low or...

The most common faults that cause your hard start can be a EVAP Purge Solenoid that is on the intake manifold. It's relatively easy to replace and only around $25. Or, it can be a fuel pump (https://www.yourmechanic.com/services/fuel-pump-replacement) pressure issue...

Trouble code P0430 (https://www.yourmechanic.com/article/p0430-obd-ii-trouble-code-catalyst-system-efficiency-below-threshold-bank-2-by-spencer-clayton) is for a catalyst on the drivers side. The sensor after the converter may be bad and not responsive enough or the catalyst itself may be bad. The catalyst (https://www.yourmechanic.com/services/catalytic-converter-replacement) should be replaced if the converter...

Hi there: It's very possible that reduced pressure from a cylinder is an indication of a blown head gasket. In most cases, this problem is caused by damaged piston rings or a hole in the piston, but a blown head...

It sounds like you may have a dirty or failing idle air control valve. The idle air control valve (https://www.yourmechanic.com/services/idle-control-valve-replacement) monitors the air intake as it is mixed with fuel prior to being injected into the engine at low speeds...

Hello, thank you for writing in. The first person to tell you this was correct to a certain extent. If the system is not warmed up, the readings cannot be taken accurately. However, if the engine is warmed up and...

If there are known faulty or damaged parts in the front suspension, those parts must be replaced in order to diagnose a hard steering (and/or failure of steering wheel to return) issue. In particular, the correct position of the front...