The [clutch](/topics-clutch-dodge/) safety switch
Responses
Gary
260 days ago
Hello! My name is Gary.
Welcome to JustAnswer.
I'm reviewing your question now, and will post back with a reply shortly.
Customer
260 days ago
Okay
Gary
260 days ago
Sounds like you have had a clutch plate failure.
Does it make any noise above normal when you try drive?
Gary
Customer
260 days ago
No it doesn't go anywhere it goes in and out of gear just fine no slipping no play in the clutch I pushed the clutch to the floor has tension I put it in gear I release the clutch and it doesn't move and it's still in gearAre you going to call
Gary
260 days ago
Your call payment hasn't gone through.
Your clutch operation is what usually happens when the clutch plate linings falls off. You get no drive. Or you have a broken shaft in the transmission. Usually you would hear some noise if the 2nd scenario is your case here.
Gary
Customer
260 days ago
Where would the clutch plate linings be located
Gary
260 days ago
Here is a simple explanation of how a clutch works:
[https://www.howacarworks.com/basics/how-a-car-clutch-works#:~:text=Most%20cars%20use%20a%20friction,power%2C%20the%20clutch%20is%20engaged.&text=When%20the%20clutch%20is%20disengaged,which%20releases%20the%20clamping%20pressure.](https://www.howacarworks.com/basics/how-a-car-clutch-works#:~:text=Most%20cars%20use%20a%20friction,power%2C%20the%20clutch%20is%20engaged.&text=When%20the%20clutch%20is%20disengaged,which%20releases%20the%20clamping%20pressure.)
I would say you need to have your vehicle towed to your nearest workshop for repair.
I wish you well moving forward.
Gary
Still not sure what you need?
Have a certified mobile mechanic diagnose what's wrong with your car, at your home or office.
Top Questions
Trending Topics
What others are asking
How do I set the electronic speed control?
The electronic speed control system lets your vehicle run at a set speed without you pressing on the throttle. All the controls for the electronic speed control system are on the right side of the steering wheel. Setting the system...
Clunking noise from rear suspension
It is possible that you could have some play in your rear control arm bushings or rear toe adjustment links. I would recommend having a rear suspension inspection performed by a qualified professional to determine where the noise is coming...
Car starts very weakly after filling up with gas.
Hello and thank you for contacting YourMechanic. Sometimes the gas cap vent tends to get stuck shut making the fuel system go into a vacuum. Check the gas cap for the seal to ensure that it is sealing. Make sure...
AC is not blowing cold and a plastic-like smell when AC is on.
There are different possibilities that could contribute to the plastic smell. The smell could be caused by a coolant leak, an electrical issue, the A/C compressor overheating, or simply an outside smell. Sometimes, plastic bags tend to get stuck to...
How do I replace my thermostat housing on my 2008 Chrysler 300
Hi there. Replacing this part does not require a lot of knowledge of cars, but you do need to have some mechanical experience to keep you from damaging anything. The thermostat housing can easily be broken when installing it if...
My car keeps jerking & making a noise.
Hi there. Typically when your car will stumble or jerks while you are driving or accelerating, it is caused by a fuel system restriction or ignition system components that are worn out and having a hard time igniting the fuel...
low beams keep going out
You may have a low voltage condition getting to the low beam circuit of the headlights and causing them to burn out early. Check the low beam relay to see if it is giving battery voltage at each headlight socket...
Shaking while driving
Depending on what the cause of the drive shaft causing the vibration is, this may be a reasonable estimate or not. If the drive shaft (https://www.yourmechanic.com/services/driveshaft-replacement) is damaged or broken and needs to be replaced, this may impact the estimate....
Drove thru water mechanic said engine not hydrolocked but need starter, starter put on now need new engine
A starter cannot ruin the engine. The most likely cause of this issue is that the mechanic misdiagnosed the issue and that the engine was actually hydrolocked in the first place. I would recommend Consulting with them to determine if...
Browse other content
Estimates
Cities
The [clutch](/topics-clutch-dodge/) safety switch Mechanic's Assistant: Has the clutch been slipping? Are you having any trouble shifting? No it has not been shift slipping and no there is no trouble shifting there is sti...
The [clutch](/topics-clutch-dodge/) safety switch Mechanic's Assistant: Has the clutch been slipping? Are you having any trouble shifting? No it has not been shift slipping and no there is no trouble shifting there is still pressure in the clutch when you push it down or tension but when I release it while it's in gear the vehicle doesn't go anywhere Mechanic's Assistant: What is the make/model/year of your car? 2013 Dodge dart SE Mechanic's Assistant: Are you fixing your Dart yourself? What have you tried so far? I am currently in the position of trying to fix it myself