96 dodge ram pickup left turn signal works but rear does ...


96 dodge ram pickup left turn signal works but rear does not new bulb seems to have power until you install bulb check with light from behind then no power Mechanic's Assistant: Is the power loss consistent, or does it flu...

96 dodge ram pickup left turn signal works but rear does not new bulb seems to have power until you install bulb check with light from behind then no power Mechanic's Assistant: Is the power loss consistent, or does it fluctuate? Only losses power when bulb is installed Mechanic's Assistant: What year is your Ram? 1996 Mechanic's Assistant: Are you fixing your Ram yourself? What have you tried so far? Yes put new bulb in checked power with test light but when i install bulb power goes off at socket Mechanic's Assistant: Anything else you want the Mechanic to know before I connect you? Emergency flasher does same thing just on rear

Automotive Expert
Hello, my name is \*\*\*\*\* \*\*\*\*\* thank you for using just answer. The site will prompt a phone call, but that is not always necessary. If it is necessary later in the conversation, I will propose it. I am sorry you are having this concern, but I will do my best to assist you. Does the right hand rear turn signal work ok? I would go under the truck and take a look at the wiring, especially where the trailer harness connects to the rest of the harness, and look for any obvious damage. Hope this helps, thank you. Kyle S. A.S.E. certified master auto technician licensed smog technician, test and repair, L-1 advanced engine performance certified Certified Volkswagen technician, 2003,2004,2013,2014,2015 Volkswagen and Audi independent 12 years

right side works right just left is messed up and i looked under at trailer wiring seem to be fine i also unhooked signal wire from trailer harness and ran just truck main wire
Automotive Expert
Ok. My next move would be to access the wire that feeds the left rear turn signal up front, and check the voltage supply there. That way, we know if its from there back, or internal headed towards the turn signal switch itself.
Automotive Expert
I would access the turn signal switch on the column, and get to the connector for it. There will be a dark green/red wire on terminal 15. This is the output for the left rear turn signal. Back probe and see what voltage you have on that wire, with a voltmeter.

friend has my volt meter hes at work but test light shows it flashes but when i install bulb light goes out comes back on when i remove bulb
Automotive Expert
Yes goes away under load. I am leaning toward the turn signal switch itself.

ok i will try voltage test when i get meter back but switch sounds prettygood thank you so much iwill try to let you know when done tom
Automotive Expert
No problem, have a great day.

What others are asking

Drove without oil; car shaking, cut out
If the engine had no oil in it, the shaking, noise, and eventual seizure of the engine would have been the result of that. The engine is also more likely to overheat. The white smoke that you saw is likely...
Ignition column popped out
Hi. It will depend on the damage done. Most likely the steering column is ok, it is the ignition lock cylinder, the housing, and the switch that have probably sustained damage and these items will need to be replaced. My...
Car is starving for fuel at idle after warming up - 1991 Ford Mustang
Hi there. I usually start with the idle air valve in these cases, as it sounds like it might be sticking. Checking fuel supply - fuel pressure, filter, dirty injectors, as you have noted - is a good idea. You...
Brown stuff coming from the radiator.
Hi there: If you have almost 600,000 miles on your Impala, it's probably time to replace your radiator (https://www.yourmechanic.com/services/radiator-replacement), as the brown stuff is likely rust coming from within your radiator due to excessive use.
How often should I lubricate suspension? I have a 2012 Jeep Grand Cherokee.
The published maintenance schedule for your vehicle only lists an inspection recommendation for the front suspension and that would be every 6,000 miles. There is no reference to lubricating ball joints or tie rod ends, on the maintenance schedule, presumably...
Starts but wont move or rev up after replacing battery 2005 Ford Explorer
Hi there - your symptoms suggest a problem with the throttle position sensor (https://www.yourmechanic.com/question/car-hesitation-when-taking-off-at-a-light-by-gloria-l). Check for problem codes - whether the Check Engine light is on or not - I would expect some indication of a problem here. Changing the...
Can a Catalytic converter break up little pieces and ruin your engine
It is not possible for broken off pieces from a catalytic converter to get into your car's engine and damage it. However, if your vehicle's catalytic converter is damaged, including breakage or melting of the internal honeycomb substrate that contains...
Check engine light is on 2014 chevy impala..Auto zone said it was the rocker arm..the chevy dealer said it was the throttle body..
Generally, the check engine light (https://www.yourmechanic.com/services/check-engine-light-is-on-inspection) comes on when something fairly serious is going on with the vehicle. This can happen for many different reasons such as a faulty mass air flow sensor (https://www.yourmechanic.com/services/mass-airflow-sensor-replacement), a faulty O2 sensor (https://www.yourmechanic.com/services/oxygen-sensor-replacement), a...