My temperature gauge spiked up to hot, my heater stopped ...
Responses
J Hall
233 days ago
Hello, my name is \*\*\*\*\* \*\*\*\*\* I will do what I can to assist you with this overheating problem. There are only a few reasons why your [engine](/topics-engine-chrysler/) overheated. The most common one is that the cooling fan or fans quick working. But you could have also lost the [water pump](/topics-water-pump-chrysler/) belt or the [thermostat](/topics-thermostat-chrysler/) has failed. The cooling fans are electrically operated based on engine temperature. They are also computer controlled. The easiest thing for you to check right away is the belt. Look at the front of the engine (the passenger side of the car) and make sure the belt is still there. After that, you will have to do some electrical diagnosis, and you may need a scan tool to help you.
Customer
233 days ago
Would that cause the lose of the heater as well?
J Hall
233 days ago
If the coolant level drops suddenly, all the coolant drains out of the heater core. Without coolant running through the core, there is no heat.
Did the heater blower quit working, or did the heater just quit blowing hot air?
Customer
233 days ago
It started blowing cold air
J Hall
233 days ago
If you want, I can send you the wiring diagram for the cooling fans. However, you will have to use a DMM to perform the electrical measurements in order to diagnose the problem.
J Hall
233 days ago
If you don't think you will be able to diagnose the cooling fans yourself, then make sure you have a qualified mechanic or reputable repair shop do the work for you. If you need any other information from me, please let me know and I will do what I can to assist you. I wish you well, and thank you for using JustAnswer.
Still not sure what you need?
Have a certified mobile mechanic diagnose what's wrong with your car, at your home or office.
Top Questions
Trending Topics
What others are asking
How do I use the power sunroof when my vehicle is turned off?
When you enter your car, you cannot adjust the sunroof without first turning the vehicle on. However, after turning the vehicle off, you can continue to operate the power sunroof. If you have the electronic vehicle information center (EVIC), then...
I need to pass smog test.
Hello. When a vehicle sits for this long there can be a number of issues keeping it from starting and running right. You do need to replace the battery, and you should replace all of the fluids before starting it...
What problems will keep the remote keyless entry transmitter from working?
If your remote keyless entry transmitter is not working properly, it is likely because of one of the following problems: 1. The battery in the transmitter is dead. 2. A key is already in the vehicle’s ignition switch. 3. You...
I have the service engine light on
The computer should be scanned to see why the Check Engine Light (https://www.yourmechanic.com/services/check-engine-light-is-on-inspection) is on by a mechanic. The Check Engine Light (https://www.yourmechanic.com/services/check-engine-light-is-on-inspection) is an indication that the computer has a fault in the systems that it monitors and has...
I'm smelling gas - 1997 Volvo 850
Hi there and thanks for contacting YourMechanic. The best way is to look in your owner's manual and look up the fuel tank size. Then remove the fuel tank from the vehicle to gain access to the fuel filler neck....
I want to know if this is the CV axles or the differentials that need replacement.
With the clicking noise on turns and when accelerating you most likely have bad front CV joints on the front axles. If you notice the clicking on left turns only then it is the left axle joints. If you notice...
I have air pockets in my cooling system how do I get them out
The cooling system does not need any special procedures to get the air out of the system except to have the heater to on and warm setting. This will allow the coolant to flow through the heater core and out...
I'm removing the motor but the input shaft is still in the motor instead of staying in the transmission what do I do?
Hi there. The input shaft is stuck in the pilot bearing on the engine or the back of the crankshaft. If the input shaft came completely off, then you will have to use a slide hammer to remove the input...
Why do I keep getting a C0268 code in my 2005 Chevrolet Tahoe
Hello. Typically when you get this code it is because the pump is not functioning. Most of the time it is caused by the pump windings in the motor failing which will cause an improper voltage feedback which sets the...
Browse other content
Estimates
Cities
Services
My temperature gauge spiked up to hot, my heater stopped working, and my [radiator](/topics-radiator-chrysler/) spewed liquid from the cap Mechanic's Assistant: Have you checked the coolant? Have you noticed any leaking? ...
My temperature gauge spiked up to hot, my heater stopped working, and my [radiator](/topics-radiator-chrysler/) spewed liquid from the cap Mechanic's Assistant: Have you checked the coolant? Have you noticed any leaking? No leaking. Just had it replaced Mechanic's Assistant: What is the make/model/year of your car? 2007 Chrysler town and country Mechanic's Assistant: Are you fixing your Town and Country yourself? What have you tried so far? The oil and coolant levels were just checked and replaced.