Car pulls to right under load


Car pulls to right under load Mechanic's Assistant: What is the make/model/year of your car? 2007 chrysler [pacifica](/topics-pacifica/) base model 3.8L fwd Mechanic's Assistant: Are you fixing your Pacifica yours...

Car pulls to right under load Mechanic's Assistant: What is the make/model/year of your car? 2007 chrysler [pacifica](/topics-pacifica/) base model 3.8L fwd Mechanic's Assistant: Are you fixing your Pacifica yourself? What have you tried so far? Yes , i have changed all front in beside sway bar bushings

Automotive Expert
Welcome to Just Answer I'm Chris aka Moose, I'm sorry you are having problems with your Pacifica. I will do my best to help you get this resolved. If I happen to be helping another or step away during our communication, please know I will follow up as soon as I am back available/online. I try to be online for about 10+ hours a day, midday and late-night shift. **car pulls to right under load** ------This can be to blame on the alignment, not within specs. Steering linkage and suspension joints and bushings worn. It can also bea concern from torque steer to blame on the [axle](/topics-axle-chrysler/) shafts having to much slack in the CV joints. Thank you for visiting Just Answer, I hope I was able to answer your question. If you need to follow up on this concern please use the reply button. If you like my answer please reply so I can mark your question complete. Moose

Problem found jack car back up whole front and took part bar out to wiggle and my dumb ass for got to tight control arm bolt.
Automotive Expert
Glad you found the issue

Well Wife did but we won't mention that now
Automotive Expert
My lips are sealed.

What others are asking

Clutch pedal goes to floor.
You have a hydraulic issue. This could be your clutch master cylinder, which is mounted in the back of your engine compartment near the brake master cylinder. The clutch master cylinder (https://www.yourmechanic.com/services/clutch-master-cylinder-replacement) pushes hydraulic fluid down to the clutch slave...
Car speakers going in and out
The radio is likely the cause, but the speakers may also be the cause. If the speaker sounds good one minute, then bad the next, then it is the radio. I recommend that you have a mechanic, such as one...
Car overheating after only a few blocks
If the engine is overheating, then the coolant level should be checked. The system may be low or may have an air bubble trapped in the system. Please note that the cooling system should never be opened or checked while...
How do you get Check Engine Light reading with no OBD-II plug?
All vehicles that are newer than 1996 and sold in the United States are required to have an OBD-2 system. The scanner (https://www.yourmechanic.com/article/can-i-fix-my-car-with-a-home-code-reader-scanner) plug may have been removed for some reason by the previous owner or mechanic. If this is...
Pulsating brakes.
Hello. All of the things that you listed could potentially cause the pedal to pulsate. If a wheel hub was recently replaced then I would move on to looking at the other hubs, as well as the rotors and pads....
Brakes still going to floor
This may suggest your brake booster is failing. The brake booster (https://www.yourmechanic.com/services/vacuum-brake-booster-check-valve-replacement) is a mechanism that uses vacuum pressure to take the force being applied to the brake pedal and amplify it. If the booster is bad, then the full...
What type of unloaded fuel is recommended for citroen c3 1.4i 2002?
You can start with the lowest octane rating available and see how well the vehicle performs. If the vehicle performs well without hesitation and has decent fuel economy, then you can stick with that octane rating. If you begin to...
Hi Mark I have an audi a4 2005 1.8 quattro AC seems to cut out in real hot tempratures also the transmission goes into limp mode
A possibility with the A/C system is a fault in the evaporator that causes internal and/or external icing. The resulting high head pressure causes the control circuitry to "throttle" the compressor, hence the ECON mode. Check for a blocked air...
When I'm on the accelerator, transmission acts as if it doesn't wants to shift.
The problem sounds like you are losing power and most common cause is the distributor causing loss of spark or timing. Take off distributor cap and if there is any oil in cap then replace distributor.