I have a 95 ford f50 everytime i try to start it th plugs...
Responses
Nachum Wagschal
213 days ago
Good Afternoon ,
On a fuel injected engine like this , I would suspect a jumped timing chain , have you checked compression ?
Customer
213 days ago
no i have not check for a jump timing how do i do tht by ccecking the distributor
Nachum Wagschal
213 days ago
Phone call session started
Nachum Wagschal
213 days ago
I would just check compression and see if its low , or move the crank to the tdc mark and see where the distributor is pointing , if its 180 out turn the crank over again
Nachum Wagschal
213 days ago
let me know if you need more information about this
Still not sure what you need?
Have a certified mobile mechanic diagnose what's wrong with your car, at your home or office.
Top Questions
Trending Topics
What others are asking
Gas smell while driving.
Smelling a gas odor coming from your vehicle is never good experience and it usually means there is a leak somewhere. From the description provided, it is quite possible that the EVAP Purge Canister has developed a leak and needs...
General Inspection or Individual Inspections
Hello. Most of the time the 150 point inspection is a visual inspection of most of the mechanical components of the vehicle. This would not be a complete diagnostic. The inspection may include scanning the computer for codes, but that...
Car jerks when putting in drive.
The jerking reaction when putting the vehicle into drive suggests that your transmission may be low on fluid. Automatic transmissions use pressurized hydraulic fluid to change gears. Every time a gear change is required, the car's computer activates a transmission...
Check engine light on and code P1791 showing when connected to scanner. 1997 Acura TL
Hello - the P1791 code indicates a problem with an internal speed sensor (or governor) within the transmission. This device provide RPM information from the transmission to the transmission controller - which determines when the transmission shifts up to the...
My car still overheats, I replaced water pump and thermostat, and now after water pump install it knocks bad
Hi there: Trying to diagnose an overheating issue remotely is incredibly difficult. However, there are three things you can do to attempt to solve this issue. First, remove the water pump, verify it's the right replacement part and reinstall with...
car wont start, acts like its not getting gas.
Hi there. Check to see if the fuel that was in the system was old and sitting for a while. If so, I recommend putting in a fuel water evaporator chemical that can be purchased at a local parts store....
Loud clicks no start
If what you have is a rapid tapping sound when you turn the key, You are not getting enough current to the starter. When the solenoid engages and connects the starter, the battery voltage rapidly drops to the point where...
Inside beeping noise when starting my 2014 Chevy Cruz
Hi Lakeshia. Thanks for writing in today. Most of the time, when you hear a chime when the car starts, it's a safety warning indicating that either a door or seat belt is not correctly closed or a sensor that...
Where is the camshaft position sensor locate on dodge charger 3.6l 2011
The camshaft position sensor (https://www.yourmechanic.com/services/camshaft-position-sensor-replacement) is near the thermostat and radiator hose. You will see a small black plug with wires going into it. If you need additional help with replacing this, please contact our service department to schedule a...
Browse other content
Estimates
Maintenance
I have a 95 ford f50 everytime i try to start it th plugs will be full with gas Mechanic's Assistant: Have you noticed an increase in fuel consumption? And how does the Ford start—same as usual? I drained alitle wat...
I have a 95 ford f50 everytime i try to start it th plugs will be full with gas Mechanic's Assistant: Have you noticed an increase in fuel consumption? And how does the Ford start—same as usual? I drained alitle water from the oil but that isgetting in from the thermostat housing but ifi pull the plugs then turn over the motor alittle then put them back in the truck will start for 3/4 seconds then dies Mechanic's Assistant: What is the model of your '95 Ford? F150 Mechanic's Assistant: Are you fixing your F150 yourself? What have you tried so far? Changed all sensors included pcm still no canges Mechanic's Assistant: Anything else you want the Mechanic to know before I connect you? Please connect me thank you