☰
GET A QUOTE

Have a 2012 equinox with 2.4 replaced crankshaft sensor a...


Have a 2012 equinox with 2.4 replaced crankshaft sensor and now it wont start Mechanic's Assistant: Does the vehicle stall at low speeds? Does it sputter? Before I replaced the sensor it ran like shit and would stall ...

Have a 2012 equinox with 2.4 replaced crankshaft sensor and now it wont start Mechanic's Assistant: Does the vehicle stall at low speeds? Does it sputter? Before I replaced the sensor it ran like shit and would stall Mechanic's Assistant: Are you fixing your Equinox yourself? What have you tried so far? Replaced crankshaft sensor that's the code I got and now it wont start

Read More

Responses

Automotive Expert
hello welcome to justanswer.com my name is \*\*\*\*\* \*\*\*\*\* i am here to help answer your questions so before replacing the sensor did you have a code for it and did you get a factory sensor to replace it

I had a code cant remember the number but it said crankshaft. I got the replacement from auto zoneIt's almost like a fuel problem to me . I did remove the intake and high pressure fuel pump to get at the sensor
Automotive Expert
Do you think it’s base fuel pressure or high pressure pump side

Not sure but guessing high pressure side

High pressure when I depressed the Schrader valve there was fuel but no pressure like the 1600 to 2000 psi
Automotive Expert
When removing the pump was there a spring and cup that rides on a lobe was the spring put back and if you remove the high pressure pump if you push it with a screwdriver can you feel anything when pumping it

Spring was intact and there is resistance if pushedPut the old crank sensor back on
Automotive Expert
How is it doing

Dont now just finished and havent tried startingRan for a couple of sec and died and sounded like shitGoing to dump a whole can of go go down its throat lolIt would even run before
Automotive Expert
ok

I give up maybe the computer needs to be flashed
Automotive Expert
do you think it does to me its hard to say

I'm thinking it's going to come down to a case of lead poisoning lolStill no codes
Automotive Expert
Yeah sometimes it’s hard diag a problem over the computer it sometimes can be easier and more helpful if I could touch the car

I hear you bro and know where your coming from
Automotive Expert
Yeah

Still not sure what you need?

Have a certified mobile mechanic diagnose what's wrong with your car, at your home or office.

Get a Diagnostic

Top Questions

Trending Topics

What others are asking

How do I lock the RamBox side storage units?
Locking the side storage units is very easy. Both units are locked and unlocked with the main vehicle key; simply insert the key into the storage unit lock, and twist it to unlock or to lock.
Read more
Car overheats when heater not on
There can be a variety of reasons that your Ford Five Hundred is overheating, even after repairs have been made. While it is possible you are experiencing problems with the water pump, you may have a defective new thermostat as...
Read more
is it safe to change Transmission Fluid. Hasn't been changed in a long time. Currently the Transmission is working fine; no slip
I agree with the other mechanic. If the fluid looks dirty then this means the transmission was not serviced for a long time and if you service it then the new fluid will wash out all the clutch material (https://www.yourmechanic.com/article/how-does-a-transmission-filter-work)...
Read more
My truck vibrates in the frount end when i slow down are brake around 30 to 20 mph ive changed the whole set up as far as brakes
Hello. This is a sign of potentially bad or worn wheel bearings (https://www.yourmechanic.com/services/wheel-bearings-replacement). When wheel bearings wear out or become damaged due to dirt or debris or lack of proper lubrication, they will cause this type of vibration which is...
Read more
my 4runner has no power pulling hills?
Hi Marsha. Has the timing belt been recently serviced? If so, did the concern start after this service? The timing belt may be incorrectly set. However, if the timing belt has not been recently serviced there are other possible reasons...
Read more
The carpets in my Saturn Vue are always soaked, and I can't find any leaks
This is a common sign of a leaking heater core. The [heater core]((https://www.yourmechanic.com/services/heater-is-not-working-inspection) is a small radiator like unit that circulates the hot coolant from the engine through the heater core which then uses this warm coolant to heat the...
Read more
Rpm spike and engine rattle
Hello. Thank you for writing in. The vehicle seems to be having a shifting issue. A rattling noise is a bad sign that something has broken off inside of the engine or transmission that is disabling it from shifting correctly....
Read more
Theft light cant start car
The theft system on you car requires the key to be a programmed key to turn off the theft system so you can start the car. If you have the original key then disconnect the battery and connect the cables...
Read more
Lost hose below two heater hoses and unable to find proper name for hose to replace it. Can you assist?
Hi there. The hose that you are describing sounds like the heater core by-pass hose. If the hose is short and straight, then it would be the heater by-pass hose. The heater by-pass hose it to by-pass the heating system...
Read more

Browse other content

Maintenance
Cars
Cities
Services