Unlock radio code


Unlock radio code Mechanic's Assistant: Has the battery been recently disconnected? Have you checked the manual or the glove box for the radio code? No manual Mechanic's Assistant: What is the make/model/year of y...

Unlock radio code Mechanic's Assistant: Has the battery been recently disconnected? Have you checked the manual or the glove box for the radio code? No manual Mechanic's Assistant: What is the make/model/year of your car? Renault 2004 magan Mechanic's Assistant: Are you fixing your vehicle yourself? What have you tried so far? Pulled the radio out and tried the cofe on radio as the site said. Mechanic's Assistant: Anything else you want the Mechanic to know before I connect you? Don't know what number the letter is ?.

Automotive Expert
Hello, Welcome to Just Answer. I am sorry your radio is not working. We used to be able to give out radio codes however, due to security reasons, for your protection, we are prohibited from giving out the code to your radio. This measure is put in place to prevent thefts, and we want to keep you and everyone else safe. But the good news is, you can get the code from your local dealership by giving them the serial number to the radio and your VIN. I recommend calling the parts department. They are the easiest to deal with. Thank you for visiting JustAnswer, and if you have any other questions please feel free to reply to me here.

What others are asking

How do I answer a call?
When a paired phone receives a phone call, it will come through the sound system, even if the sound system is currently playing something. To answer the call, press the Phone Send button.
The new ignition is locked, cannot turn over
Hello. When you install a new ignition and a new computer, it needs to be reprogrammed to communicate correctly. This can usually only be done at the dealer. If they are not programmed correctly then the computers will not communicate...
No trailer running lights
Hello. The trailer could be wired wrong. It also could be a blown fuse (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-fuse) or relay. There is a running light fuse under the hood and a relay behind the rear bumper. Either one being blown will cause your...
Malfunction indictor lamp comes on and car won't move
You should first have the code scanned in the computer and then diagnosed to see what is causing the concern. If you have a floor shifter and have spilled fluid into the shifter, then you may be getting shorting in...
My truck is giving codes P0171 & P0174
Hi there. If the engine is running lean, then there could be a plugged fuel filter (https://www.yourmechanic.com/services/fuel-filter-replacement) or a faulty fuel pump (https://www.yourmechanic.com/services/fuel-pump-replacement) with loss of pressure. If the pressure is dropping after 20 to 25 minutes, then there could...
car won't start and keeps showing error code P0129.
With a reoccurring code such as this, after replacing the sensor, it is time to test the wiring harness and connector at the sensor. The orange wire should have 5V. This would be the 5 volt reference. The black and...
I went to an automatic car wash and 2 minutes after that my car's dashboard flickered and the car died.
You are likely experiencing an electrical short (https://www.yourmechanic.com/services/electric-problems-inspection) of some kind. This is likely due to a wire or electrical component being exposed to the water from the car wash. A number of electrical components will become damaged when exposed...
2003 trailblazer car starts but wouldn't move when I put it in drive or reverse yesterday. This morning it drove fine.
Hello, thank you for writing in. Typically no response from the transmission is a sign of a failed hydraulics. This is most commonly caused by low transmission fluid, a clog or hydraulic valve issue, or transmission failure. You will want...
chevy tahoe 5.7 pcm voltage output issue
Re-check the triggering signal using the specific LED test light described in the instructions at this page (http://easyautodiagnostics.com/gm/4.3L-5.0L-5.7L/how-to-test-the-icm-3). If the LED test light does not flash per those instructions then the PCM would have to be tested further. If the...