There was a swift sportz manual car but the problem is it...


There was a swift sportz manual car but the problem is its steering getting heavy ...

There was a swift sportz manual car but the problem is its steering getting heavy

Automotive Expert
Hello and thank you for using JustAnswer. My name is \*\*\*\*\* \*\*\*\*\* I will do my best to assist you. During this conversation you will be given an automated offer for a phone call. You may accept or decline that offer.I don’t personally offer this service so if you take this another tech may call I’m sorry that you’re having trouble with your vehicle. I will do my best to help you resolve them. Please understand that I do not know your knowledge or capabilities so I may need to ask questions to find out basic information to help solve your specific problem. My aim is to give you the best service possible and to help you. If you have any questions or concerns, please don’t hesitate to let me know. Sometimes it may take a moment for me to respond because I may have to look up information about your concern. I appreciate your patience and will provide responses as soon as possible. Ok, by steering getting heavy, do you mean that it feels more like manual steering when turning? Any noises when turning? Thanks for using Just Answer and letting me help you. I hope I provided what you needed. If you find more help is still needed, let me know by listing out any remaining questions you have on this concern. I hope the remainder of your day is well.

No its becoming heavy to turn while running
Automotive Expert
HI First, check fluid level and condition. If it is black, start with a fluid change. If ok, then it will be the pump starting to get weak due to wear on the pump shaft and will need to replace the pump

Ill.check for it and msg u tysm
Automotive Expert
HI ok, sounds good

One small question how much that may cost to replace pump2007 swift sportz has any defects it ran at 157K

What others are asking

How do I operate the cinch tongue seatbelts?
The cinch tongue seatbelts can be repositioned along the belt as well as fastened. Seatbelts are very important and should always be fully operational. To operate the cinch tongue seatbelts. To add more length to the seat belt, pull some...
Steering wheel locking up.
The theft system on your car can have an intermittent problem of being disabled because of having other keys or metal items on your key ring. These items may be interfering with the code key to disable the system for...
How do I control the air flow mode selection?
Your climate controls have three different air flow modes: face level (air is directed towards the face), floor level (air is directed towards the feet), bi-level (air is directed towards both the feet and the face), floor/defrost level (air is...
My car is running hot
I would recommend checking for smoke coming from your exhaust. Since you are not able to find a leak and you are positive that the coolant is not mixing with the oil, it is very likely that your engine is...
Will a bad battery cause my car to shut off and my EPS light to come on? What would cause it to come on?
Hi there. This is a serious battery problem if the battery is now swollen and has no power. There has been an obviously internal fault. This will cause the vehicle to power down and the EPS light to come on...
Pcv valve problem
Hello. In most case a PCV valve should not noticeably rattle, though that varies from engine to engine. If it appears to be rattling excessively that could signify that the PCV valve is not secured properly, that there is a...
Stalling at cold start, runs fine when warm
Diesels are in fact notorious for being cold blooded by nature and can be even worse on cold starts. This is mainly due to the manner in which diesel fuel is ignited vs regular gasoline. Diesel fuel has a much...
What type of Ball Joint System does a 2005 Nissan Altima Have? Or where can I find this information ? 2005 Nissan Altima
Hello - the front suspension on your Altima utilizes a lower control arm (https://www.yourmechanic.com/question/when-replacing-ball-joints-can-you-just-replace-the-ball-joints-or-do-you-have-to-replace-the-whole-control-arm-by-debra-l) (with a pressed in ball joint), and a strut/spring assembly. The ball joint comes pressed into the aluminum lower control arm, and is generally not available...
My truck was getting codes of P0300 & P0420 & P0430. My truck can't go over 40/45MPH without jerking 1997 Chevrolet Tahoe
Hello - the first task is to check problem codes to see if the P0300 (misfire (https://www.yourmechanic.com/article/how-can-problems-with-the-ignition-system-cause-misfiring_2)) code is still present, or others. If so - which seems to be what your description indicates - you may have ignition coil,...