Q: 2013 explorer sunroof won't close. The fuse is ok, no motor noise

The transmission in your truck has the updated 4L60 series with a heavier duty forward gears and thrust bearings so your transmission problem is most likely the torque converter or front pump failure. The clutch materials in an automatic transmission...

If you are not getting any spark, a few things I would check would be the ignition coil or coils (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-fuse), the ignition module, the ignition system fuses (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-fuse), and finally the cam (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-camshaft-position-sensor) and crank position sensors (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-crankshaft-position-sensor). Tests...

Hey there. It looks as if you've thrown everything at it except the kitchen sink. Sometimes simplifying the search is the best course of action in regards to keeping the engine running. This would narrow it down to air, fuel,...

Your mechanic's diagnosis and explanation could well be correct. This is classic symptom behavior of a failing ignition switch. The contacts become "burned" over time and over lots of "start" cycles. The repair is to replace the ignition switch (https://www.yourmechanic.com/services/ignition-switch-replacement)....

Hi there. It is suggested to have a bidirectional scan tool but it is not required. Verify the idle speed is within 650-750 rpm. You want to be at 700 rpm ideally. Connect data link connector terminals TEN & GND...

Hi there. First check the transmission position sensor (https://www.yourmechanic.com/services/transmission-position-sensor-switch-replacement) to see if the wiring harness has a short to ground or the sensor is failing. This sensor will cause the engine to shut off in the event that the computer...

Hi there. If the hood will not set correctly on the vehicle and the adjustments were made in all directions, then the hinges may be bent or out of placement. I recommend replacing the hinges with new ones to have...

There are two catalytic converters on the Expedition, one for each "bank" of the engine. Converter 1, corresponding to Bank No. 1 of the engine (passenger side of vehicle) has quite a bit of pipe integral with the converter and...

Fault code B1342 has to do with the anti-lock brake system (https://www.yourmechanic.com/services/abs-light-is-on-inspection). It typically indicates that the ABS control module is faulty. While there is also a possibility of faulty wiring to the ABS control module or even a faulty...