Q: 2012 Toyota Santana , replace alternator,discornete battery,will not start even with charger on it
Starter button will not turn green,
Recommended Services
| Car is hard to start Inspection | $94.99 - $114.99 | Get a Quote |
Hi there:
If you have a remote FOB key, it’s possible that there is a problem with that key, or that by disconnecting the battery, the ECU reset, causing the ignition system to be faulty right now. There are many electrical issues that could be the source of your starting issue, which is why it’s probably a good idea to have a professional mechanic complete a car is hard to start inspection, so they can pinpoint the source of your starting issues.
The statements expressed above are only for informational purposes and should be independently verified. Please see our
terms of service
for more details
Get an instant quote for your car
Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing
What others are asking
Random misfires
Hello. There are several possibilities that could explain why you are having this problem. One possibility is that you could have one or more faulty fuel injectors (https://www.yourmechanic.com/services/fuel-injector-replacement), or the fuel injector wiring is damaged. Another possibility is that one...
Moisture in fuse box causes fuel pump fuse malfunction
For this, Silicone spray is one tool I personally like to use especially on rubber or silicone seals. The spray will leave a water-tight film on the electrical component and offers a moisture resistant coating. If you would like to...
Purge valve canister
Hi there. In most cases, the purge valve (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-canister-purge-solenoid) needs to be replaced. It's due to rough idle or issues with emissions. If not replaced in a relatively short period of time, it can cause additional problems with the EVAP...
water not coming to the rediator, can it be a blown casket, peugeot diesel
Hello. If water is not flowing or going into the radiator then it may be possible that there is an issue with the cooling system. If water is not flowing then that may be a sign that the water pump...
I have a 1996 chevy k1500 and I just put a new motor in it and it will start and run and idle amazing but has no power in drive
Check to see if ignition timing is advancing per the specifications in the factory service manual as you rev the engine. Measure fuel pump pressure. Check throttle position sensor, oxygen sensors, vacuum leaks, ignition system malfunctions, bad valve timing if...
i upgraded from 28.9 in tire to 32.4 in tires. a week later transmission went out, what should i change to relieve strain on trans
The change in shift points generates added heat in terms of operation. Increasing the tire tire diameter more than a percent or two affects the transmission shift points, as the shift points were programmed based on the vehicle's original tire...
There is a rattling noise coming from the exhaust. Car begins to jerk with this and sometimes it turns off.
You may have a catalytic converter that has broken up inside. The business part of the catalyst is made of ceramic material, (yes just like the clay pots) which is coated with the various precious metals that facilitate the reaction...
My truck turns over and acts like it wants to start but doesn't and now the battery is dead.
It could be that all your trouble is in the battery-charging system. If the system voltage drops below about 10 volts. The electronics will not work correctly but you will still have enough voltage for the starter to turn. The...
On the start/ stop engine button on my 2016 scion IA. It will occasionally have a flashing light.
The normal display modes for the indicator light on the Start/Stop button are discussed on page 140 of the 2016 Scion iA Owner's Manual (https://www.toyota.com/t3Portal/document/om-s/OM99M17z/pdf/OM99M17z.pdf). A flashing indicator on the Start/Stop button is not a normal (expected) display mode. If...
Related articles
How Do I Know If My Brakes Need Replacing?
Certain symptoms tell you when to replace car brakes. The Brake Warning Light and squeaky brakes are common signs of worn out brake pads or rotors.
How to Get BMW Dealership Certified
BMW car dealerships offer automotive technician jobs to mechanics who are certified through the Universal Technical Institute (UTI) program.
P0556 OBD-II Trouble Code: Brake Booster Pressure Sensor Circuit Range/Performance
P0556 code means there is a problem with the brake booster pressure sensor circuit often due too shorted electrical circuitry or defective valves.
Browse other content
Services
Cities
Estimates