Q: 1993 cadillac seville motor mounts 4.9 engine

Your car’s console box (or center console if you prefer) is designed to provide you with additional storage space. It also acts as an armrest for the driver and front passenger. There are actually two storage areas here – this...

The teeth themselves cannot be replaced on a distributor. If the teeth are missing the whole distributor will need to be replaced. (https://www.yourmechanic.com/services/distributor-rotor-and-cap-replacement) It is also a good idea to have your spark plugs and wires replaced at the same...

You likely have a broken wire, shorted wire, or bad pin connection. Start with a visual inspection of the wiring and connectors from the sensor to the ABS control module located by the master cylinder. Chances are you will find...

The movement in the rack shaft is normal as far as I have seen in the video. With everything hooked up, use jack stands (https://www.yourmechanic.com/article/how-to-properly-use-a-floor-jack-and-jack-stands-by-brent-minderler) on both sides of the car to and support it below the lower control arms....

The security chip is designed to keep your vehicle from starting without the owner's key. Unfortunately, you will need to obtain a key (https://www.yourmechanic.com/article/how-to-replace-a-car-key) with a chip and have it programed to the vehicle. A mobile locksmith may be able...

Hi, thanks for writing in. I'm a little confused by your question. If you're asking whether it's possible to install a broken serpentine belt (https://www.yourmechanic.com/article/how-to-replace-a-serpentine-belt-by-mia-bevacqua) on a vehicle and drive 20 miles, I'd say not. If the belt is physically...

Hello there. Many faults will cause your 1999 Ford Expedition to have low output from the stereo. The most common faults would be blown speakers, a failing radio, or a wiring harness fault. A qualified Technician such as one from...

Hi there. Looking at the OBD-II trouble codes you provided us and your symptoms, it appears you have a torque converter solenoid or torque converter issue that is causing the sluggish driving and check engine light. The Powertrain Control Module...

The engine might not start because the neutral start safety switch "thinks" the car is in drive. There is a problem with the selector, the switch and/or the shift/gear selector cable adjustment. To figure out which of the three, the...