Toyota Tundra Transfer Case Output Shaft Seal Replacement at your home or office.

Our mobile mechanics offer services 7 days a week. Upfront and transparent pricing.

Estimate price near me

Service Location

Customer Ratings

(542)

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

Customer Ratings

(542)

Transfer Case Output Shaft Seal Replacement Service

How much does a Transfer Case Output Shaft Seal Replacement cost?

On average, the cost for a Toyota Tundra Transfer Case Output Shaft Seal Replacement is $191 with $58 for parts and $133 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2007 Toyota TundraV8-5.7LService typeTransfer Case Output Shaft Seal - Front ReplacementEstimate$277.31Shop/Dealer Price$320.39 - $418.13
Show example Toyota Tundra Transfer Case Output Shaft Seal Replacement prices

What is the Transfer Case Output Shaft Seal all about?

Vehicles equipped with four wheel drive employ a gearcase to switch among two wheel drive, high gear four wheel drive, neutral mode, and low gear four wheel drive. This gearcase is known as a transfer case. It uses a chain drive and gear reductions inside in order to transfer power from the transmission to the rear differential and the front differential according to the driver’s input. The chain and gears rotate in fluid that lubricates and cools the components inside the transfer case, and seals keep the fluid from leaking out past the input shaft from the transmission and the front and rear output shaft to the differentials. When one or more of these seals leak, fluid not only gets on the undercarriage and ground, but the transfer case is no longer able to effectively cool and lubricate the internal components. If the internal components overheat and seize up, or a catastrophic failure occurs to the transfer case, the four wheel drive system will not operate.

Keep in mind:

  • The transfer case does not have a fluid level indicator or dipstick. Any fluid leaks should be addressed immediately to prevent internal damage from low fluid.
  • Seals such as the transfer case output shaft seal will normally sweat due to the output shaft rotation.

How it's done:

  • The vehicle is lifted and supported on jack stands
  • The driveline is removed and transfer case output yoke is removed
  • The defective transfer case output seal is removed and replaced with a new seal
  • The transfer case yoke and driveshaft is reinstalled and the vehicle is taken off the jack stands
  • The repair is verified and the vehicle is road tested for proper operation

Our recommendation:

The transfer case is not made for any routine maintenance, however, if the transfer case fluid is leaking from either the front or rear seal, one of our expert mechanics needs to remove and replace the seal to prevent damage inside the transfer case.

What common symptoms indicate you may need to replace the Transfer Case Output Shaft Seal?

  • Brownish color fluid spots on the ground under the middle of your vehicle
  • Whining noise when shifting transfer case modes
  • Grinding noise from under the middle of your vehicle while driving
  • Rattling noise when driving at highway speeds
  • Transfer case will not shift between two wheel drive and four wheel drive modes

How important is this service?

If your vehicle is equipped with four wheel drive, the transfer case is integral to its operation. A fluid leak from the transfer case should be addressed in short order to prevent further damage internally, and to prevent your vehicle from being unusable.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Toyota mechanics

Real customer reviews from Toyota owners like you.

Excellent Rating

(542)

Rating Summary
509
16
1
5
11
509
16
1
5
11

William

34 years of experience
569 reviews
William
34 years of experience
Toyota Tundra V8-4.7L - Oxygen Sensor Replacement (Front/Upper/Upstream) - Phoenix, Arizona
Very professional. Will use again

Casey

24 years of experience
152 reviews
Casey
24 years of experience
Toyota Tundra V8-4.6L - Pre-purchase Car Inspection - Bothell, Washington
After a little hiccup with an incorrect address, the buyer's inspection went flawlessly.

Joseph

27 years of experience
578 reviews
Joseph
27 years of experience
Toyota Tundra V8-4.7L - Oil Cooler Adapter Gasket - Houston, Texas
Great service

Robert

22 years of experience
303 reviews
Robert
22 years of experience
Toyota Tundra V8-4.6L - Smoke from engine or exhaust - North Richland Hills, Texas
Tries to do his best.

Excellent Rating

(542)

Rating Summary
509
16
1
5
11
509
16
1
5
11
Number of Toyota Tundra services completed
5962+
services done by our mechanics
TOTAL NUMBER OF EXPERT Toyota MECHANICS
1600+
experts on our platform

Recent articles & questions

How Do Hoses Near the Engine Avoid Melting from the Heat?
Hoses Hoses play a vital role in your engine, allowing fluids like coolant, power steering fluid, and brake fluid to flow where they’re needed and then return. Most of the engine hoses are made from specially formulated rubber, designed to...
What Is Brake Fluid and What Does it Do?
Brake Brake fluid, also known as hydraulic fluid, is responsible for moving the various components of your vehicle’s braking system. The fluid operates under high temperatures and high pressure and, without it, your car or truck would not be able...
P0487 OBD-II Trouble Code: Exhaust Gas Recirculation Throttle Control Circuit A
P0487 code means that the car’s computer did not register the correct amount of air pressure in the manifold due to malfunction.

Radio only works through steering wheel controls

It sounds like the radio unit in your vehicle may have partially failed to where the controls no longer work. I would recommend having your radio inspected by a qualified professional. This inspection may involve the removal of the radio...

My vehicle won't start

Hello. I would recommend first disconnecting and cleaning the battery clamps and battery with baking soda and water. Once the terminals are clean then see if it will crank over. You may need to jump start the battery if it...

The truck wasn't starting up or making any noise. I replaced the starter and it still doesn't want to start up. It just makes a clicking noise

Hey there. You have a bad battery (https://www.yourmechanic.com/services/battery-replacement) or there is a bad connection in the starting system. The battery should be load tested and the state of charge should be checked with a hydrometer. Your starter requires about ten...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com