Toyota Previa Car starts and then dies Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(19)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(19)

Car starts and then dies Inspection Service

How much does a Car starts and then dies Inspection cost?

On average, the cost for a Toyota Previa Car starts and then dies Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
1995 Toyota PreviaL4-2.4L TurboService typeCar starts and then dies InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
1992 Toyota PreviaL4-2.4LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1997 Toyota PreviaL4-2.4L TurboService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1994 Toyota PreviaL4-2.4L TurboService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$104.99 - $112.48
1995 Toyota PreviaL4-2.4LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.02 - $112.55
1991 Toyota PreviaL4-2.4LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1993 Toyota PreviaL4-2.4LService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$109.87 - $117.28
1994 Toyota PreviaL4-2.4LService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$110.24 - $117.94
Show example Toyota Previa Car starts and then dies Inspection prices

Starting a vehicle only to have it quit immediately after can be confusing and annoying for many drivers especially if their vehicle has not experienced this type of issue before. Typically, a vehicle will start and then quit because of an issue with the fuel or electrical system. It is important to monitor fuel levels as well as warning lights which can signal to the driver that a vehicle may quit unexpectedly.

How this system works:

To start a vehicle, the electrical system, composed of the battery and starter, turns the engine over. Once running, the engine requires a constant flow of gasoline and good spark to keep that fuel igniting. If gasoline is not readily available, or if there is not enough spark, the engine will quit. More modern vehicles with sophisticated computers may affect the way the vehicle runs. These computers help the car run efficiently but can also shut a car down if the fuel/air mixture is not correct. While an older vehicle may be less sophisticated and easier to diagnose, the computers on modern cars can provide more specific information when connected to a code scanner/reader.

Common reasons for this to happen:

  • Mass Airflow Sensor: The mass airflow sensor measures how much air is entering the engine and relays this information to the vehicle’s computer so that the right amount of fuel can be delivered from the fuel injectors. When a sensor begins to fail, the vehicle’s computer may generate an error code to indicate that something has gone wrong. An issue with the mass airflow sensor may manifest itself when a car starts and then stalls soon after starting.

  • Fuel Pump Relay: The fuel pump relay functions much like a fuse for an electric fuel pump. The fuel pump relay engages as the vehicle is started and starts the fuel pump. While the vehicle is running, the fuel pump relay turns off and the fuel pump is powered by the oil pressure sending unit. If the vehicle’s computer is unable to keep the fuel pump relay running throughout the starting process, the vehicle may start and quit immediately after starting.

  • Ignition Coil: Your vehicle’s ignition coil takes the low voltage of the battery and provides the thousands of volts needed to create a spark in the spark plugs. When an ignition coil begins to fail, it may struggle to provide consistent spark to the plugs, causing the engine to stall after starting.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the reason why the vehicle starts and then dies. The mechanic will then provide a detailed inspection report outlining why the vehicle quit and the cost of any repairs that need to be made.

How it's done:

A mechanic will begin diagnosing your vehicle’s issue by plugging a code reader/scanner into the vehicle’s computer. The mechanic should be able to get more information from your vehicle’s computer on what component has failed. Using this information, the mechanic can begin necessary repairs.

If your vehicle has a bad or failing mass airflow sensor, the mechanic will begin by finding the sensor in the engine bay and checking for any signs of failure. The mechanic should check the wire harness connected to the sensor to ensure that all of wires are properly connected. After removing the sensor, the mechanic should be able to discover the nature of the failure and replace the sensor.

If the mechanic suspects an issue with the fuel pump relay, he or she should check the vehicle’s computer for a problem. If the vehicle’s computer is having difficulty providing consistent power to the fuel pump relay, the computer may need to be reprogrammed or replaced. If the vehicle’s computer is functioning normally, the mechanic may need to replace the fuel pump relay.

If the mechanic suspects that the ignition coil may be faulty, he or she should first disconnect the battery before beginning work. The mechanic should then begin the process of disconnecting wires from the ignition coil and removing it from the engine bay. The mechanic will then install the new ignition coil and ensure that it is connected properly. The mechanic should then reconnect the battery and test the new coil.

With all repairs, the mechanic will ensure the newly installed parts work properly. The mechanic can then turn off and warning lights that may have come on while the vehicle was not running properly.

How important is this service?

If your vehicle is starting but dying soon after starting, you should have it checked out by a mechanic. Issues involving the fuel management and electrical systems will become worse if not dealt with. Diligence and paying attention to warning lights may help prevent further damage to critical engine component and may save money in repairs. A vehicle that quits after starting can be inconvenient and having a mobile mechanic inspect and repair you vehicle will ensure that you and your vehicle are back on the road soon.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Toyota mechanics

Real customer reviews from Toyota owners like you.

Excellent Rating

(19)

Rating Summary
18
1
0
0
0
18
1
0
0
0

Kenneth

20 years of experience
775 reviews
Kenneth
20 years of experience
Toyota Previa L4-2.4L - Lights (Headlamps/beams/brakes) - Los Angeles, California
Very knowledgeable, friendly. Knew EXACTLY what the issue was and helped me resolve it.

David

21 years of experience
107 reviews
David
21 years of experience
Toyota Previa L4-2.4L - Oil Change - Arvada, Colorado
David handled himself well under less than perfect circumstances. Way to go!

Joseph

20 years of experience
640 reviews
Joseph
20 years of experience
Toyota Previa L4-2.4L Turbo - Brake Rotor/Disc Replacement (Rear) - Salt Lake City, Utah
Great service. Joseph was professional and thorough. I will not hesitate to schedule future work with him.

Victor

35 years of experience
226 reviews
Victor
35 years of experience
Toyota Previa L4-2.4L - Brake System Flush - Albuquerque, New Mexico
He was both knowledgeable and friendly. Would recommend him for the job

Excellent Rating

(19)

Rating Summary
18
1
0
0
0
18
1
0
0
0
Number of Toyota Previa services completed
209+
services done by our mechanics
TOTAL NUMBER OF EXPERT Toyota MECHANICS
1600+
experts on our platform

Recent articles & questions

Top 10 Scenic Drives in Oklahoma
The Midwestern state of Oklahoma is known for its prairielands, mesas, minor mountain ranges, and blend of cultures. The Native American influence there is great with 24 tribal languages still in use, and there are also thriving German, Scottish, and...
How Can the Light Bulb Wiring Become Damaged?
Your Your car is as much electrical as it is mechanical. Wiring harnesses snake their way around the engine bay, and throughout the cabin of the vehicle. Most of your accessories run on electricity, and even the engine needs a...
Insurance Requirements for Car Registration in Montana
Montana Montana law states that all drivers are required to maintain auto insurance, or “financial responsibility,” in order to legally operate a vehicle. The minimum financial responsibility requirements for Montana drivers are as follows: A minimum of $25,000 per person,...

Engine turns, doesn't start

The most common failure is the fuel pump module not giving enough fuel pressure to the engine. The fuel system should be checked to diagnose the no-start condition (https://www.yourmechanic.com/services/car-is-not-starting-inspection) for you. I recommend having a certified mechanic, such as one...

O2 sensor

Hey there. Oxygen sensors are located in the exhaust system, typically before and after the catalytic converter. Bank 1 is found on the driver's side - if the engine is a V6 or V8. On a 4 cylinder, it would...

Car won't start after fuel pump installation 2004 Subaru WRX/STi Hybrid

If the hard starting issue began immediately after the pump install, a possibility is the fuel delivery (pressure and volume) characteristics of the new pump are far enough off stock (or your just prior pump), that the engine either floods,...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com