Suzuki SX4 Car Battery Replacement Costs

Estimate price near me

Service Location

Customer Ratings

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

See availability

Customer Ratings

Car Battery Replacement Service

How much does a Car Battery Replacement cost?

On average, the cost for a Suzuki SX4 Car Battery Replacement is $296 with $156 for parts and $140 for labor. Prices may vary depending on your location.

Car	Service	Estimate	Shop/Dealer Price
2012 Suzuki SX4L4-2.0L	Service typeCar Battery Replacement	Estimate$466.56	Shop/Dealer Price$548.05 - $784.42
2013 Suzuki SX4L4-2.0L	Service typeCar Battery Replacement	Estimate$457.55	Shop/Dealer Price$537.27 - $772.32
2009 Suzuki SX4L4-2.0L	Service typeCar Battery Replacement	Estimate$457.55	Shop/Dealer Price$537.30 - $772.36
2011 Suzuki SX4L4-2.0L	Service typeCar Battery Replacement	Estimate$457.55	Shop/Dealer Price$537.30 - $772.36
2007 Suzuki SX4L4-2.0L	Service typeCar Battery Replacement	Estimate$457.55	Shop/Dealer Price$538.77 - $774.94
2010 Suzuki SX4L4-2.0L	Service typeCar Battery Replacement	Estimate$457.55	Shop/Dealer Price$537.44 - $772.61
2008 Suzuki SX4L4-2.0L	Service typeCar Battery Replacement	Estimate$457.55	Shop/Dealer Price$537.31 - $772.39

Show example Suzuki SX4 Car Battery Replacement prices

What are car batteries and how do they work?

A car battery is an energy storage device that relies on a chemical reaction within the battery to produce electricity. The stored electrical energy is used to initially operate the starter motor, ignition system, and fuel system on your vehicle. Once your car engine is running, the alternator supplies the electricity needed for all vehicle systems and charges the battery to replace the electric energy used when starting a car.

Most electric vehicles have a traction battery which is in addition to the standard 12 volt battery that is used to start the car engine. Traction batteries also convert chemical energy to supply electrical energy but operate at higher voltages and often are monitored by the PCM (Powertrain Control Module).

Battery

When to replace a car battery?

Your car doesn’t start. A new battery has a specified capacity to provide power. This capacity is referred to as the cranking amps rating of the battery. As a battery ages, the actual amps that a battery can supply becomes lower than its original rating Once the cranking amps fall below a critical threshold, it will be difficult or impossible to start your car.
Battery or charging system warning light is illuminated. Should a battery or charging system warning light illuminate, a mechanic should perform a few basic tests to determine if a battery replacement is needed.
Electrical components don’t work. Once a battery has started to fail, and the voltage produced by the battery drops, then vehicle electrical components can malfunction, such as the security system. If you are experiencing electrical malfunctions, it’s a smart idea to have the battery tested.

How do mechanics replace the battery?

A temporary power source might be installed to avoid the possibility of losing radio presets or stored data in the PCM while the battery is out. When the battery is already completely dead, this step is unnecessary.
The vehicle’s negative cable is removed from the battery, followed by the positive cable. The battery tie down system is loosened and the old battery removed.
Cable ends and wiring are carefully inspected to ensure cleanliness and no corrosion. In some cases, corrosion can be extreme and the cable may need to be replaced or wiring repaired.
The new battery is installed and the tie down system is reinstalled. Anti-corrosion compound is applied to the battery terminals. The positive terminal is reconnected followed by the negative terminal.
Some vehicles, for example some models of BMW, VW, and Audi, may require PCM programming to input battery parameters. This step, performed using a specialized scan tool, is necessary to maximize battery life and prevent electrical system malfunctions.
The car is started and charging system output is measured and compared against the factory OEM specification to ensure that the new battery will properly recharge. Generally, charging output will be in the range of 13.8 to 14.8 volts but the exact specifications vary by make and model.

Is it safe to drive with a battery problem?

Yes, but if you have a weak battery you might be left stranded somewhere if the battery dies completely and you cannot start your car. A faulty battery may also needlessly overload the alternator and could adversely affect the operation of the vehicle’s electrical system, including the vehicle security system and the shift interlock.

When replacing the battery keep in mind:

The quality of the electrical connections to the battery posts is important. Connections must be clean, free of corrosion and properly tightened.
Batteries store a large amount of energy and if short-circuited a battery could explode and can create intense discharges that can damage your eyesight. Insulated tools should be used to attach cabling to battery terminals. Otherwise, the battery’s positive cable can be shorted to ground or the positive and negative posts can be directly shorted. Batteries can only be safely installed from a positive terminal to positive wiring and from a negative terminal to body ground. If the polarity is reversed damage will likely occur to the vehicle’s electrical system.
Generally, a car battery will have a service life of 4 to 7 years. If a load test on a battery reveals a significant reduction in the capacity of the battery to provide power, you should buy a new battery rather than wait for the old battery to fail completely.
Batteries should only be disconnected if the engine is off and the alternator is not running. Disconnecting a car battery while the alternator is running can cause a voltage spike that will damage sensitive electronic components in the vehicle, such as the PCM.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee

Meet some of our expert Suzuki mechanics

Real customer reviews from Suzuki owners like you.

Excellent Rating

(55)

Rating Summary

54

1

0

0

0

54

1

0

0

0

SEE REVIEWS NEAR ME

Theodore

10 years of experience

1656 reviews

Request Theodore

Theodore

10 years of experience

Request Theodore

by Millie Hewes

SX4 2012 - Door will not open - Kirkland, WA

Theodore repaired the inner right side rear door. He also checked the fluid levels and tire pressure.

Jimmi

25 years of experience

156 reviews

Jimmi

25 years of experience

by Vernon A Byron

SX4 2008 - Camshaft Position Sensor - Orlando, FL

Excellent work and extremely knowledgeable!!

Arturo

25 years of experience

253 reviews

Arturo

25 years of experience

by Dante Lee

SX4 2008 - Pre-purchase Car Inspection - San Diego, CA

Very nice and knowledgeable. Helped a lot with determining whether or not we should buy a used car. It was like having a personal friend who knew what he was talking about!

Daniel

6 years of experience

208 reviews

Daniel

6 years of experience

by Steve Halloran

SX4 2008 - 75 Point Safety Inspection - Chicago, IL

Couldn't fix all my problems, but very helpful in letting me know what the issues were. Very fair and reasonable with his time, would definitely use him again. Thanks for the help!

Excellent Rating

(55)

Rating Summary

54

1

0

0

0

54

1

0

0

0

SEE REVIEWS NEAR ME

Recent articles & questions

How to Become a Certified Mobile Vehicle Inspector (State Car Inspector Certified) in Minnesota

Automotive technician jobs include mobile vehicle inspectors. Learn how to do car checks in Minnesota through the Minnesota State Patrol.

Symptoms of a Bad or Failing Idler Pulley

Common signs include a damaged bearing or pulley, squealing from the engine area, and visibly worn pulleys.

Insurance Requirements for Car Registration in New Mexico

All All registered vehicles in New Mexico are required to be covered by liability insurance, or “financial responsibility.” The minimum financial responsibility requirements for New Mexico drivers are as follows: A minimum of $25,000 for injury or death, per person;...

How do I turn off the StabiliTrak?

The traction control system (TCS) and StabiliTrak system are crucial parts of your vehicle’s safety. TCS and StabiliTrak limit wheel spin, and keep your vehicle driving securely and safely, especially in adverse weather conditions. However, you can turn off the...

Thumping noise after replacing motor mounts & tranny

Hello. The thumping noise that you hear is probably coming from one of the motor mounts that was replaced. The bolts that hold the mount down could be loose or it is possible that one of the mounts are defective...

The oil pressure light comes on ONLY in park after getting oil changed. The car is full of oil.

This may very well be a faulty oil pressure sending unit. This is a sensor located down near the oil pan on your engine that monitors the oil pressure inside your motor. When this detects lower than normal oil pressure,...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com