Subaru Legacy Reduced Power light is on Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(345)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(345)

Reduced Power light is on Inspection Service

How much does a Reduced Power light is on Inspection cost?

On average, the cost for a Subaru Legacy Reduced Power light is on Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2012 Subaru LegacyH6-3.6LService typeReduced Power light is on InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
2009 Subaru LegacyH4-2.5L TurboService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2010 Subaru LegacyH4-2.5LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2015 Subaru LegacyH6-3.6LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$104.99 - $112.48
1999 Subaru LegacyH4-2.2LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$105.02 - $112.55
2008 Subaru LegacyH4-2.5LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2006 Subaru LegacyH4-2.5L TurboService typeReduced Power light is on InspectionEstimate$99.99Shop/Dealer Price$109.87 - $117.28
2014 Subaru LegacyH6-3.6LService typeReduced Power light is on InspectionEstimate$99.99Shop/Dealer Price$110.24 - $117.94
Show example Subaru Legacy Reduced Power light is on Inspection prices

A Reduced Power light usually indicates a fairly serious problem with the throttle system. When this light illuminates the vehicle will often go into a “safe mode”, which will severely limit the speed of the car and in some cases will render the vehicle un-drivable.

Since the Reduced Power light can trigger for a number of different reasons, tracking down the exact cause is extremely important, if the vehicle is not properly diagnosed and repaired, the Reduced Power light will trigger again, putting the vehicle in safe mode.

How this system works:

When the vehicle’s computer detects a fault in the engine that affects its drivability, performance, transmission or emission system it will trigger the reduced power light. It will also trigger if there is an issue with the electronic throttle, the accelerator pedal or the throttle module.

When a vehicle goes into reduced power mode it will seriously impact its performance. Some vehicle will be restricted to idle speed while others restrict speed to 20-30 miles per hour. The Reduced Power trigger will save Diagnostic Trouble Codes (DTCs), which will indicate where the fault occurred. In most cases, a Restricted Power light is related to a throttle body or the connector.

Common reasons for this to happen:

  • Faulty Throttle Body: A throttle body is part of the of the air intake system which helps control the amount of air going into the engine. If a throttle body is failing the engine will not get the correct mixture of air and fuel. This can trigger the Reduced Power light as well as lead to a poor running engine. It can also trigger the Check Engine light.

  • Failing Throttle Position Sensor: The throttle position sensor tells the vehicle computer the position of the gas pedal. The computer uses this information to calculate the proper amount of air and fuel to send to the engine. The throttle position sensor also controls shifting the gears of a vehicle, which means that a faulty throttle position sensor will prevent a car from changing gears. If this part is failing, the Reduced Power light will trigger.

  • Faulty Engine Control Unit: The engine control unit is an essential component of a vehicles computer. It regulates and controls many systems, including the drive train and parts of the engine. If a fault is detected in this crucial part, it can trigger the Reduced Power light as well as the Check Engine light. This is a major issue that should be investigated as soon as possible.

  • Faulty Wiring: Exposed or damaged wires can cause issues with the any of these components and will possibly trigger the Reduced Power light. A loose wiring crimp can also be the culprit. Wiring issues can be tricky to track down so using a professional mechanic is a necessity.

  • Malfunctioning Oxygen Sensors: Oxygen sensors are responsible for measuring how rich or lean exhaust gases are leaving a vehicles combustion chamber. The vehicle’s computer uses this information to constantly adjust the amount of fuel going into the engine. A failing or dirty sensor can put too much or too little fuel into the engine. While a failing oxygen sensor will usually trigger a Check Engine light it is possible that the Reduced Power light could also trigger.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the source and cause of the Reduced Power light issue, ​and will then provide a detailed inspection report that includes the scope and cost of the necessary repairs.

How it's done:

The mechanic will inspect your vehicle's air intake system, electrical wiring and sensors, including the throttle body and oxygen sensors, along with other important components. It may be necessary for the mechanic to test drive the car to verify the complaint and provide an accurate diagnosis.

How important is this service?

The Reduced Power light only illuminates if there is a serious issue with the vehicle that must be addressed immediately. In almost all cases, the throttle or the vehicles computer will be malfunctioning which can make driving the vehicle dangerous. While it varies by manufacturer, most vehicles that go into “safe mode” will stay there until the error codes are read by a code scanner.

If the vehicle Reduced Power light illuminates the vehicle should immediately be inspected, diagnosed and repaired.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Subaru mechanics

Real customer reviews from Subaru owners like you.

Excellent Rating

(345)

Rating Summary
328
11
1
2
3
328
11
1
2
3

Allan

21 years of experience
16 reviews
Allan
21 years of experience
Subaru Legacy H4-2.2L - Car is not starting - Wendell, North Carolina
Allan was very prompt in his arrival and his diagnosis indicated that new battery terminals needed to be replaced in order to properly perform further diagnostics to determine full resolution of problem. I would recommend Alan for further work to my vehicle.

Genaro

13 years of experience
30 reviews
Genaro
13 years of experience
Subaru Legacy H4-2.5L - Battery - Portland, Oregon
Genaro was early, easy to talk to, and efficient.

Ramon

20 years of experience
166 reviews
Ramon
20 years of experience
Subaru Legacy H4-2.5L - Car is not starting - Tucson, Arizona
Wonderful!

Joshua

27 years of experience
709 reviews
Joshua
27 years of experience
Subaru Legacy H4-2.5L - Brakes, Steering and Suspension Inspection - Oakland, California

Excellent Rating

(345)

Rating Summary
328
11
1
2
3
328
11
1
2
3
Number of Subaru Legacy services completed
3795+
services done by our mechanics
TOTAL NUMBER OF EXPERT Subaru MECHANICS
700+
experts on our platform

Recent articles & questions

The Best Used Cars to Buy If You Live in a City
Living Living and driving in the city means you’re faced with parking constraints, narrow streets, and the constant stop and go of traffic. With all of that said when you’re ready to purchase a used vehicle these are all things...
P2084 OBD-II Trouble Code: Exhaust Gas Temperature (EGT) Sensor Circuit Range/Performance Bank 1 Sensor 2
Diagnostic Diagnostic Trouble Code (DTC): P2084 P2084 code definition Exhaust Gas Temperature (EGT) Sensor Circuit Range/Performance Bank 1 Sensor 2 Related Trouble Codes: P2080: EGT Sensor Circuit Range/Perf Bank 1 Sensor 1 P2081: EGT Sensor Circuit Intermittent Bank 1 Sensor...
P0472 OBD-II Trouble Code: Exhaust Pressure Sensor Low
P0472 code means there is a problem with your electrical circuit, often due to issues with the back pressure sensor.

Bad radio in this truck, is there an easy fix?

Greetings! Thank you for writing in with this question. This is a well-known problem for 2009 and 2010 Tacoma models. Toyota released Technical Service Bulletin (TSB) 0238-09 that deals specifically with this problem. While the TSB calls for replacement of...

Dying when idling too long and whining noise while revving

Hey there. In many cases, whistling or whining noises can come from the belt drive system or a vacuum leak under the hood. Is your vehicle maintenance and tune-up schedule up to date? You may want to check the idle...

Check Engine Light on, catalytic converter and O2 sensors need changing - $3000

Hi there: If you're Check Engine Light is coming on and somebody diagnosed this as a problem with your O2 sensors or the catalytic converter emissions system, it's highly possible that the trouble part are the front or back bank...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com