Pontiac G5 Car starts and then dies Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(44)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(44)

Car starts and then dies Inspection Service

How much does a Car starts and then dies Inspection cost?

On average, the cost for a Pontiac G5 Car starts and then dies Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2007 Pontiac G5L4-2.4LService typeCar starts and then dies InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
2007 Pontiac G5L4-2.2LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2008 Pontiac G5L4-2.4LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2008 Pontiac G5L4-2.2LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$104.99 - $112.48
2009 Pontiac G5L4-2.2LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.02 - $112.55
2010 Pontiac G5L4-2.2LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
Show example Pontiac G5 Car starts and then dies Inspection prices

Starting a vehicle only to have it quit immediately after can be confusing and annoying for many drivers especially if their vehicle has not experienced this type of issue before. Typically, a vehicle will start and then quit because of an issue with the fuel or electrical system. It is important to monitor fuel levels as well as warning lights which can signal to the driver that a vehicle may quit unexpectedly.

How this system works:

To start a vehicle, the electrical system, composed of the battery and starter, turns the engine over. Once running, the engine requires a constant flow of gasoline and good spark to keep that fuel igniting. If gasoline is not readily available, or if there is not enough spark, the engine will quit. More modern vehicles with sophisticated computers may affect the way the vehicle runs. These computers help the car run efficiently but can also shut a car down if the fuel/air mixture is not correct. While an older vehicle may be less sophisticated and easier to diagnose, the computers on modern cars can provide more specific information when connected to a code scanner/reader.

Common reasons for this to happen:

  • Mass Airflow Sensor: The mass airflow sensor measures how much air is entering the engine and relays this information to the vehicle’s computer so that the right amount of fuel can be delivered from the fuel injectors. When a sensor begins to fail, the vehicle’s computer may generate an error code to indicate that something has gone wrong. An issue with the mass airflow sensor may manifest itself when a car starts and then stalls soon after starting.

  • Fuel Pump Relay: The fuel pump relay functions much like a fuse for an electric fuel pump. The fuel pump relay engages as the vehicle is started and starts the fuel pump. While the vehicle is running, the fuel pump relay turns off and the fuel pump is powered by the oil pressure sending unit. If the vehicle’s computer is unable to keep the fuel pump relay running throughout the starting process, the vehicle may start and quit immediately after starting.

  • Ignition Coil: Your vehicle’s ignition coil takes the low voltage of the battery and provides the thousands of volts needed to create a spark in the spark plugs. When an ignition coil begins to fail, it may struggle to provide consistent spark to the plugs, causing the engine to stall after starting.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the reason why the vehicle starts and then dies. The mechanic will then provide a detailed inspection report outlining why the vehicle quit and the cost of any repairs that need to be made.

How it's done:

A mechanic will begin diagnosing your vehicle’s issue by plugging a code reader/scanner into the vehicle’s computer. The mechanic should be able to get more information from your vehicle’s computer on what component has failed. Using this information, the mechanic can begin necessary repairs.

If your vehicle has a bad or failing mass airflow sensor, the mechanic will begin by finding the sensor in the engine bay and checking for any signs of failure. The mechanic should check the wire harness connected to the sensor to ensure that all of wires are properly connected. After removing the sensor, the mechanic should be able to discover the nature of the failure and replace the sensor.

If the mechanic suspects an issue with the fuel pump relay, he or she should check the vehicle’s computer for a problem. If the vehicle’s computer is having difficulty providing consistent power to the fuel pump relay, the computer may need to be reprogrammed or replaced. If the vehicle’s computer is functioning normally, the mechanic may need to replace the fuel pump relay.

If the mechanic suspects that the ignition coil may be faulty, he or she should first disconnect the battery before beginning work. The mechanic should then begin the process of disconnecting wires from the ignition coil and removing it from the engine bay. The mechanic will then install the new ignition coil and ensure that it is connected properly. The mechanic should then reconnect the battery and test the new coil.

With all repairs, the mechanic will ensure the newly installed parts work properly. The mechanic can then turn off and warning lights that may have come on while the vehicle was not running properly.

How important is this service?

If your vehicle is starting but dying soon after starting, you should have it checked out by a mechanic. Issues involving the fuel management and electrical systems will become worse if not dealt with. Diligence and paying attention to warning lights may help prevent further damage to critical engine component and may save money in repairs. A vehicle that quits after starting can be inconvenient and having a mobile mechanic inspect and repair you vehicle will ensure that you and your vehicle are back on the road soon.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Pontiac mechanics

Real customer reviews from Pontiac owners like you.

Excellent Rating

(44)

Rating Summary
41
2
0
0
1
41
2
0
0
1

Maurice

32 years of experience
17 reviews
Maurice
32 years of experience
Pontiac G5 L4-2.4L - Wheel Bearings Replacement (Passenger Side Front) - Laurel, Maryland
Maurice was very professional and knowledgeable. Service was preformed in the time given. Maurice answered all the inquires to my satisfaction and recommended services my car might need in the future. I would recommend this mechanic to anyone looking for good service on their vehicles.

Jamahl

20 years of experience
830 reviews
Jamahl
20 years of experience
Pontiac G5 L4-2.2L - Turn Signal Switch - Deltona, Florida
He was there in a reasonably prompt time. He fixed the repair quickly. He was courteous and professional.

Joshua

13 years of experience
41 reviews
Joshua
13 years of experience
Pontiac G5 L4-2.2L - Brake Pads Replacement (Front) - Morrisville, North Carolina
Very professional and friendly. The job was to be done in 1hr and 45 minutes, Josh got it done in 1 hr and my car runs nicely! Will be requesting him again!

Johnathan

7 years of experience
108 reviews
Johnathan
7 years of experience
Pontiac G5 L4-2.2L - Car is not starting - Saint Louis, Missouri
Best guy I’ve ever met and does his job

Excellent Rating

(44)

Rating Summary
41
2
0
0
1
41
2
0
0
1
Number of Pontiac G5 services completed
484+
services done by our mechanics
TOTAL NUMBER OF EXPERT Pontiac MECHANICS
800+
experts on our platform

Recent articles & questions

A Buyer’s Guide to the 2012 Jeep Patriot
Those Those who love getting off road will often turn to a Jeep. The 2012 Patriot could be a good choice for those who want a quality vehicle for the roads, and when they decide to venture off the beaten...
How to Replace a Lost or Stolen Car Title in Tennessee
A A car title is a very important document to possess. This is the document that proves you are the owner of your vehicle. Without the title you won't be able to sell your vehicle or transfer ownership of it....
P0368 OBD-II Trouble Code: Camshaft Position Sensor "B" Circuit High (Bank 1)
What What the P0368 code means Your powertrain control module (PCM) has detected an incorrect voltage reading or waveform from your vehicle’s camshaft position sensor circuit for camshaft sensor “B” in engine bank one. The camshaft position sensor is a...

What’s the proper way to disconnect the battery

In normal operation, your battery should recharge while the engine is running (the alternator should supply all the power needed). However, if the car has set for some time, it’s possible that the battery may be low. To charge it,...

Engine light is on

Hello. Diagnostic Trouble Codes (DTC's) do not necessarily identify faulty parts. For example, the Code you are inquiring about, namely, P0126 could set the Check Engine Light (CEL) simply because the coolant level in your car is too low. If...

The car shudders between the speeds of 25 mph to 45 mph when accelerating. What is the problem?

Hi there. Check the engine and transmission mounts on your vehicle. When accelerating quickly, the engine and transmission move around causing the loose or broken mounts to make the engine and transmission move around violently making the front tires to...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com