Pontiac Aztek Grease on inner edge of tires Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(33)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(33)

Grease on inner edge of tires Inspection Service

How much does a Grease on inner edge of tires Inspection cost?

On average, the cost for a Pontiac Aztek Grease on inner edge of tires Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2003 Pontiac AztekV6-3.4LService typeGrease on inner edge of tires InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
2004 Pontiac AztekV6-3.4LService typeGrease on inner edge of tires InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2002 Pontiac AztekV6-3.4LService typeGrease on inner edge of tires InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2001 Pontiac AztekV6-3.4LService typeGrease on inner edge of tires InspectionEstimate$94.99Shop/Dealer Price$104.99 - $112.48
2005 Pontiac AztekV6-3.4LService typeGrease on inner edge of tires InspectionEstimate$94.99Shop/Dealer Price$105.02 - $112.55
Show example Pontiac Aztek Grease on inner edge of tires Inspection prices

Grease is an important protectant for many parts of your car. While it isn’t used in your engine, it is used in several other areas, including the CV joints on your axles, as well as the grease fittings on your suspension (many newer cars have sealed fittings that aren’t serviceable today). It’s also used in rear-wheel drive applications – a truck’s driveshaft may have one or even two grease fittings. However, if you’re noticing grease on the inner edge of your tires, it means that something has potentially gone wrong.

How this system works:

There are a couple of places that grease on the inner edge of your tires might have come from. The most likely is from the CV joint. CV axles, or constant velocity axles, are used in front-wheel drive cars to connect the wheel hubs to the transmission. They have two joints, one close to either end. The joints are made to be flexible, so that your car can travel over bumps and dips easily without losing traction.

The joints are flexible, and include moving parts. To protect them from damage from dust, debris and other threats, they’re covered by rubber “boots” filled with grease. This ensures that they’re constantly lubricated, and that dust and debris cannot enter and damage the joints.

However, over time, your boots wear. The rubber can become brittle from age, and can crack. Boots can also be torn through impact with debris in the road and more. When this happens, the grease can leak out, and dirt and debris can enter the joint.

Common reasons for this to happen:

  • Blown CV Boot: If you’ve noticed grease on the inner edge of your tires, there’s a chance that one of your CV boots has blown and is leaking grease out. This is a serious situation. Without grease, the joint is not properly lubricated. Even more worrying, dirt and debris can enter the CV joint and cause serious damage, requiring the entire joint to be replaced. If the situation is caught early, it’s possible that only the boot will need to be replaced.

  • Damaged Grease Fitting: Some vehicles have grease fittings on their suspension system that enable moving parts to move more easily with lubrication. If one of these is damaged, it’s possible that some of the grease may leak onto the edge of your wheel from a nearby grease fitting.

  • Recent Lubrication of Grease Fittings: Once upon a time, an “oil and lube” service really lived up to its name, with all of a car’s grease fittings being lubricated during normal maintenance. With most newer cars now having sealed systems, this has become less common. However, if your car has serviceable fittings, it’s possible that grease from a recent service somehow ended up on the inner edge of the tire.

  • Recent CV Boot or Axle Replacement: If you’ve already had a CV boot blow out and the axle has been rebooted, or a new CV axle has been installed, it’s possible that the mechanic did not clean off the inner edge of the tire after the repair.

What to expect:

A top-rated mobile mechanic will come to your home or office to inspect the CV axles, boots, grease fittings and more. The mechanic will then provide a detailed inspection report that includes the scope and cost of the necessary repairs.

How it's done:

The mechanic will inspect your CV axles and boots, as well as any grease fittings on your front suspension in order to determine the source of the grease on the inner edge of your tires. The mechanic may also need to test drive the vehicle to test for symptoms of a failed CV joint, which include clicking during turning, or a vibration while driving.

How important is this service?

If the problem is with your CV boots, having the situation corrected is critical. While it’s possible to reboot a CV axle before the boot blows entirely, or immediately afterward, any use of the vehicle with the boot blown can contaminate the CV joint with dust and dirt. This will eat into the joint itself, causing irreparable damage and requiring the entire axle to be replaced. If you’ve noticed grease on the inner edge of your tires, one of our professional mechanics can diagnose and repair the condition.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Pontiac mechanics

Real customer reviews from Pontiac owners like you.

Excellent Rating

(33)

Rating Summary
28
2
2
1
0
28
2
2
1
0

Jamahl

20 years of experience
830 reviews
Jamahl
20 years of experience
Pontiac Aztek V6-3.4L - Spark Plugs - Altamonte Springs, Florida

Mark

14 years of experience
73 reviews
Mark
14 years of experience
Pontiac Aztek V6-3.4L - Thermostat - Indianapolis, Indiana
Friendly guy and a job well done!

Tim

15 years of experience
57 reviews
Tim
15 years of experience
Pontiac Aztek V6-3.4L - Oil/Fluid Leak - Brush Prairie, Washington
Tim was very helpful in diagnosing my issue. He seems very knowledgable and his recommendations were very useful. Thanks, Tim!

Jonathan

17 years of experience
138 reviews
Jonathan
17 years of experience
Pontiac Aztek V6-3.4L - Window Motor / Regulator Assembly Replacement (Driver Side Front) - Scottsdale, Arizona
Excellent service great job!!! Got the job done in a timely fashion.

Excellent Rating

(33)

Rating Summary
28
2
2
1
0
28
2
2
1
0
Number of Pontiac Aztek services completed
363+
services done by our mechanics
TOTAL NUMBER OF EXPERT Pontiac MECHANICS
800+
experts on our platform

Recent articles & questions

A Buyer’s Guide to the 2013 Scion FR-S
This This sporty little twin of the Subaru BRZ offers the same light, fun to drive platform but in a bit more spartan, budget-minded form. The marriage of affordability and sports car-like driving is a successful one in the 2013...
How to Get Rid of Bad Smells in Your Car
No one likes riding in a smelly car. Locate the source of the smell, then give your car a thorough clean to keep it smelling fresh.
P2200 OBD-II Trouble Code: NOx Sensor Circuit Bank 1
P2200 code means that the PCM has detected irregular readings in a NOx sensor circuit due to failed air flow or pressure sensors, or spark timing

Battery good, but car won't start.

The battery may be bad to the point it cannot operate the starter but had enough power to run the radio or lights. The starter will need about 100 to 200 amps to turn it properly, but a radio or...

Problem with noisy brakes

Depending on what part you purchased, you might be ok. Brakes usually only make noises (https://www.yourmechanic.com/article/why-do-brakes-squeal) if they are installed incorrectly, or if the friction material (brake pads) are not solidly connecting to the rotors. If the rotors have high...

Squealing

It sounds like it could be your brakes; however, it could be a belt. I have seen issues where the belt won't make noise until you let off the gas. I will give you some steps to go through to...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com