Mitsubishi Eclipse Car starts and then dies Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(450)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(450)

Car starts and then dies Inspection Service

How much does a Car starts and then dies Inspection cost?

On average, the cost for a Mitsubishi Eclipse Car starts and then dies Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2000 Mitsubishi EclipseV6-3.0LService typeCar starts and then dies InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
1995 Mitsubishi EclipseL4-2.0L TurboService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1998 Mitsubishi EclipseL4-2.4LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1996 Mitsubishi EclipseL4-2.0LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$104.99 - $112.48
1992 Mitsubishi EclipseL4-1.8LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.02 - $112.55
1999 Mitsubishi EclipseL4-2.0L TurboService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1994 Mitsubishi EclipseL4-2.0L TurboService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$109.87 - $117.28
1990 Mitsubishi EclipseL4-1.8LService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$110.24 - $117.94
Show example Mitsubishi Eclipse Car starts and then dies Inspection prices

Starting a vehicle only to have it quit immediately after can be confusing and annoying for many drivers especially if their vehicle has not experienced this type of issue before. Typically, a vehicle will start and then quit because of an issue with the fuel or electrical system. It is important to monitor fuel levels as well as warning lights which can signal to the driver that a vehicle may quit unexpectedly.

How this system works:

To start a vehicle, the electrical system, composed of the battery and starter, turns the engine over. Once running, the engine requires a constant flow of gasoline and good spark to keep that fuel igniting. If gasoline is not readily available, or if there is not enough spark, the engine will quit. More modern vehicles with sophisticated computers may affect the way the vehicle runs. These computers help the car run efficiently but can also shut a car down if the fuel/air mixture is not correct. While an older vehicle may be less sophisticated and easier to diagnose, the computers on modern cars can provide more specific information when connected to a code scanner/reader.

Common reasons for this to happen:

  • Mass Airflow Sensor: The mass airflow sensor measures how much air is entering the engine and relays this information to the vehicle’s computer so that the right amount of fuel can be delivered from the fuel injectors. When a sensor begins to fail, the vehicle’s computer may generate an error code to indicate that something has gone wrong. An issue with the mass airflow sensor may manifest itself when a car starts and then stalls soon after starting.

  • Fuel Pump Relay: The fuel pump relay functions much like a fuse for an electric fuel pump. The fuel pump relay engages as the vehicle is started and starts the fuel pump. While the vehicle is running, the fuel pump relay turns off and the fuel pump is powered by the oil pressure sending unit. If the vehicle’s computer is unable to keep the fuel pump relay running throughout the starting process, the vehicle may start and quit immediately after starting.

  • Ignition Coil: Your vehicle’s ignition coil takes the low voltage of the battery and provides the thousands of volts needed to create a spark in the spark plugs. When an ignition coil begins to fail, it may struggle to provide consistent spark to the plugs, causing the engine to stall after starting.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the reason why the vehicle starts and then dies. The mechanic will then provide a detailed inspection report outlining why the vehicle quit and the cost of any repairs that need to be made.

How it's done:

A mechanic will begin diagnosing your vehicle’s issue by plugging a code reader/scanner into the vehicle’s computer. The mechanic should be able to get more information from your vehicle’s computer on what component has failed. Using this information, the mechanic can begin necessary repairs.

If your vehicle has a bad or failing mass airflow sensor, the mechanic will begin by finding the sensor in the engine bay and checking for any signs of failure. The mechanic should check the wire harness connected to the sensor to ensure that all of wires are properly connected. After removing the sensor, the mechanic should be able to discover the nature of the failure and replace the sensor.

If the mechanic suspects an issue with the fuel pump relay, he or she should check the vehicle’s computer for a problem. If the vehicle’s computer is having difficulty providing consistent power to the fuel pump relay, the computer may need to be reprogrammed or replaced. If the vehicle’s computer is functioning normally, the mechanic may need to replace the fuel pump relay.

If the mechanic suspects that the ignition coil may be faulty, he or she should first disconnect the battery before beginning work. The mechanic should then begin the process of disconnecting wires from the ignition coil and removing it from the engine bay. The mechanic will then install the new ignition coil and ensure that it is connected properly. The mechanic should then reconnect the battery and test the new coil.

With all repairs, the mechanic will ensure the newly installed parts work properly. The mechanic can then turn off and warning lights that may have come on while the vehicle was not running properly.

How important is this service?

If your vehicle is starting but dying soon after starting, you should have it checked out by a mechanic. Issues involving the fuel management and electrical systems will become worse if not dealt with. Diligence and paying attention to warning lights may help prevent further damage to critical engine component and may save money in repairs. A vehicle that quits after starting can be inconvenient and having a mobile mechanic inspect and repair you vehicle will ensure that you and your vehicle are back on the road soon.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Mitsubishi mechanics

Real customer reviews from Mitsubishi owners like you.

Excellent Rating

(450)

Rating Summary
425
13
2
2
8
425
13
2
2
8

Keith

26 years of experience
231 reviews
Keith
26 years of experience
Mitsubishi Eclipse L4-2.4L - Car starts and then dies - Grapevine, Texas
Excellently customer service.

Chuy

14 years of experience
403 reviews
Chuy
14 years of experience
Mitsubishi Eclipse L4-2.4L - Air Filter - Orland Park, Illinois
Very friendly but also professional I would recommend him again

Chris

22 years of experience
2229 reviews
Chris
22 years of experience
Mitsubishi Eclipse V6-3.0L - Wheel Bearings Replacement (Passenger Side Front) - Irvine, California
Chris is great! Listened to my explanation of what was happening and test drove it so that he could experience the same issues I was having and then went to work checking into what could be causing the problem. After listing out what the possibilities could be he then suggested that we tackle them one at a time so that we don't change out parts that don't need to be, keeping my cost as low as possible but also fixing the problem. I'm very happy with the work that Chris did and will use him again when the time comes for more repairs. Thank you Chris!

John

36 years of experience
438 reviews
John
36 years of experience
Mitsubishi Eclipse V6-3.0L - Radiator - San Bruno, California
John was on time did a great job replacing my radiator. He was courteous and professional from start to finish. Will definitely use your mechanic.com again for my next repair.

Excellent Rating

(450)

Rating Summary
425
13
2
2
8
425
13
2
2
8
Number of Mitsubishi Eclipse services completed
4950+
services done by our mechanics
TOTAL NUMBER OF EXPERT Mitsubishi MECHANICS
700+
experts on our platform

Recent articles & questions

Is It Safe to Drive During a Thunderstorm?
KABOOM! KABOOM! Big, black clouds roll in, flashes of fire light up the sky, and all of a sudden you are completely amazed by the power of nature. The problem is, you’re driving, and you’re not all that sure whether...
Symptoms of a Bad or Failing Timing Chain
Common signs of a faulty timing chain include engine misfires, metal shavings found in the oil, and rattling sounds from the engine while idling.
P0980 OBD-II Trouble Code: Shift Solenoid C Control Circuit High
P0980 means there is an issue with a control circuit in the shift solenoid C, possibly due to a faulty solenoid or transmission fluid issues.

How do I use the key to lock or unlock the doors?

While you can use the lock/unlock controls on the door panels to lock your car, or the remote attached to your key, you can also use the mechanical key itself. Just turn the key in the driver door lock to...

There are sometimes small vibrations during idle and at times a clacking noise

Hello. The noise you hear is the timing chain and tensioner. This is the most common noise in these motors. The fix is to replace the timing chains and tensioner for both sides of the engine with new guides also....

Speedometer is jumping and my car is jerking

This could be related to a couple of possibilities. The [instrument voltage regulator]((https://www.yourmechanic.com/services/instrument-voltage-regulator-replacement) regulates the voltage supplied to the various gauges in your vehicle’s dash. When this is not working properly, this may cause the gauges in your dash to...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com