Mercedes-Benz S560 Seat vibrates or shakes Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(5,600)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(5,600)

Seat vibrates or shakes Inspection Service

How much does a Seat vibrates or shakes Inspection cost?

On average, the cost for a Mercedes-Benz S560 Seat vibrates or shakes Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2019 Mercedes-Benz S560V8-4.0L TurboService typeSeat vibrates or shakes InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
2020 Mercedes-Benz S560V8-4.0L TurboService typeSeat vibrates or shakes InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2021 Mercedes-Benz S560V8-4.0L TurboService typeSeat vibrates or shakes InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2018 Mercedes-Benz S560V8-4.0L TurboService typeSeat vibrates or shakes InspectionEstimate$94.99Shop/Dealer Price$104.99 - $112.48
Show example Mercedes-Benz S560 Seat vibrates or shakes Inspection prices

Unless a vehicle is equipped with built-in massagers, the feel of vibrations coming through the driver’s seat can be an alarming experience. Luckily, there is a fairly limited number of components that would cause such an issue.

Common reasons for this to happen:

Seat is not fully secured to vehicle

Over time, bolts and hardware holding the seat to the vehicle can loosen or wear out. Sometimes this can be fixed with a few turns of a wrench, so it should be addressed immediately for comfort and to ensure the safety of the car is maintained.

Worn out suspension parts

The suspension in a vehicle performs the task of keeping everything smooth and level while traveling down the road. If any components malfunction, become loose, or bend, then the result may be vibrations in the vehicle. In the case of a vibrating driver’s seat, suspension components in the rear are a likely culprit. If the vibration gets worse when the road surface is rough, then this is probably the source of the problem.

Warped brake disks or drums

Brake disks or drums provide a surface for the brake pads to grip onto when the brakes are applied in order to stop the car. If the rotor or drum is warped in any way, then the friction provided to the brake pads is intermittent. This intermittent friction can cause vibrations and often sounds like the brake is slipping on the disk. Vibration that occurs only during braking is an indicator that this is the problem.

Unbalanced wheels

In order to rotate smoothly and evenly, wheels must be properly balanced. If something happens to the wheel or tire that disrupts the distribution of weight, violent shakes and vibrations can occur. If the vibration occurs consistently around a certain speed, then this is likely the issue.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the source and cause of the shaky or vibrating seat, and will then provide a detailed inspection report that includes the scope and cost of the necessary repairs.

How it's done:

The mechanic will ask about any recent potholes, bottom-outs, or collisions that the vehicle may have experienced. Following that, they will inspect the wheels, axles, and any driveshafts on the vehicle.

How important is this service?

There is a heightened importance with any problem that causes vibration in the vehicle. Vibration means that somewhere there is a component that is unbalanced. Unbalanced components will typically fail in motion and tend to carry a lot of inertia with them when they do. Small, inexpensive parts have the potential to damage far more expensive parts in these dynamic kinds of failures. Book a mechanic when the problem is first detected.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Mercedes-Benz mechanics

Real customer reviews from Mercedes-Benz owners like you.

Excellent Rating

(5,600)

Rating Summary
5,210
189
54
28
119
5,210
189
54
28
119

John

36 years of experience
444 reviews
John
36 years of experience
Mercedes-Benz E320 L6-3.2L - Starter - San Francisco, California
There is additional work that needs to be done with the car. The reading for a previous auto mechanic's scan stated P0040 - Upstream O2 sensor swapped Bank to Bank.Possible causes Crossed Heated Oxygen Sensor harness connection; Wiring swapped from one Oxygen Sensor to the other; Wiring changed at the computer connection or in the harness.This time it was P0100 - Mass Air Flow Sensor. Possible causes MAF Sensor circuit open or shorted; Intake air leaks (unmetered are after MAF Sensor); Defective MAF Sensor; Electronic Control Module (ECM) Powertrain Module (PCM) concern.

Whitney

39 years of experience
783 reviews
Whitney
39 years of experience
Mercedes-Benz C300 V6-3.0L - Brake Pads Replacement (Rear) - Mountain View, California
Whitney did a great job on my car!

Cody

8 years of experience
99 reviews
Cody
8 years of experience
Mercedes-Benz SL550 V8-5.5L - Headlight Bulb Replacement (Driver Side Low Beam) - Fort Worth, Texas
Cody was great. He was on time and completed the job quickly. I'd would have him work on my car anytime! Thanks.

Patrick

8 years of experience
48 reviews
Patrick
8 years of experience
Mercedes-Benz E350 V6-3.5L - Battery - Covington, Georgia
Changed battery quickly!

Excellent Rating

(5,600)

Rating Summary
5,210
189
54
28
119
5,210
189
54
28
119
Number of Mercedes-Benz services completed
61600+
services done by our mechanics
TOTAL NUMBER OF EXPERT Mercedes-Benz MECHANICS
1100+
experts on our platform

Recent articles & questions

A Buyer's Guide to the 2012 Honda Crosstour
There There could be a number of reasons an SUV isn’t right for you: the price, the size, their mpg, etc. However, there could also be a number of reasons you’d really like to have some extra space. If that’s...
Symptoms of a Bad or Failing Trunk Latch
Common signs include the trunk not shutting or locking and the trunk getting stuck closed.
How to Get Smog Technician Certified in Missouri
Automotive technician jobs include smog certified emissions inspectors. In Missouri, you can easily obtain a license from GVIP to become an inspector.

How do I use the sunshade?

The sunshade covers the moon roof, to keep excess light and glare from entering your vehicle. When you open the moon roof, the sunshade will automatically open as well. However, at any point you can manually open or close the...

My car is not getting fuel

You should have the engine scanned for codes first to see if there is a code to diagnose for no fuel pressure. The fuel pump will not run if the inertia switch is tripped. Look behind the right passenger side...

Ok on my 2012 ford fusion .the [water pump](/topics-water-pump-ford/) belt broke so I got a new one and rented the special tool to put it on but I dont know how what size of socket to us to turn the pully to get the belt over the pully

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com