Mercedes-Benz ML500 Reduced Power light is on Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(61)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(61)

Reduced Power light is on Inspection Service

How much does a Reduced Power light is on Inspection cost?

On average, the cost for a Mercedes-Benz ML500 Reduced Power light is on Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2003 Mercedes-Benz ML500V8-5.0LService typeReduced Power light is on InspectionEstimate$114.99Shop/Dealer Price$132.49 - $145.62
2004 Mercedes-Benz ML500V8-5.0LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$112.52 - $125.67
2005 Mercedes-Benz ML500V8-5.0LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$112.52 - $125.67
2006 Mercedes-Benz ML500V8-5.0LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$112.48 - $125.60
2007 Mercedes-Benz ML500V8-5.0LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$112.55 - $125.72
2002 Mercedes-Benz ML500V8-5.0LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$112.52 - $125.67
Show example Mercedes-Benz ML500 Reduced Power light is on Inspection prices

A Reduced Power light usually indicates a fairly serious problem with the throttle system. When this light illuminates the vehicle will often go into a “safe mode”, which will severely limit the speed of the car and in some cases will render the vehicle un-drivable.

Since the Reduced Power light can trigger for a number of different reasons, tracking down the exact cause is extremely important, if the vehicle is not properly diagnosed and repaired, the Reduced Power light will trigger again, putting the vehicle in safe mode.

How this system works:

When the vehicle’s computer detects a fault in the engine that affects its drivability, performance, transmission or emission system it will trigger the reduced power light. It will also trigger if there is an issue with the electronic throttle, the accelerator pedal or the throttle module.

When a vehicle goes into reduced power mode it will seriously impact its performance. Some vehicle will be restricted to idle speed while others restrict speed to 20-30 miles per hour. The Reduced Power trigger will save Diagnostic Trouble Codes (DTCs), which will indicate where the fault occurred. In most cases, a Restricted Power light is related to a throttle body or the connector.

Common reasons for this to happen:

  • Faulty Throttle Body: A throttle body is part of the of the air intake system which helps control the amount of air going into the engine. If a throttle body is failing the engine will not get the correct mixture of air and fuel. This can trigger the Reduced Power light as well as lead to a poor running engine. It can also trigger the Check Engine light.

  • Failing Throttle Position Sensor: The throttle position sensor tells the vehicle computer the position of the gas pedal. The computer uses this information to calculate the proper amount of air and fuel to send to the engine. The throttle position sensor also controls shifting the gears of a vehicle, which means that a faulty throttle position sensor will prevent a car from changing gears. If this part is failing, the Reduced Power light will trigger.

  • Faulty Engine Control Unit: The engine control unit is an essential component of a vehicles computer. It regulates and controls many systems, including the drive train and parts of the engine. If a fault is detected in this crucial part, it can trigger the Reduced Power light as well as the Check Engine light. This is a major issue that should be investigated as soon as possible.

  • Faulty Wiring: Exposed or damaged wires can cause issues with the any of these components and will possibly trigger the Reduced Power light. A loose wiring crimp can also be the culprit. Wiring issues can be tricky to track down so using a professional mechanic is a necessity.

  • Malfunctioning Oxygen Sensors: Oxygen sensors are responsible for measuring how rich or lean exhaust gases are leaving a vehicles combustion chamber. The vehicle’s computer uses this information to constantly adjust the amount of fuel going into the engine. A failing or dirty sensor can put too much or too little fuel into the engine. While a failing oxygen sensor will usually trigger a Check Engine light it is possible that the Reduced Power light could also trigger.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the source and cause of the Reduced Power light issue, ​and will then provide a detailed inspection report that includes the scope and cost of the necessary repairs.

How it's done:

The mechanic will inspect your vehicle's air intake system, electrical wiring and sensors, including the throttle body and oxygen sensors, along with other important components. It may be necessary for the mechanic to test drive the car to verify the complaint and provide an accurate diagnosis.

How important is this service?

The Reduced Power light only illuminates if there is a serious issue with the vehicle that must be addressed immediately. In almost all cases, the throttle or the vehicles computer will be malfunctioning which can make driving the vehicle dangerous. While it varies by manufacturer, most vehicles that go into “safe mode” will stay there until the error codes are read by a code scanner.

If the vehicle Reduced Power light illuminates the vehicle should immediately be inspected, diagnosed and repaired.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Mercedes-Benz mechanics

Real customer reviews from Mercedes-Benz owners like you.

Excellent Rating

(61)

Rating Summary
50
4
0
0
7
50
4
0
0
7

AL

12 years of experience
238 reviews
AL
12 years of experience
Mercedes-Benz ML500 V8-5.0L - Oil Change - Aurora, Colorado
AWESOME JOB! FAST AND PROFESSIONAL!

Richard

12 years of experience
48 reviews
Richard
12 years of experience
Mercedes-Benz ML500 V8-5.0L - Coolant is leaking - Tucson, Arizona
On time, knowledgeable, efficient

Richard

12 years of experience
48 reviews
Richard
12 years of experience
Mercedes-Benz ML500 V8-5.0L - Fuel Tank Pressure Sensor - Tucson, Arizona
Excellent job Great guy Arrived on time Completed on time

Chris

22 years of experience
2266 reviews
Chris
22 years of experience
Mercedes-Benz ML500 V8-5.0L - Brake Pads Replacement (Rear) - Irvine, California
He is very professional and knowledgeable

Excellent Rating

(61)

Rating Summary
50
4
0
0
7
50
4
0
0
7
Number of Mercedes-Benz ML500 services completed
671+
services done by our mechanics
TOTAL NUMBER OF EXPERT Mercedes-Benz MECHANICS
1100+
experts on our platform

Recent articles & questions

Child Seat Safety Laws in Colorado
In In Colorado, as in other states, seat belt laws are in place to protect the occupants of motor vehicles. When those occupants are too young to protect themselves, then the duty falls to adults. Colorado is a bit different...
Disability Driver Laws and Permits in Missouri
Even Even if you are not a disabled driver, it is important to familiarize yourself with the disabled driver laws in your state. Missouri, as is true of all states, has very specific guidelines for what disabled drivers. How do...
How to Care for the Paint on Your Car
Caring Caring for the paint job on your car is one of the best ways to keep your car looking great all year round. Regular washing and cleaning, followed by drying, polishing (https://www.yourmechanic.com/article/how-to-polish-a-car-by-olivia-marsh), and waxing, adds a protective coating over...

Where are the timing chains located at is a 2x4 1999 Ford Explorer 4.0L v6

There were two different engines supplied in the 1999 Ford Explorer. Both of them were 4.0 liters engines. One has single overhead cams one located in front of engine and the other in rear of engine. The other engine is...

Engine stumbles around 3000 RPM.

Hi there. The engine could be stumbling for the coil pack or distributor may not be functioning correctly. As the coil pack or distributor gets old, the parts tend to become weak and is not able to send an electrical...

Check engine light is on. Codes go back to the purge valve. Which I've replaced 3 times in the last 5 months.

Hi Miguel. Thanks for sending your question to us today. In most cases, if the purge valve has been replaced and you're still getting codes related to this component, then it's going to be a fault caused by the sensor...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com